Search: Posts Made By: mamin
Showing results 1 to 25 of 176
Search took 0.08 seconds.
09-14-19, 12:10 PM
Replies: 1
Views: 115
Posted By mamin

Maytag Gas Stove No Display/No Spark

Hi,
I have about 10 year old Maytag Gas Stove and I do not see any Display or Spark coming in. Gas works fine with manual light.

I checked power outlet and it has power. No issue So power is...
Replies: 11
Views: 572
Posted By mamin

@Spott, Thank you very much for your answer. ...

@Spott,
Thank you very much for your answer.

Yes, I am planning to add MonoFlo Tee at Attic but I have following question:

1) Where will a install Monoflow Tee ? At Supply or Return ?
2) My...
Replies: 11
Views: 572
Posted By mamin

Anyone please can help ? I appreciate if someone...

Anyone please can help ? I appreciate if someone can help me
Replies: 11
Views: 572
Posted By mamin

@Steamboy: I am planning removing everything...

@Steamboy:
I am planning removing everything from piping to boiler from steam system and put new Hydronic Boier with slant Fin Baseboard everywhere. I will have Seperate Zone on Second Floor. Attic...
Replies: 11
Views: 572
Posted By mamin

@Steamboy: I am planing to remove existing steam...

@Steamboy: I am planing to remove existing steam system and replacing with Baseboard heating. On second floor I have three bedroom, one bathroom and Kitchen. Attic is about 15 X 20 on top of the...
Replies: 11
Views: 572
Posted By mamin

How to Isolate one Baseboard Heater from Same Zone

Hi,
I am in process of designing Baseboard Heating for second floor zone. We are replacing Steam to Baseboard Heating. Second floor will be separate Zone but I want to add one baseboard on Attic and...
Replies: 12
Views: 1,024
Posted By mamin

I found root cause of problem. Shut Off Ball...

I found root cause of problem. Shut Off Ball Valve was leaking very little water which was causing water to fill up boiler in couple days. I cut pipe and checked and indeed very little amount of...
Replies: 12
Views: 1,024
Posted By mamin

@sidny, What you are saying is making lots of...

@sidny,
What you are saying is making lots of sense. Can you please elaborate on " float bowl " you are referring to ?. Are you referring to Diaphram and Rod of Solenoid Valve of Water Feeder ? Or...
Replies: 12
Views: 1,024
Posted By mamin

I am not sure if I would agree. It is not...

I am not sure if I would agree. It is not dangerous if water goes too low or too high. You may make a mess but your boiler will not blow up. There are safety control built in steam boiler, LWCO,...
Replies: 12
Views: 1,024
Posted By mamin

@Steamboy: I have Williamson GSA-125-SP 125000...

@Steamboy:
I have Williamson GSA-125-SP 125000 BTU Steam boiler working great. As far I know, once in a week Boiler do need extra water since it looses water due to steam lost. As I mentioned in my...
Replies: 12
Views: 1,024
Posted By mamin

DIY Water Feeder for Steam Boiler

Hi,
I had Uni-Match Universal Water Feeder WFe24 on my steam boiler for auto water feeding and this is second time it is overfeeding water and flooding the system. For time being we have shut off...
Replies: 4
Views: 270
Posted By mamin

@Pootplmr: Thank you. Honeywell S8610U3009 is...

@Pootplmr: Thank you. Honeywell S8610U3009 is exactly I was looking for. From what i understand, I can use this control in various boiler/Furnace where I can have PV/MPG/MV with single or two rod ...
Replies: 4
Views: 270
Posted By mamin

Universal Spark Igniter for Hydronic Gas Boiler

Hi,
I have quite of few properties with all different brand of Hydronic Gas Boilers. e.g. Utica, Crown, Burnham, Peerless. Also, I have couple of Gas Furnace for Hot Air.

Is there any Universal...
Replies: 0
Views: 247
Posted By mamin

Weil Mclain Ultra 155 - Delay before calling Slave Boiler

Hi,
I have two Weil Mclain Ultra 155 piped to same primary/secondary loop. One is setup as LEAD boiler connected to System Circulator Pump, Temp. Sensor, Ourdoor Temp. Sensor and Zone Valves. When...
11-12-18, 06:01 PM
Replies: 0
Views: 574
Posted By mamin

Garage Door Opener Automatic Doorman 455 Replacing Transmitter

Hi,
I have three 25 years old Automatic Doorman 455 opener for my three car garage. They work fine except I am having hard time pairing with my Cars. I feel it is outdated transmitter which is wired...
Replies: 17
Views: 594
Posted By mamin

Thank you all for your great ideas. I learned so...

Thank you all for your great ideas. I learned so many different things which I would have never known. I think I am going to take simplest approach which is adding thermostat and wiring back to...
Replies: 17
Views: 594
Posted By mamin

In that case my entire house in danger. I have...

In that case my entire house in danger. I have generator to solve this issue. It has happened in past several times in NJ.
Replies: 17
Views: 594
Posted By mamin

I have large basement I do not want to increase...

I have large basement I do not want to increase temp. and waste energy. Since inside temp is always above 50 it does not kick in but outer room baseboard gets freezed. I think adding thermostat to...
Replies: 17
Views: 594
Posted By mamin

That is good Idea. I am going to add thermostat...

That is good Idea. I am going to add thermostat in parallel or move existing to basement room which is on outer wall and gets colder than inside part of basement.

What Pete Suggested is also,...
Replies: 17
Views: 594
Posted By mamin

Freeze prevention in certain zones in HW baseboard heat

Hi,
I have Weil Mclain Ultra 155 which has built in Freeze Control option but as far as I know
it is limited to only boiler means that periodically it will turn on boiler and circulator pump and...
Replies: 5
Views: 313
Posted By mamin

I have Weil Mclain which does not have aquastat,...

I have Weil Mclain which does not have aquastat, so I will be having external 24V tranformer which will supply 24V to Thermostat and Zone Valve.
Replies: 5
Views: 313
Posted By mamin

How about, if I wire Thermostat wire to Boiler at...

How about, if I wire Thermostat wire to Boiler at the same time with the Zone valve, so it sends 24V to Boiler and Zone valve whenever contact closes in thermostat ?

Only risk I run, for any...
Replies: 5
Views: 313
Posted By mamin

Here is the wiring diagram from honeywell

Here is the wiring diagram from honeywell
Replies: 5
Views: 313
Posted By mamin

Honeywell zone valve V8043A1029

I bought and installed Honeywell Zone Valve V8043A1029. I did not realized it came with 2 wires instead of 4 wires.

As I understood 1(White) Wire from Transformer will go to Zone Valve Black...
Replies: 5
Views: 934
Posted By mamin

I think I found root cause of problem. Wire going...

I think I found root cause of problem. Wire going from external transformer to three zone valve was shorted due to wire clip I installed to organize the wire. Apparently nail from Wire Clip went in...
Showing results 1 to 25 of 176
 


 
Forum Jump