Search: Posts Made By: rock13979
Showing results 1 to 5 of 5
Search took 0.01 seconds.
11-19-19, 10:34 AM
Replies: 13
Views: 253
Posted By Norm201

I did that. Yes you can go to the ceiling and yes...

I did that. Yes you can go to the ceiling and yes go with the 42". Get as much storage as you can. And defiantly install the uppers before the lowers. Don't worry about any spacing at the ceiling...
07-26-19, 07:16 AM
Replies: 10
Views: 970
Posted By CasualJoe

I would be concerned if that galvanized nipple...

I would be concerned if that galvanized nipple screws into another piece of galvanized piping/fitting or if it screws into cast iron. There is a very high probability that all the galvanized piping...
07-26-19, 06:20 AM
Replies: 10
Views: 970
Posted By aka pedro

I've smacked more than a few wrenches to help...

I've smacked more than a few wrenches to help break something loose, but for pipe fittings I typically go for a piece of pipe or unistrut over the handle to increase the leverage first.
07-25-19, 08:47 PM
Replies: 10
Views: 970
Posted By joecaption

I'm hoping that will work, but it never has for...

I'm hoping that will work, but it never has for me.
I end up using a saws all with a metal cutting short blade to make 3 cuts on the inside to weaken it and crushing it with a pair of channel locks....
07-25-19, 04:31 PM
Replies: 10
Views: 970
Posted By Pilot Dane

A bigger wrench is usually what I go for. The...

A bigger wrench is usually what I go for. The smallest pipe wrench I carry is a 14" and I don't hesitate to grab a bigger one. Sometimes I'll whack on the end of the wrench with a 3 pound mallet. ...
Showing results 1 to 5 of 5


 
Forum Jump