Search: Posts Made By: dam
Showing results 1 to 25 of 51
Search took 0.03 seconds.
Replies: 4
Views: 3,326
Posted By dam

I would put decorative wood gussets under the...

I would put decorative wood gussets under the overhang
Replies: 5
Views: 1,085
Posted By dam

Cut back to good pipe ,prep area and tig weld new...

Cut back to good pipe ,prep area and tig weld new piece in or oxy/acetylene it with a clean coat hanger if you don't have a welder.
Replies: 2
Views: 1,355
Posted By dam

Gas is getting back thru the check valve into the...

Gas is getting back thru the check valve into the oil resevoir.. It's the only way it can. Guess I'll replace the check valve.
Replies: 2
Views: 1,355
Posted By dam

Gas in oil reservoir

I have a merc with the oil res. on the motor. Is it possible for gas to back feed into the oil reservoir?
Replies: 3
Views: 634
Posted By dam

MDB6701AWB1 this is the model

MDB6701AWB1 this is the model
Replies: 3
Views: 634
Posted By dam

Maytag quiet series 300 dishwasher door part

I'm looking for the name of the plastic piece on the inside bottom of the door. It's not the seal. I don't see it on the may tag sch. Mines cracked. It looks like it mounts under the bottom of the...
Replies: 2
Views: 665
Posted By dam

Garage door won't close when it snows?

It's an old All-O-Matic opener. It seems to only close partially at times and won't move up or down.Seems to happen when there's snow on the roof. Can't see anything hitting the door,plenty of...
Replies: 3
Views: 1,148
Posted By dam

Battery bad?

If my deep cycle battery reads 12 1/2 volts but barely cranks the my outboard is it shot? I put this in this forum fir a quicker response.
Replies: 20
Views: 22,368
Posted By dam

A regular 5" hole saw would do it

A regular 5" hole saw would do it
Replies: 4
Views: 648
Posted By dam

It's strange. I emptied the water out,then I...

It's strange. I emptied the water out,then I checked the air pressure and it said zero. I started re charging it to 28psi and it seamed like the air was going into the lines. So that's why I came to...
Replies: 4
Views: 648
Posted By dam

No air in bladder

I try to put air in it and it's back feeding into my other tank and lines. Am I correct thinking the bladder is leaking?
Replies: 8
Views: 1,404
Posted By dam

Don't get an auto darking lens unless you want to...

Don't get an auto darking lens unless you want to get ark flash. They don't change fast enough especially cheap ones. Try going a shade less. To much back light coming in your garage will make it...
Replies: 3
Views: 836
Posted By dam

Find an experienced tig welder.

Find an experienced tig welder.
Replies: 2
Views: 911
Posted By dam

Cold weather fluorescent lights

Do I need a certain 4 foot light that's designed for cold weather in my garage or can I just use standard fixtures?
Replies: 3
Views: 836
Posted By dam

I agree with pilot. Have someone tig weld it...

I agree with pilot. Have someone tig weld it together. Brazing won't get the penetration you need for strength.
Replies: 2
Views: 906
Posted By dam

Dewalt 18v exp charger

My dewalt charger is blinking and according to the code it says replace pack. There about 3 or 4 years old but used very lightly. Are the packs really bad? They still have the same power. Will the...
Replies: 4
Views: 973
Posted By dam

6hp Briggs + Stratton fuel problem

It doesn't seem to be getting fuel. I pulled the carb off like 4 times and sprayed it out with carb cleaner. Took the needle and float out and ran a pin through all holes. Everything's seems clear....
Replies: 2
Views: 1,347
Posted By dam

Tttttttttttttttttttttttttttttttttttttttttttt

Tttttttttttttttttttttttttttttttttttttttttttt
02-22-13, 04:57 PM
Replies: 5
Views: 1,148
Posted By dam

The foundation is fairly air tight. The outlets...

The foundation is fairly air tight.
The outlets and wiring are old. There's no ground on them or in the wiring. Or I'll rewire if I insulate the floor.
There's 6" between the ceiling and roof....
02-21-13, 08:38 AM
Replies: 5
Views: 1,148
Posted By dam

The floor is totally enclosed by stone foundation...

The floor is totally enclosed by stone foundation . There's just no basement under that part of the house. I would have to cut access in floor to get under it. There is wiring. The outlets are in the...
Replies: 8
Views: 6,356
Posted By dam

Just clean a old coat hanger and use it for...

Just clean a old coat hanger and use it for filler rod.
Replies: 1
Views: 1,001
Posted By dam

You shouldn't get any uv rays behind the helmet...

You shouldn't get any uv rays behind the helmet depending on where your welding. What I mean is sometimes it can reflect off something behind you. Wear safety glasses cause they do help block out...
02-18-13, 04:41 PM
Replies: 5
Views: 1,148
Posted By dam

Insulating floor and ceiling

I have a great room with hardwood floors and a cathedral ceiling. It's always cold,especially the floor. There is no basement under that part of the house but a air space that t think I can get in....
Replies: 2
Views: 1,347
Posted By dam

Evergreen border trees

I'm looking for suggestions on evergreens for a border along a road. I'd like it to grow 3 to 6 ft or around there. Most be durable and deer proof.
Replies: 2
Views: 772
Posted By dam

Wood floor cleaner

Can I use concentrate carpet/ upholstery cleaner on my wood flooring using a Hoover floormate or is there something else out there?
Showing results 1 to 25 of 51
 


 
Forum Jump