Search: Posts Made By: DaDruid
Showing results 1 to 23 of 23
Search took 0.01 seconds.
Replies: 3
Views: 124
Posted By DaDruid

Pilot Dane, TYVM for your response. I have been...

Pilot Dane, TYVM for your response. I have been on well water before bust never had a sediment filter before so was not familiar with results.
Replies: 3
Views: 124
Posted By DaDruid

Drilled Well Sediment Filter

I currently have a 140 ft drilled well with a casing depth of 120 ft. I have sediment and/or iron/rust clogging the currently installed inline sediment filter. Would installing an additional sediment...
05-18-11, 04:11 PM
Replies: 6
Views: 823
Posted By DaDruid

SO tldoug, would you reccomend forgoing the...

SO tldoug, would you reccomend forgoing the installion of a window and sealing it up.

I do have a basement door on the other side. I am trying to use the space efficiently as possible as well let...
Replies: 4
Views: 2,010
Posted By DaDruid

Thank you very much for your help. Based on what...

Thank you very much for your help. Based on what I have read it is going to be a better idea to move that use the existing.
Replies: 9
Views: 134,397
Posted By DaDruid

As a former cable TV contarctor I will do my best...

As a former cable TV contarctor I will do my best to explain and help where I can. Lets start with the education first. TV signal is typically measured in dB. Comcast's standard is that you should...
Replies: 4
Views: 2,010
Posted By DaDruid

Dryer Vent Duct Placement

Wasn't sure if this was the correct forum location so I will try and let me know if I need to run it in another place.

I am moving my dryer and I am trying to figure out if I need to re run my...
05-17-11, 04:08 PM
Replies: 6
Views: 823
Posted By DaDruid

Measuring for a New Window

Been ahwile since I have been in the forum.

I have a hole in my basement wall that use to be used for shuffling wood in for my wood stove. When the owner before me did not use this hole any more...
Replies: 1
Views: 1,169
Posted By DaDruid

1993 Pathfinder Factory Alarm

I have a friend who recently purchased a 1993 Nissan Pathfinder SE-V6. He was not given the key fob for the stock alarm. We would like to disconnect the factory alarm (when the alrams sounds it is...
09-12-08, 10:23 AM
Replies: 1
Views: 830
Posted By DaDruid

Insulation around exisitng duct work

I have recently started to insulate the ceiling in my unfinished basement to help insulate the tiled florr above it. Everything was going fine until I reached areas with existing AC duct work. My...
Replies: 7
Views: 1,227
Posted By DaDruid

THanks guys. I am actually going to give all 3 a...

THanks guys. I am actually going to give all 3 a try in the end. I will update you when I get it done tonight.
Replies: 7
Views: 1,227
Posted By DaDruid

Nope no more detail. I have the OEM XP cd. This...

Nope no more detail. I have the OEM XP cd. This is how I have gotten into the Recivery Console. Upon following other instructions online I exit and reboot and it take me to the screen where I...
Replies: 7
Views: 1,227
Posted By DaDruid

Question \WINDOWS\SYSTEM32\CONFIG\SYSTEM Error

I keep having this pop up on my Dell Latitude D531 laptop. I have been everywhere else on the net and following all kinds of instructions on how to repair my registry (I believe that is the issue)...
Replies: 7
Views: 1,205
Posted By DaDruid

Question Update on Pressure Switch Situation

I tightned all my fittings, no leaks, replaced my pressure switch (again) with a new one. Everything seems to be working BUT, I am still loosing pressure, very, VERy slowly, almost unrecognizable...
Replies: 1
Views: 1,144
Posted By DaDruid

Question Moving a Dryer Vent

Would it be unreccomendable to mive your dryer vent to underneath your deck?
Replies: 7
Views: 1,205
Posted By DaDruid

I have figured out the adjust. It is only 1 nut...

I have figured out the adjust. It is only 1 nut but I am getting the hang of it (I think). Which directions are which on a single nut? Clockwise vs. Counter Clockwise, shut off pressure up or...
Replies: 2
Views: 942
Posted By DaDruid

Exclamation Bad Front End Vibration PLEASE HELP!

My 2004 Dodge Stratus has a really BAD vibration during braking at high and medium and even slow speeds. I thought it was warped rotors but when I replaced my brake pads recently yhe rotors felt...
Replies: 1
Views: 754
Posted By DaDruid

Dryer Vent Help

I do not know if I am in the right place. I looking for guidence on moving my Dryer vent.

If this is or is not the correct forum please let me know so I do not waste anybodies time.
Replies: 7
Views: 1,205
Posted By DaDruid

Question Help with Pressure Switch on Pressure Tank

I recently replaced my pressure tank and switch. Unfortunately when replacing the switch the switch now rests against my tank. I wanted to see if it was a bad idea to put a couple of bends in the...
Replies: 1
Views: 908
Posted By DaDruid

Lightbulb Water Softener vs. Filtration

Anybody have any recomendations? I have been thinking about adding one of these two items to my well water system here at me house and would like some opinions!
Replies: 5
Views: 1,732
Posted By DaDruid

Valveguy, you were correct. It was the pump (or...

Valveguy, you were correct. It was the pump (or atleast a pump wire). I replaced the tank becasue I was reccomended by a local plumber friend. Well after doing so that did not do it so a long...
Replies: 5
Views: 1,732
Posted By DaDruid

Wait a minute, lets try this and see if anybody...

Wait a minute, lets try this and see if anybody can see my skecth. Please let me know if you do not.http://************/view.php?pic=70jq0k&s=3
Replies: 5
Views: 1,732
Posted By DaDruid

Unfortunately the moderater does not allow...

Unfortunately the moderater does not allow attachments and I can not figure out how to turn my pic into a URL, so here is a description instead. In is a Lowes WellSaver 36 gal. upright pressure...
Replies: 5
Views: 1,732
Posted By DaDruid

No Water After Installing New Pressure Tank

HELP!!!!! I am new to this board. I just (1 hr. ago) installed a new pressure tank. I set the pressure to 2 PSI 30 on a 30/50 switch. It is still not working. No water for the last 24 hrs and no...
Showing results 1 to 23 of 23


 
Forum Jump