Search: Posts Made By: rob24chevy
Showing results 1 to 25 of 76
Search took 0.01 seconds.
Replies: 9
Views: 1,661
Posted By rob24chevy

Water pump on this engine is in the timing chain...

Water pump on this engine is in the timing chain cover and is driven by the timing chain sounds like it has gone bad and leaking into the engine almost has to be , there is no where else on this...
Replies: 10
Views: 22,442
Posted By rob24chevy

yes you will have to remove the punp from the...

yes you will have to remove the punp from the transmission. then the o-ring i`m talking about is a big o-ring around the outside of the pump probably around 6-8 inches around, be sure to get the...
Replies: 10
Views: 22,442
Posted By rob24chevy

you should have a tranny shop pull the front pump...

you should have a tranny shop pull the front pump and check the rubber o-ring around the pump these are known to dry out and fool alot of people into thinking seal ! When we pull a tranny to put a...
Replies: 9
Views: 15,127
Posted By rob24chevy

If its on the 3.1 it isn`t that bad. you just...

If its on the 3.1 it isn`t that bad. you just have three 13 mm bolts that are accessable throught the pully holes, and a 16mm high pressure line , and a ruturn line to un hook, it has a small spring...
Replies: 7
Views: 2,007
Posted By rob24chevy

That engine is known to leak from the head gasket...

That engine is known to leak from the head gasket at the back side of the head under the intake. Near the fire wall! Just a possibility to look at. I`ve replaced a couple in the last couple yrs.
Replies: 3
Views: 829
Posted By rob24chevy

Check Fuel Pressure !!!

Check Fuel Pressure !!!
Replies: 11
Views: 7,852
Posted By rob24chevy

you did`nt need to take brakes apart or the...

you did`nt need to take brakes apart or the "upper" balljoint loose, just the bottom one ! take the nut off and take a hammer and hit the casting that the balljoint stud goes through real hard a...
Replies: 11
Views: 1,177
Posted By rob24chevy

sounds like it could also be fuel pressure !!

sounds like it could also be fuel pressure !!
Replies: 5
Views: 11,287
Posted By rob24chevy

1870 is a valve worn out in the valve body in the...

1870 is a valve worn out in the valve body in the tranmission. It can be fixed by taking out the valve body and buying a hone from a tranny shop and honeing out the bore for the valve and putting in...
Replies: 6
Views: 1,934
Posted By rob24chevy

Have you had the distributor out for any reason...

Have you had the distributor out for any reason because this is a corelation code for the crank and cam sensors !!
Replies: 31
Views: 6,489
Posted By rob24chevy

those cam gears are also used on the 2.0 engine...

those cam gears are also used on the 2.0 engine BUT the MARKS ARE ON THE OPPOSITE SIDE .... make SURE you put the cam gears back on the right way!!! Also check the fuel pressure regulator sounds like...
Replies: 4
Views: 1,799
Posted By rob24chevy

The after market distributor caps for these...

The after market distributor caps for these engines are junk, MUST put a GM cap on it, the after market caps are molded with the bands for the plug wire terminals too close together and will cause it...
Replies: 1
Views: 1,242
Posted By rob24chevy

the only way to easily remove the switch from...

the only way to easily remove the switch from most fords is to have the key and get the switch into the "RUN" position and use a small punch or paper clip and push in on the small pin on the bottom...
Replies: 10
Views: 6,507
Posted By rob24chevy

Fel-pro has actually started making those intake...

Fel-pro has actually started making those intake gaskets out of metal and rubber instead of the composite ones, but the anti-freeze has nothing to do with the gasket failure it`s just poor gasket...
Replies: 2
Views: 1,078
Posted By rob24chevy

Fan will work it should be a clutch fan on the...

Fan will work it should be a clutch fan on the water pump! Check timing and compression !
Replies: 14
Views: 1,852
Posted By rob24chevy

Thanx bejay i guess i would know that too since i...

Thanx bejay i guess i would know that too since i work in a transmission shop !!!!!
Replies: 1
Views: 683
Posted By rob24chevy

I`ts a 4 wire plug on side of tranny near...

I`ts a 4 wire plug on side of tranny near radiator!
Replies: 5
Views: 3,413
Posted By rob24chevy

Check the vacum line going to the modulator valve...

Check the vacum line going to the modulator valve on the right side of tranny.
Replies: 14
Views: 1,852
Posted By rob24chevy

you can also just unplug the 4 wire plug on the...

you can also just unplug the 4 wire plug on the side of the tryaany and it will run fine just no lock-up !!
Replies: 16
Views: 1,954
Posted By rob24chevy

you may want to consider a speed sensor try first...

you may want to consider a speed sensor try first if the speedometer isnt working.
Replies: 16
Views: 1,795
Posted By rob24chevy

Towman you nailed it with the ignition...

Towman you nailed it with the ignition module.Fixed it with a new one. Thanx for all the help peeps. GREATLY APPRECIATED!!!!:thumbup: :D
Replies: 16
Views: 1,795
Posted By rob24chevy

thanx towman will check tomorrow its getting...

thanx towman will check tomorrow its getting close to bed time here in good old north carolina but ill post tomorrw enening thanx to all who have helped
Replies: 16
Views: 1,795
Posted By rob24chevy

nope no codes whatsoever. The engine is a 3.8 v6...

nope no codes whatsoever. The engine is a 3.8 v6 i have ran a self test and everything seems to pass those tests a slow code test and fast code test. I also checked for codes before the pcm was...
Replies: 16
Views: 1,795
Posted By rob24chevy

autozone says no cam sensor or crank sensor for...

autozone says no cam sensor or crank sensor for this vehicle so what now? What controls injector pulse, air flow ?
Replies: 16
Views: 1,795
Posted By rob24chevy

yes but where would you go from there do you pcm...

yes but where would you go from there do you pcm replaced.
Showing results 1 to 25 of 76
 


 
Forum Jump