Search: Posts Made By: bob57
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Replies: 8
Views: 1,100
Posted By bob57

:dogrun: I will run down to the parts house...

:dogrun: I will run down to the parts house tomorrow.
:wall: then decide which AC/Delco plugs to get.

:thumbup: Just want to thank each one of you for your input.
P.S. NO SUCH THING AS A...
Replies: 8
Views: 1,100
Posted By bob57

thank ya for your response OK, :thinker: no...

thank ya for your response

OK, :thinker: no such thing as a life time plug could you suggest a plug (V8driver said something about a platinum plug) is there a plug for high milage? :confused:
Replies: 8
Views: 1,100
Posted By bob57

spark plugs

I have '91 cheyenne 350. My dad orginal owner, keeps telling the truck came lifetime spark plugs, truck has 107,000 miles. Did or does Chervolet put this type of spark plugs in their engines? Any...
Replies: 4
Views: 957
Posted By bob57

First of all Thank you for your reply. I had...

First of all Thank you for your reply.

I had the alternator bench tested today and was assured that alternator is good. After I installed it, the voltmeter on the dash was registering a little...
Replies: 4
Views: 957
Posted By bob57

'91 chevy PU 350engine

I got a hand me down truck and today I noticed volt gauge in the red on the charge side (right)? I went to a parts house they said the alternator is bad so I bought a rebuilt one put it in connected...
Replies: 3
Views: 11,495
Posted By bob57

rv floor

Yes Sir Doc,

I agree with you and have done so. Dealer has a bad reputation and I have talked via e-mail a rep. at the factory inwhich the trailer was made, all the rep. told me I can bring it...
Replies: 3
Views: 11,495
Posted By bob57

RV Floor Rotting

I have a 2003 Mallard 30N. The floor at the front door has rotted and the vinyl discolor is spreading along the wall on each side of the door. My question is were can I find information or any...
Replies: 7
Views: 10,260
Posted By bob57

A hair dryer has enough heat to get the glue soft...

A hair dryer has enough heat to get the glue soft enough so you can rub/wipe the residue off with a rag. hope this works for you as it did for me.
01-11-06, 08:21 PM
Replies: 4
Views: 925
Posted By bob57

I do have a ridge vent, it was installed along...

I do have a ridge vent, it was installed along with the roof and there was not any type of vent before the new roof.
This room along with additional room were added in the 60's other room was a...
01-10-06, 08:01 PM
Replies: 4
Views: 925
Posted By bob57

utility room make over

Hello folks
I'm on the Texas Gulf coast. The utility room is 10'x10' and has 3 doors (one is ext.) two windows and water heater, washer and dryer. The room is not climate controled, the walls are...
Replies: 1
Views: 708
Posted By bob57

Question ZTR Mowers

Does a web site exist that has the different (ztr) mowers made?
Replies: 2
Views: 1,163
Posted By bob57

ryobi trimmer

thanks for info on the 40:1 mix.

The O.D. of the stop is larger than the I.D. of the tube. The tube end in question is flaired, that O.D. is just a little shy of stop O.D.
Replies: 2
Views: 1,163
Posted By bob57

Ryobi trimmer

I'm going at this for the first time so here it goes. :blah: I have an Ryobi 790r click link. The entire unit tried swimming during hurricane Rita unsuccesful. Every thing appears good, except the...
Showing results 1 to 13 of 13


 
Forum Jump