Search: Posts Made By: landonspop
Showing results 1 to 11 of 11
Search took 0.01 seconds.
09-24-19, 12:34 PM
Replies: 2
Views: 367
Posted By landonspop

Thank you for replying. Line is not plugged. I...

Thank you for replying. Line is not plugged. I hooked drain line to water hose and out of the garage to the drive way. I am told water is moving to fast in stage 2, the brine suction mode.

All new...
09-24-19, 10:21 AM
Replies: 2
Views: 367
Posted By landonspop

no suction on water softener to suck brine

I have replaced every part that is possible and can not get state 2 to syphon brine water. Instead, after a complete cycle, I end up with a tank full of water. It should be about 2 gallons. or a few...
09-21-19, 04:28 PM
Replies: 0
Views: 306
Posted By landonspop

Waterboss 900: high water pressure issues?

I have changed out every part that can be changed out on a waterboss 900. I cannot get it to syphon brine tank.

Can high water pressure force water around rubber o-rings?

I ran twice with no...
09-19-19, 09:31 PM
Replies: 2
Views: 301
Posted By landonspop

not fixed yet

I found the problem but not the fix. Just in case this was read wrong above.
09-19-19, 07:08 AM
Replies: 2
Views: 301
Posted By landonspop

OK, I think I found my problem. The float ball...

OK, I think I found my problem. The float ball seems to stick on bottom unless I wiggle it. Then it will float in water. I cannot find any reason for it to stick.

Any ideas on this?
09-18-19, 08:34 PM
Replies: 2
Views: 301
Posted By landonspop

Waterboss 900 not draining with new parts

I got lucky and Home Depot had a new (old) unit in storage. It had been a display model and a few pieces were missing including the computer. They were about to scrap it and they let me buy it for...
Replies: 3
Views: 571
Posted By landonspop

I have had this unplugged for 48 hours now. Even...

I have had this unplugged for 48 hours now. Even more by morning when I open back up. Should the HIGH power be drained by now?
Replies: 3
Views: 571
Posted By landonspop

Samsung Smart oven fuse burning

I have a Samsung that has microwave, convection oven, fry, grill and combinations of these.

About 2 months the fuse blew when trying to start. Replaced fuse and all worked again but started...
12-07-11, 08:15 AM
Replies: 5
Views: 2,338
Posted By landonspop

First: I know where I am going to place the tank...

First: I know where I am going to place the tank now. It will go between water softener and water heater, but closer to water softener on cold line. More room in garage to work than small closet in...
12-06-11, 06:36 PM
Replies: 5
Views: 2,338
Posted By landonspop

The only issue I have with this is: this would...

The only issue I have with this is: this would all be underground. My meter is in hole about 2' from sidewalk, then my shutoff. Each in a round plastic meter box. I have a shutoff right before...
12-06-11, 03:10 PM
Replies: 5
Views: 2,338
Posted By landonspop

PRV and expansion tank

I am going to add a pressure relief valve to my house to release pressure from city water. I am adding this right after the water meter and before a shutoff valve.

Should it follow shut off...
Showing results 1 to 11 of 11


 
Forum Jump