Search: Posts Made By: salspat
Showing results 1 to 19 of 19
Search took 0.02 seconds.
04-09-08, 07:06 AM
Replies: 16
Views: 40,493
Posted By salspat

tile haze

i too had the same problem, a floor guy told me to use white vinegar and warm water in a bucket...buy a good sponge, about 3 in thick keep rinsing the spong constantly...then wipe tile with clean dry...
09-02-05, 10:30 PM
Replies: 2
Views: 965
Posted By salspat

i believe unit has an hour timer after so many...

i believe unit has an hour timer after so many hours it will kick off telling you to clean filter.can't find any timer without taking unit apart ......orit maybe programmed in there some how?
09-02-05, 11:21 AM
Replies: 2
Views: 965
Posted By salspat

sharp a/c 8000 btu cuts off

hey there guys ...bought :alarm: a sharp a/c 8000 btu remote control unit, don't use
remote. anyway after the unit runs about 20min, it will cut off and prompt a e1 on control panel....this means...
Replies: 2
Views: 2,212
Posted By salspat

Talking haaaaaaaa i don't mean to laugh but i had the...

haaaaaaaa i don't mean to laugh but i had the same problem also, moen single faucet. sometimes my wife would spray down the the sink, then i'd go over and turn on the water and get a bath, i'm just...
Replies: 1
Views: 755
Posted By salspat

shower body no water?

:wall: hey guys . i have a shower on the second floor the body was leaking sometime ago. i cut out the sheet rock and replaced the shower body. 3 valve body, it worked fine, it hasn't been used up...
08-12-05, 07:05 PM
Replies: 2
Views: 950
Posted By salspat

thanks for your reply, i found a piece of the...

thanks for your reply, i found a piece of the wood the guy used for the sub floor it said bcx, and for the thinset he used portlen cement thin set, the board was cement board, both 1/2". but my...
08-11-05, 07:52 PM
Replies: 2
Views: 950
Posted By salspat

porcelin floor put down something wrong

:alarm: hey guys hope all is well back again with a new problem, guy came put down a kitchen floor for me, here's what we have he put down 1/2 cdx plywood, then 1/2" wallboard. then porcelin tile...
Replies: 3
Views: 888
Posted By salspat

wacky gas guage,

thanks for your response, but if i ground the sender and the guage goes to full. that would mean what? a bad sender

thanks
sal
Replies: 3
Views: 888
Posted By salspat

wacky gas guage

hello, nice to be back w/ u guys i have a 99 chevy s10 pickup 4cyl.
when ever i start the vehicle, the gas guage will go from f to e back to f to half tank mark and continue i'm never sure how much...
Replies: 4
Views: 895
Posted By salspat

thanks kindly jeff i'll give it a try i'll check...

thanks kindly jeff i'll give it a try i'll check the altenator voltage asap

thanks again
sal
01-01-05, 06:51 PM
Replies: 3
Views: 1,197
Posted By salspat

hello, no i used three different kinds of...

hello,

no i used three different kinds of dimmer switches. it only seems to happen like i said when the voltage is cut back to halfway. like only when the switch
has more of a load on it

...
01-01-05, 06:11 PM
Replies: 3
Views: 1,197
Posted By salspat

Hi Hats dimming

I have 3 hi-hats out on my front porch. They are hooked up to a rotary dimmer switch. They work fine when I put it up to full brightness . When I dimm them down to 1/2 brightness and leave the switch...
Replies: 4
Views: 895
Posted By salspat

hello thanks 4 your reply i have tried the...

hello thanks 4 your reply i have tried the potentiometer slide... it slides up and down still no change.. would this also cause a problem w/ the intermitent wipers also? the dash problem is driving...
Replies: 4
Views: 895
Posted By salspat

Question 97" jeep grand jerokee

hello,

could use a little help her if anyone can help me, i have a 97" jeep grand jerokee. fullyloaded, when i turn on the headlights at night, the dash lights are dim. then out of no-where, they...
Replies: 7
Views: 1,608
Posted By salspat

expansion tank problem

ed, thanks for your help and rick too i did change the expansion tank although it was not nad it was called a number 2 i went to a #3 tank for a two zone heating system, its a little larger and it...
Replies: 5
Views: 2,516
Posted By salspat

Wink 3rd gear problem?

3rd gear and reverse are the same clutch pack. is reverse ok? if reverse is ok then its probably not an internal problem int that case it could be a weak spring on the 2-3 shifter valve or the...
Replies: 7
Views: 1,608
Posted By salspat

sal spat

hi ed no aquastat if i reset the head it will run then kick off again. i'm gonna change the expansion tank to a larger one i will try what rick said about lowering the water pressure will get back to...
Replies: 7
Views: 1,608
Posted By salspat

boiler shuts ..down prv leaks

thanks rick i'll try that. but what about my problem with the retention head its a riello. once it shuts down it won't start again i have to reset the head again. is this due to the psi you...
Replies: 7
Views: 1,608
Posted By salspat

Question hot water furnace problem

hello, can someone help me. my prv started leaking. presssure was 28-29psi
expansion tank is less then a year old capable of 100psi max. has solid sound on bottom then tinny sound going up when...
Showing results 1 to 19 of 19


 
Forum Jump