Search: Posts Made By: jasjms
Showing results 1 to 25 of 59
Search took 0.01 seconds.
Replies: 3
Views: 1,593
Posted By jasjms

feedback for new boiler

Yes the main header and pipes are fully insulated, i want to thank you for your input, i just don't want to get a boiler too big or too small either. Jim
Replies: 3
Views: 1,593
Posted By jasjms

Square Feet of Radiation from Radiators

I am getting a new gas fired steam boiler, the radiation i need comes in at 340 square feet, this was measured by the contractor and also by me so the numbers are correct. My contractor wants to...
Replies: 3
Views: 1,519
Posted By jasjms

oil fired steam boiler

I presently heat with a weil mclain oil fired steam boiler, i want to replace this unit with a gas fired steam boiler. The old boiler is about 12 years old, was installed by a good company who did a...
Replies: 2
Views: 10,546
Posted By jasjms

2002 Toyota Highlander Thermostat Replacement V6 enigine

Where on this vehicle is the thermostat located, in the good old days, it was always the top hose going to the thermostat housing, but this is not the case for this vehicle, so now i have to ask for...
07-17-10, 05:39 PM
Replies: 1
Views: 955
Posted By jasjms

pruning a Rhodedenderum plant

I have a very large plant that is about 12 feet in height and i was wondering if it can be pruned by or not, when it is in bloom it is a beautiful site to see, i don't want to harm the plant so this...
Replies: 4
Views: 3,524
Posted By jasjms

mp3 jack

No this is a stock radio with CD player, no input jacks on the face of it, this is the reason i am asking for information.
Replies: 4
Views: 3,524
Posted By jasjms

MP3 player in a PT Cruiser stock radio

I have a 2005 PT Cruiser, i know there is a way to install a jack to listen to my MP3 player without buying another new radio, does anybody have any knowledge of doing this, and if so can you please...
Replies: 1
Views: 1,216
Posted By jasjms

Union Steam Gas Boiler

I was thinking of converting to Gas, and was wondering if anybody has heard of Union Steam, who manufactures gas boilers. Just wanted some pros and cons on the company if there are any.
Replies: 5
Views: 4,137
Posted By jasjms

1999 honda accord front wheel stud

Wheel stud will not come loose, it will break before it comes off, is there a easier way to replace the wheel stud without disconnecting the knuckle and everything else to get to the front hub....
Replies: 7
Views: 3,365
Posted By jasjms

making a curve in wood

I need to replace a piece of curved wood under my oak steps, how can i bend the curve in the wood underneath, can i use luan plywood and wet it or can i steam it to make the curve that i need. It...
Replies: 4
Views: 8,428
Posted By jasjms

reply to post

Ok the pipes are insulated in the basement, i even took the vent valve off the side of the radiator and ran the boiler, the radiator heats up to the 1st section on the radiator and then no more, can...
Replies: 4
Views: 8,428
Posted By jasjms

reply to post

Yes i have what looks like 2 vent valves in the main piping above the boiler, i do believe they are both working, the system is a Weil McClain oil fired boiler with the hartford loop, unit works...
Replies: 4
Views: 8,428
Posted By jasjms

Honeywell pressuretrol settings

My upper radiators on my steam system do not heat up as well as the lower floor, in fact at night the bedroom is chilly. My settings on the pressuretroll are 1/2 psi and diff of 2lbs. If i was to...
11-20-08, 04:32 PM
Replies: 3
Views: 4,230
Posted By jasjms

Removing old paint from basement floor

I was wondering if anybody has a good solution to remove the old paint from a basement floor, it will scrape off in certain areas, but i want to take it down to the concrete, what steps for preparing...
Replies: 14
Views: 1,225
Posted By jasjms

i found the problem with the foglights

After doing some more checking i found that the ground wire going to the frame was corroded, and not making a good ground, easy fix, but i do want to thank everyone who had given me input on the...
Replies: 14
Views: 1,225
Posted By jasjms

followup to problem

When i put my meter at the 2 terminals on both plugs for the fog lights i get a reading of 12 volts, am i doing something wrong here in checking this problem.
Replies: 14
Views: 1,225
Posted By jasjms

power to both plugs

Yes i have 12 volt power to both plugs, and i checked the bulbs by applying 12 volt power from the battery which they both lit up. When i plug the connectors in, the bulbs just dont light up, and i...
Replies: 14
Views: 1,225
Posted By jasjms

After market fog lights

The fog lights were Mopar after market, the bulbs are good, and the power is there, i dont understand what you mean by screwed in, these bulbs are fitted into a rubber type socket male and female...
Replies: 14
Views: 1,225
Posted By jasjms

2005 pt cruiser fog lights

After doing some voltage checking, i have 12 volts coming into both plugs for the foglights when i put the foglight switch on so i know power is there. I also took each bulb and put direct 12 volt...
Replies: 14
Views: 1,225
Posted By jasjms

2005 pt cruiser fog light bulbs

I have power coming into the plug for the foglights, i checked it and found 12 volts on both sides of the plugs, but the lights still don't light, i have even straight wired them to the battery, the...
Replies: 2
Views: 1,625
Posted By jasjms

Mopar fog lights

Yes these are factory Mopar fog lights i installed, and yes they went through a relay at the fuse box.
Replies: 2
Views: 1,625
Posted By jasjms

2005 PT Cruiser Fog light switch

I put in the fog lights about 6 months ago, and they stopped working, i have checked all the wiring to the fuse box back to the switch, made sure all connections were good, checked the fuses also,...
Replies: 5
Views: 1,241
Posted By jasjms

chimney liner

In the state of New Jersey i believe it is code to have the chimney lined with a new liner because you are going from oil to gas heat, this is also part of the additional costs factored into the...
Replies: 5
Views: 1,241
Posted By jasjms

converting oil boiler to gas

I have the same boiler you have here, have had different opinons on cost and installation, they all say the best way is to go is with a brand new gas boiler, it would be far more efficient. I know of...
Replies: 10
Views: 1,862
Posted By jasjms

air in fuel line from tank

You may need to have a Tiger Loop put into your line which would mounts on the side of the boiler and is connected to your fuel lines, it isn't that expensive, and it is far cheaper then digging up...
Showing results 1 to 25 of 59
 


 
Forum Jump