Search: Posts Made By: cristobawat
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Replies: 8
Views: 1,087
Posted By cristobawat

used a hammer and blade sharpening handle and...

used a hammer and blade sharpening handle and popped out a busted shear which had lodged in the space.

thanks for the tip!

Now if only I can get the engine to run smoother. added some...
Replies: 9
Views: 14,730
Posted By cristobawat

prime it 3-4 times. I think it may have been...

prime it 3-4 times. I think it may have been because I had loosened the bottom nut, thinking that would alter the carb/gas flow (like on old carbs).

Just bought some Textron and will run that...
Replies: 9
Views: 14,730
Posted By cristobawat

carb leaks when primed - then runs rough

I also have a craftsman 9 hp snowblower - bought it in Dec. 2007.

gas leaks out when I prime, and the engine also runs rough when started.

tried spraying with carb cleaner - any other...
Replies: 8
Views: 1,087
Posted By cristobawat

Hole in drive shaft under auger is missing!

I have a Craftsman 9 hp snowblower with Tecumseh engine. Went to replace a shear pin but the hole in the auger(?) does not line up with hole in the drive shaft. No matter how I spin it there is no...
Replies: 8
Views: 2,471
Posted By cristobawat

hole for shear pin missing!!

I have a Craftsman 9 hp snowblower with Tecumseh engine. Went to replace a shear pin but the hole in the auger(?) does not line up with hole in the drive shaft. No matter how I spin it there is no...
Showing results 1 to 6 of 6


 
Forum Jump