Search: Posts Made By: H3re2Learn
Showing results 1 to 25 of 157
Search took 0.02 seconds.
Replies: 12
Views: 227
Posted By H3re2Learn

Its up and running, Thanks for all the help and...

Its up and running, Thanks for all the help and insight

I asked about single phase because where I wanted to install the fan is 30 meters from the panel and running 12/3 that far is more expensive.
Replies: 12
Views: 227
Posted By H3re2Learn

Toyln Ironhand stated "240 single phase" that is...

Toyln Ironhand stated "240 single phase" that is why I questioned it. Thank you all for your replies.
Replies: 12
Views: 227
Posted By H3re2Learn

So I can run this motor off of 240 single phase...

So I can run this motor off of 240 single phase as well?
Replies: 12
Views: 227
Posted By H3re2Learn

Dayton 3 phase motor help

Skill set = I am not a licensed electrician but I am more advanced than your average home improvement guy/gal. I have wired a standard 3 phase outlet from a 3 pole panel so im not completely lost...
Replies: 15
Views: 647
Posted By H3re2Learn

I'm positive on both the 3 layer tare off and not...

I'm positive on both the 3 layer tare off and not replacing that flashing. I can see where it had been damaged from being pried up then being hammered back down. That is probably why there is such a...
Replies: 15
Views: 647
Posted By H3re2Learn

They did not replace that flashing. From what I...

They did not replace that flashing. From what I can tell they pried the edge up, shoved the last row of shingles under the edge then nailed it back down. there are small dabs of "goop" over the nail...
Replies: 15
Views: 647
Posted By H3re2Learn

The stains on the flashing are from leaves that...

The stains on the flashing are from leaves that were sitting there about a month ago but have since been removed. Here are 2 pictures closer to the sidewall flashing where we now think the water is...
Replies: 15
Views: 647
Posted By H3re2Learn

The word I was looking for I guess is "sidewall"...

The word I was looking for I guess is "sidewall" where the roof meets the rest of the house. I found out today that we think the leak is in fact coming from the sidewall flashing. In the general area...
Replies: 15
Views: 647
Posted By H3re2Learn

The water gets behind the siding and runs down...

The water gets behind the siding and runs down the wall then soaks into the sill plate and into the basement. Gutter drains just fine and it only happens in this 2ft area. no other visible stains and...
Replies: 15
Views: 647
Posted By H3re2Learn

Id say it's slightly < 2/12, it was an addition...

Id say it's slightly < 2/12, it was an addition to the home 30 years after it was built back in 1960. We didn't have any issues until after the new roof. I'll get some pictures when i get home later....
Replies: 15
Views: 647
Posted By H3re2Learn

Wicking shingles on low pitch roof

New roof a year ago and it was a 3 layer tare off on this section of the home. I guess you could call it a 4 inch and we noticed stain streaks in a small two foot section of our foundation wall a few...
Replies: 7
Views: 1,174
Posted By H3re2Learn

Yes I did, many are called torque converters of...

Yes I did, many are called torque converters of such and they are actually pretty large, too large for this set up. I wish they made a miniature one for my set up.
Replies: 7
Views: 1,174
Posted By H3re2Learn

"Figure A" is already in play and is working just...

"Figure A" is already in play and is working just not as well as id like. The current set up it goes about 40 mph on flat pavement then hesitates once it hits a slight hill. Id rather it go 20 mph...
Replies: 7
Views: 1,174
Posted By H3re2Learn

Possible question for an engineer? sprocket ratio?

First off I wasnt really sure where to post this, if a mod can think of a better place to move this to please do.

Working on an electric bicycle project for a good friend/adopted grandfather of...
06-18-19, 05:59 PM
Replies: 3
Views: 439
Posted By H3re2Learn

12 volt 8AH X 4 = 48 volt 32 AH?

Like the title says. Wired in series I have 4 batteries that are 8 amp hour will they total 32 AH 48 VOLT or just 48 volt 8 AH?. IM building an electric go kart and didn't want to buy a $400 48 volt...
Replies: 8
Views: 891
Posted By H3re2Learn

Finally got the message again so I ran that diag...

Finally got the message again so I ran that diag scan and got the error - (microsoft can't connect to the sync service). So im going to look into that. Im sure it has something to do with that. The...
Replies: 8
Views: 891
Posted By H3re2Learn

i have avast anti virus that scans daily and the...

i have avast anti virus that scans daily and the whatever came with windows 10 that scans randomly and it never finds anything. I only have a local account and I run all the window 10 updates it...
Replies: 8
Views: 891
Posted By H3re2Learn

Windows 10 account problem?

Ive gotten this notification about 5 times now in the past 4 months, sorry the picture is a little blurry but you should still be able to see it. It shows up in my notifications when I log into...
03-02-19, 08:27 AM
Replies: 2
Views: 397
Posted By H3re2Learn

Can anyone identify this mumified corpse?

I was under my back crawl space installing a vent and found this dried up animal, dont know what it is or how long its been there, kind of curious what it is though. Does anyone know? I live in NE...
02-11-19, 07:17 PM
Replies: 13
Views: 606
Posted By H3re2Learn

"if you put enough weight" over a solid joist it...

"if you put enough weight" over a solid joist it will also snap. What im saying is a 2x4 with a perpendicular hole through it is 50% more likely to give under a load then a 4x4. or in my case a 4x8...
02-11-19, 05:59 PM
Replies: 13
Views: 606
Posted By H3re2Learn

it is harder to snap a 4x4 in half or a 2x4?

it is harder to snap a 4x4 in half or a 2x4?
02-11-19, 08:06 AM
Replies: 13
Views: 606
Posted By H3re2Learn

so if I were to sister the joist with another...

so if I were to sister the joist with another joist over the expansion then it will be okay to cut the 3 1/2 hole through the both of them?
02-10-19, 11:26 AM
Replies: 13
Views: 606
Posted By H3re2Learn

floor joist hole allowance

I installed a bathroom in my basement and need to run a 3 1/2 inch vent through one floor joist, the joist is 2x8 (1 1/2 X 7 3/8) with an 8 ft span across a cinder block wall. From what I have read...
10-28-18, 01:19 PM
Replies: 3
Views: 421
Posted By H3re2Learn

As you can see in the picture, its only about a 1...

As you can see in the picture, its only about a 1 inch gap. Id like to finish it off more cleanly so that brings me back to my original question, does that gap need to breathe?
10-27-18, 06:17 PM
Replies: 3
Views: 421
Posted By H3re2Learn

Ill take a photo when I get home later but for...

Ill take a photo when I get home later but for now imagine a standing shower built 1 inch away from cinder block, I'm wondering if I can block off that gap so it looks finished or does that gap need...
Showing results 1 to 25 of 157
 


 
Forum Jump