Search: Posts Made By: MrRonFL
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Replies: 19
Views: 9,549
Posted By MrRonFL

Double check your connections, sometimes those...

Double check your connections, sometimes those slip on connectors aren't as snug as they should be after you do a battery swap. Check the battery with the AC power disconnected. It's rare, but you...
Replies: 19
Views: 9,549
Posted By MrRonFL

Thanks, based on his response to your question, I...

Thanks, based on his response to your question, I couldn't tell if he had the RF keypad or not. GIGO...
Replies: 19
Views: 9,549
Posted By MrRonFL

Assuming that you have a receiver and not a RF...

Assuming that you have a receiver and not a RF model keypad and it is still set to the default module address of 35:

*8 [installer code]
35#
[xx]# (xx being the zone number of the device)
press...
Replies: 19
Views: 9,549
Posted By MrRonFL

Normally, you pop the new battery in. Open and...

Normally, you pop the new battery in. Open and close the door to send an open and restore, and good to go.

The only thing I can suggest is to power down the system, walk away fro a few minutes,...
Replies: 19
Views: 9,549
Posted By MrRonFL

Yes, as soon as the system gets a signal from the...

Yes, as soon as the system gets a signal from the device.

You could easily have gotten a bad battery. These lithiums are a low demand battery, and some vendors don't rotate their stock enough. I...
Replies: 19
Views: 9,549
Posted By MrRonFL

Try *7. It forces a reset on the sensors. I...

Try *7. It forces a reset on the sensors.

I am assuming that you have properly replaced the battery cover. There's a tamper switch on it.
Showing results 1 to 6 of 6


 
Forum Jump