Search: Posts Made By: beejoe
Showing results 1 to 10 of 10
Search took 0.01 seconds.
11-04-19, 12:17 PM
Replies: 7
Views: 307
Posted By beejoe

Pulling one wire with the old would be excellent...

Pulling one wire with the old would be excellent but with 5 other wires in a 1/2" conduit, Im not sure pulling a single wire is going to be that simple. There is a 90 degree turn to manuver as well....
11-04-19, 06:40 AM
Replies: 7
Views: 307
Posted By beejoe

pull new wire vs. splice box?

Junction box with 3 circuits, one wire is damaged and its too short to pigtail.

Do you think its easier to pull 6 #12 wires in 50' of 1/2" emt conduit by yourself?

This is a homerun back to the...
10-29-19, 08:09 AM
Replies: 2
Views: 180
Posted By beejoe

damaged wire insulation

I found a small scuffed portion of 12awg wire right where it enters a box at the fitting. I think its just the nylon sheath got damaged when pulling. I didnt see exposed copper so I covered it in...
10-26-19, 01:22 PM
Replies: 1
Views: 141
Posted By beejoe

molex? connector question

Do all of the plastic (molex?) connectors on modern appliances only fit together in one direction?

(so the layman doesnt plug something in the wrong direction!!)
Replies: 12
Views: 197
Posted By beejoe

beejoe

First off I like to say thanks to both of you for responding to me and for your patience, its very kind of you.

I took it apart this morning again because I still couldnt confirm it went to...
Replies: 12
Views: 197
Posted By beejoe

Aint that the truth! Im still wondering...

Aint that the truth!

Im still wondering though, if the defrost circuit wasnt working at all, how long do you think it would be before I saw ice formation inside the freezer, another freeze up or...
Replies: 12
Views: 197
Posted By beejoe

I was thinking of doing the wire trick but was...

I was thinking of doing the wire trick but was concerned it would melt the tube if it comes in contact.

SO basically, if I had a component failure... do you think after 48 hours of clearing the...
Replies: 12
Views: 197
Posted By beejoe

Thanks again manden... fwiw the model is...

Thanks again manden... fwiw the model is whirlpool ET1CHEXSB01 , its a basic top mount ... but apparently not basic enough since it has a $100+ defrost control board vs. a simple and cheap timer!
...
Replies: 12
Views: 197
Posted By beejoe

thx for confirming that for me. When I say it...

thx for confirming that for me. When I say it appeared to work.... I heard the familar sizzle of water hitting it, and water did drain.... it also ohm'ed out correctly.

When a control board (or...
Replies: 12
Views: 197
Posted By beejoe

fridge forced defrost question

my fridge had a frozen defrost drain tube and leaked into bottom section. Im hoping it was a simple clog and not a failed or intermittent component. Both compartments are cooling as usual.

So I...
Showing results 1 to 10 of 10


 
Forum Jump