Search: Posts Made By: brad325is
Showing results 1 to 8 of 8
Search took 0.01 seconds.
01-29-13, 02:27 PM
Replies: 10
Views: 4,800
Posted By brad325is

induction motor installed. working as it should...

induction motor installed. working as it should even with the old pressure sensor hooked up.

thanks..
01-25-13, 06:08 PM
Replies: 10
Views: 4,800
Posted By brad325is

Seattle, Thanks for the reply. I spent...

Seattle,

Thanks for the reply.

I spent the morning removing the flue to see if it was blocked..had some rust ect. in it but clear. Cleaned it all.

removed the induction blower and found 3...
01-25-13, 10:11 AM
Replies: 10
Views: 4,800
Posted By brad325is

Please see the other posts on this thread...I am...

Please see the other posts on this thread...I am now stumped..........
01-25-13, 10:00 AM
Replies: 10
Views: 4,800
Posted By brad325is

Replace pressure switch..called for heat,...

Replace pressure switch..called for heat, everything went as it was suppose to. Furnace ran for about 5 minutes and shut off No where near the stat setting.

I pulled cover off and I'm getting same...
01-24-13, 06:54 PM
Replies: 10
Views: 4,800
Posted By brad325is

lol...had it working although the main blower...

lol...had it working although the main blower seemed to be running fast...cycled three times before fault code for the pressure switch failure ( remains open )
started coming up.

induction...
01-24-13, 04:12 PM
Replies: 10
Views: 4,800
Posted By brad325is

I was not getting the correct voltage to the...

I was not getting the correct voltage to the motor.

I replaced the board and while I was at it, replaced the igniter and flame sensor. I called RUUD/RHEEM prior to ordering the parts to make sure...
01-21-13, 04:15 PM
Replies: 10
Views: 4,800
Posted By brad325is

correction on above post

this is a ruud model UGLG-15EARJR

SER CE1D307 F0592 4812

What are the chances of the board going bad?
01-21-13, 02:38 PM
Replies: 10
Views: 4,800
Posted By brad325is

Ruud Silhouette just stopped working

Just got home from work and the furnace insn't working

Ruud Silhouette model rcba-60896624
SER# m2494

gas forced air

Induction draft motor starts: really not sure..makes a humming noise...
Showing results 1 to 8 of 8


 
Forum Jump