Search: Posts Made By: tinner666
Showing results 1 to 25 of 158
Search took 0.06 seconds.
Replies: 2
Views: 1,498
Posted By tinner666

Sounds like the sill pan was left out. Wouldn't...

Sounds like the sill pan was left out. Wouldn't doubt the window/door flashing was left out too.
Replies: 1
Views: 3,011
Posted By tinner666

Well, it appears to lap over the lower piece. If...

Well, it appears to lap over the lower piece. If that was a roof, I'd want a 1 1/2" to 2" gap there and and I'd have the metal 'kick-out'.

Being a chimney, water could even be getting under the...
Replies: 1
Views: 987
Posted By tinner666

Plan on getting under the existing roof about 18"...

Plan on getting under the existing roof about 18" to get a proper joint.
Replies: 5
Views: 813
Posted By tinner666

Different programs have different screen formats....

Different programs have different screen formats. You can use the zoom feature the fill the screen, but it will make people look fat and squat.
Not all films or broadcasts will fill the screen...
Replies: 3
Views: 1,287
Posted By tinner666

My bad. I meant SBS. Not SSA.

My bad. I meant SBS. Not SSA.
Replies: 3
Views: 1,287
Posted By tinner666

Flintastic, I think makes a SSA mod-bit roof...

Flintastic, I think makes a SSA mod-bit roof material. Use 2 base sheets, 1 cap sheet. Don't forget to prime the drip edge before installing the mod-bit over it.
Replies: 1
Views: 857
Posted By tinner666

Remove the shingles along that edge, bend 3/4" of...

Remove the shingles along that edge, bend 3/4" of the metal back on itself about 170 degrees to form a channel. Install new shingles that overlap the hem by 3", and cut, at an angle, the unexposed...
Replies: 1
Views: 864
Posted By tinner666

I hope the shingles and flashing extend past the...

I hope the shingles and flashing extend past the rake mold by an inch.

Just cut the foam out of the way and fill the hole with geocel. The finished product should NOT be flush. Caulk deep and...
Replies: 5
Views: 8,215
Posted By tinner666

You're on the right track. The devil is in the...

You're on the right track. The devil is in the details.
Will you be able to lap the new materail under the existing on the ends?

If not, can you melt and scrape off enough granual to get...
Replies: 5
Views: 8,215
Posted By tinner666

You have a can of worms there for sure. Normally,...

You have a can of worms there for sure. Normally, built-in-gutters are sloped by notching the rafters.

That drain was doomed fail with galvie pipe. And set level to boot.

Use 4" PVC, and give...
Replies: 7
Views: 2,259
Posted By tinner666

No Analog/DTV button on remote? There must be...

No Analog/DTV button on remote? There must be something you missed, either on the remote, or in the sttings. I've been under the impression that all TV's had a A-D switch somewhere.
Replies: 4
Views: 896
Posted By tinner666

Assuming you've always had 5" K like most...

Assuming you've always had 5" K like most residences, see how 6"K would fit and use 3x4 downspouts.
With hangers every2', the gutters should be able to handle the extra water. Doubt a 5'K would work...
Replies: 9
Views: 36,718
Posted By tinner666

Windows don't appear to be flashed. It seems to...

Windows don't appear to be flashed. It seems to be coming in around the stucco on top. Is that a roof drain above? Draining water and wind could add to volume there.
you could google stucco man.
Replies: 7
Views: 1,958
Posted By tinner666

I see a few re-roofs make it 3-4 years.

I see a few re-roofs make it 3-4 years.
Replies: 3
Views: 797
Posted By tinner666

You can throw the cable box away if you own it,...

You can throw the cable box away if you own it, return it to the cable company if you rent it.
Unless the cable box has some HDMI hook-up???
Replies: 37
Views: 15,475
Posted By tinner666

I do thank you sir. I appreciate that. I'm also...

I do thank you sir. I appreciate that. I'm also sending you a PM about other pictures. Thanks in advance. Frank :)
Replies: 37
Views: 15,475
Posted By tinner666

Blacktoe. May I save a couple of those pictures?...

Blacktoe. May I save a couple of those pictures? May I assume the shingle tops weren't clipped to cause those water tracks? It's a typical cause and effect.

I like keeping examples of what did...
Replies: 10
Views: 3,171
Posted By tinner666

How are you going to attach the roof after...

How are you going to attach the roof after covering the deck with steel?

If you're building, Bolt the plate and band to the foundation, use Simpson brackets to attach every other stud, and every...
Replies: 1
Views: 1,533
Posted By tinner666

I won't get into loads, etc. Assuming that's safe...

I won't get into loads, etc. Assuming that's safe to do, use a 2x 12" or two 2x6" as the tie-in plate. The 2x6's can be spread apart for best bearing surface. Nail them into existing rafters across...
Replies: 3
Views: 869
Posted By tinner666

I described my connections here. ...

I described my connections here.

http://forum.doityourself.com/entertainment-center-tvs-stereos-vcrs-dvds/374742-analog-vcr-connection-digital-tv.html
Replies: 25
Views: 32,400
Posted By tinner666

BTW. I was having the same problem without having...

BTW. I was having the same problem without having a converter box. DTV wouldn't come throught the VCR.

I had many chances to experiment because I bought my 'system' a piece at a time over 3-4...
Replies: 25
Views: 32,400
Posted By tinner666

"The only way I can get the VCR to work is if I...

"The only way I can get the VCR to work is if I connect the cable from the antenna to "antenna in" on the VCR. I connect another cable from "antenna out" on the VCR to the VHF/UHF antenna port on the...
Replies: 25
Views: 32,400
Posted By tinner666

Yes, they should be connected. The...

Yes, they should be connected.

The Digital/analog switch on the remote is just that. It tells the TV, at least on my Bravia, which signals to accept. In analog, it cannot find ANY D signals.
AND...
Replies: 25
Views: 32,400
Posted By tinner666

Interesting results of some testing. I removed...

Interesting results of some testing. I removed the A-B switch and the antenna line to the TV. Did NOT affect the DVR or DVD set-up. I DID lose all UHF signal.

I left the A-B out and put a splitter...
Replies: 3
Views: 10,540
Posted By tinner666

Exposed nails? Sealing shingles? Sealing...

Exposed nails? Sealing shingles? Sealing flashing? With some form of glue? :wall:

Sounds like you hired somebody pretending to be a roofer. I doubt there'll be any warranty that can be of any use.
Showing results 1 to 25 of 158
 


 
Forum Jump