Search: Posts Made By: Dsherm112
Showing results 1 to 25 of 155
Search took 0.02 seconds.
Replies: 1
Views: 346
Posted By Dsherm112

Door Handle On Microwave

I have a Model JVM 240BL02 GE Spacemaker Microwave. The door handle broke off and is unavailable from GE and other places I've checked. Is the oven safe to use with the two screw holes in the door....
12-03-17, 12:20 PM
Replies: 8
Views: 552
Posted By Dsherm112

I'll be going thru the floor to a 1/2" copper...

I'll be going thru the floor to a 1/2" copper line in the basement. I assume from your comments the valve has a 1/4" connector.
11-29-17, 04:28 PM
Replies: 8
Views: 552
Posted By Dsherm112

Thanks for the help. D Sherm

Thanks for the help.


D Sherm
11-28-17, 01:01 PM
Replies: 8
Views: 552
Posted By Dsherm112

Refrigerator Connections

I don't know what I;m dealing with here. The store said I'd get a stainless line to hook up the fridge to the water line. I read in their literature that I need to install a stop within 6' of the...
11-28-17, 12:45 PM
Replies: 8
Views: 552
Posted By Dsherm112

Refrigerator Connections

I'm having a new refrigerator delivered in 2 wks. It has a stainless steel connector for the ice/water hookup. I have to plump the valve to hook up to this. The tubing goes through a ceramic floor....
Replies: 2
Views: 404
Posted By Dsherm112

1979 Olds Cutlass Supreme Brougham

I'm replacing the interior driver's side door handle. The latch cable has a fish hook on the end that hooks into the handle to open the door. When I removed the old handle I just slipped the cable...
Replies: 9
Views: 559
Posted By Dsherm112

Door Handle

I'm replacing the door release handle. Based on your advice I'll leave the mirror connected. Is having the window down meant for the upper or lower panel.

Thanks
Replies: 9
Views: 559
Posted By Dsherm112

Pic Attached

I hope this works. I've tried many times.
Replies: 9
Views: 559
Posted By Dsherm112

79 Olds Cutlass Supreme Brougham replace drivers interior door handle.

I need to remove the bottom door panel to fix this. I'm ok with all steps except the remote mirror adjuster trim chrome ring. I can't get this trim off. I've watched U-tube video's but none of them...
Replies: 6
Views: 1,265
Posted By Dsherm112

2006 Chevy Impala Stuck Rotors

I tried to change the brakes and rotors on this car. The rotors wouldn't budge. Tried a hammer and a torch, no help. How do you remove stuck rotors?
Replies: 3
Views: 582
Posted By Dsherm112

I tried to upload a picture but it failed. I'm...

I tried to upload a picture but it failed. I'm not sure that it's necessary. The system worked fine for 10 yrs and then started to malfunction at the end of last heating season. There were no changes...
Replies: 3
Views: 582
Posted By Dsherm112

Zones Overheating

National Boiler
Taco, SR 503 Control Panel
3 Zones
2 Programmable Thermostats, I regular thermostat


I'm having a problem with overheating in the 2 zones with the programmable...
Replies: 5
Views: 11,734
Posted By Dsherm112

The plastic thing did the job. Thanks, ...

The plastic thing did the job.

Thanks,

Denny
Replies: 5
Views: 11,734
Posted By Dsherm112

Replacing Moen #1225 Tub/Shower Faucet Cartridge

I am trying to replace this cartridge. I have removed the retainer clip. I have tried pulling the cartridge out with pliers and vise grips, but it won't budge. Is there a secret to getting this...
Replies: 3
Views: 981
Posted By Dsherm112

The original filler neck is in the car. It has a...

The original filler neck is in the car. It has a miniscule Hole. Gas does not leak. Is there any reason to replace it?
Replies: 3
Views: 981
Posted By Dsherm112

98 Pontiac Transport Fuel Filler Neck

What is the procedure for replacing the filler neck on this car? Does the tank need to be dropped? Does it matter if I don't replace it for a few months? Thanks

Sherm
Replies: 3
Views: 948
Posted By Dsherm112

The pins are new and the slides and pins are...

The pins are new and the slides and pins are greased. The flexible hose between the strut and caliper was replaced.

Sherm
Replies: 3
Views: 948
Posted By Dsherm112

Pontiac Transport Caliper Sticking

1998 Pontiac Transport, 6 cyl, 152,000 miles

I have a 1998 Pontiac Transport that the left front caliper is sticking. I can smell the brakes burning and feel them dragging. I have replaced the...
Replies: 1
Views: 999
Posted By Dsherm112

Pilots Won't Stay Lit

The pilots on my boiler and water heater won't stay lit. I'm lighting them every day. My suspicion is a break in the supply line outside. Could this be the problem, or is it just poor pressure?...
Replies: 10
Views: 2,474
Posted By Dsherm112

Honda Lawn Mowers

I need to purchase a new mower. My 22 yr old Honda has died. I'm looking at a Honda HRR216VKA for $399 at Home Depot and A Honda HRR216K5VKA for $479 at the local Honda dealer. In comparing the specs...
Replies: 2
Views: 803
Posted By Dsherm112

New Boiler

I have a 50 yr old gas boiler. I use gas for heat, hot water and clothes drying. My monthly bill averages $100. If I replace the boiler with an 80% efficiency boiler will it be cost effective.
...
Showing results 1 to 25 of 155
 


 
Forum Jump