Search: Posts Made By: Canvasdraw
Showing results 1 to 8 of 8
Search took 0.01 seconds.
03-13-19, 06:52 PM
Replies: 8
Views: 452
Posted By Canvasdraw

Diagonally measure each cabinet. If the two...

Diagonally measure each cabinet. If the two dimensions do not exactly match, your cabinets are not square.
03-13-19, 06:45 PM
Replies: 4
Views: 712
Posted By Canvasdraw

A suggestion. Find a small piece of the same...

A suggestion. Find a small piece of the same wood (Birch) and stain it with Minwax "Jacobean." It is a pretty dark brown stain that might work Probably a better test would be, on the same Birch...
Replies: 3
Views: 425
Posted By Canvasdraw

Find the highest point on your floor and strike a...

Find the highest point on your floor and strike a level line from that point. Set the tops of your base cabinets up to the horizontal line using shims, then set the uppers from a constant height...
Replies: 11
Views: 418
Posted By Canvasdraw

After you drill a smaller hole in the center of...

After you drill a smaller hole in the center of the bolt, get an "Easy Out" in a diameter that fits the small hole you drilled. Shoot some penetrating oil around the broken bolt and wait a while. ...
Replies: 8
Views: 631
Posted By Canvasdraw

Thanks, Pete.. Is there a way for someone...

Thanks, Pete..

Is there a way for someone who knows little about electric motors to open the end of the motor
and check is the switch is open? Can it be cleaned in-place?

TIA!

Larry
Replies: 8
Views: 631
Posted By Canvasdraw

I can spin the disc and the sanding wheel will...

I can spin the disc and the sanding wheel will turn very slow with no torque. One time it did trip a breaker when I was spinning it.. Still hums.
Replies: 8
Views: 631
Posted By Canvasdraw

"Stuck open centrifugal start switch." Way above...

"Stuck open centrifugal start switch." Way above my knowledge. Care to unravel my lack of understanding? In simple terms?
TIA!
Canvasdraw
Replies: 8
Views: 631
Posted By Canvasdraw

Repairing Harbor Freight 12" disc sander

I have an older Harbor Freight 12" disc sander. Model Number 43468. The motor just hums now and won't start. Replaced the switch.. No change. Pulled out and disconnected the start cap,...
Showing results 1 to 8 of 8


 
Forum Jump