Search: Posts Made By: adkdan
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 16
Views: 2,283
Posted By adkdan

Mystery Solved

Long story short...I was showing element to a coworker and it snapped at a place that was no longer metal but charred wire.... thus enough contact for resistance? But, nothing to carry a current.
...
Replies: 16
Views: 2,283
Posted By adkdan

I'm going to order an element.. then if its not...

I'm going to order an element.. then if its not that I'll assume its the control panel...new dryer then.

Thanks.. I'll post the results

Dan
Replies: 16
Views: 2,283
Posted By adkdan

New DATA

I DO have 235v volts but only .1mA at the element with load. Also .1mA at thermal fuse and thermister?

Dan
Replies: 16
Views: 2,283
Posted By adkdan

Don't know how there could be a connection issue....

Don't know how there could be a connection issue. I scrapped fittings with sand paper. Could the fittings be bad inside the little ceramic thing that holds the connectors (I could believe this one)?...
Replies: 16
Views: 2,283
Posted By adkdan

PJ, I have 236V at the element, with the...

PJ,

I have 236V at the element, with the element connected. Time for a new element?

Thanks Dan
Replies: 16
Views: 2,283
Posted By adkdan

Pugsl, I have the tech manual and know where...

Pugsl,

I have the tech manual and know where all components are located. My confusion is the fact that with the dryer on and running with High heat I connect the meter to the leads that go into...
Replies: 16
Views: 2,283
Posted By adkdan

Senseon Dryer

Sorry,

Senseon eas a fancy dryer made a few years back.

Thanks
Replies: 16
Views: 2,283
Posted By adkdan

Whirlpool Senseon dryer- no heat

Hello,
I am not a wiz at these things but I try. I have checked resistance on all applicable parts. Meter shows continuity. I have about 15 ohms on heater element. I have 235 volts at the element,...
Showing results 1 to 8 of 8


 
Forum Jump