Search: Posts Made By: JB-consultants
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 1
Views: 948
Posted By JB-consultants

Red face fuseblock

Since one went before the other and you pulled a fuse I would inspect the connections on the back of the fuse panel. Don't make the mistake of assuming that because everything is plugged in or feels...
Replies: 2
Views: 928
Posted By JB-consultants

Talking yeah

Lot of work friend. A bit of fabrication is involved. Just the fact that you stepping from new to old is a leap. Unless the motor has 30,000 miles or less it's not worth the hassle. You'll spend as...
Replies: 1
Views: 2,010
Posted By JB-consultants

Talking lope

Unfortunately on older vehicles you replace a part to revitalize an aging system and the older parts of the system can't keep up. Assuming your ignition and timing system are properly maintained...
Replies: 1
Views: 822
Posted By JB-consultants

horn

If the horn emits no sound replace the relay. If you replace the relay and it is on constant the problem is in the steering wheel. Check to see if you have dual horns and are grounding out on the...
Replies: 16
Views: 1,528
Posted By JB-consultants

stools

If your making multiple stools its a good idea to make a simpl jig so your not holding or clamping over and over. When working with stainless and al remember that you generally want a good...
Replies: 8
Views: 9,289
Posted By JB-consultants

rust

The tub will break down within the year friend. outside burner and the motor will suck for a grinder unless you belt drive.
Replies: 3
Views: 5,392
Posted By JB-consultants

If you have a compressor and a paint gun you can...

If you have a compressor and a paint gun you can spray degreaser. If you have a pressure washer you can do it that way. If all you have is elbow grease you can purchase carb cleaner and spray it that...
Replies: 4
Views: 9,042
Posted By JB-consultants

bit

If its a one time metal drilling event any standard metal bit from walmart will do. Depending on the diameter of the hole you wish to acheive you may need to drill a (pilot) hole or smaller hole...
Replies: 2
Views: 1,046
Posted By JB-consultants

cast`

I attempted repairing a bell housing years ago. The popular opinion is no. If you are trying to repair a part that is under stress or pressure forget it. I say forget it because you obviously don't...
Showing results 1 to 9 of 9


 
Forum Jump