Search: Posts Made By: mattison
Showing results 1 to 25 of 200
Search took 0.05 seconds.
Replies: 4
Views: 1,210
Posted By mattison

So it's not saying the computer has failed....

So it's not saying the computer has failed. That's good. Any advice on what needs replaced going off of the other 2 codes? Knock on wood it's been giving me no problems starting lately.
Replies: 4
Views: 1,210
Posted By mattison

Would that cause the rough start issue? Runs...

Would that cause the rough start issue? Runs great other than that. Computer sound costly.
06-06-13, 06:32 PM
Replies: 5
Views: 908
Posted By mattison

Sounds like the t-stat is bad.

Sounds like the t-stat is bad.
06-06-13, 06:23 PM
Replies: 7
Views: 1,109
Posted By mattison

You may be successful in finding the leak but...

You may be successful in finding the leak but that's where the DIY part stops. In order to repair it any remaining refrigerant has to be recovered, leak repaired, system properly evacuated, then...
Replies: 4
Views: 1,210
Posted By mattison

93 Mustang LX Rough Start

OK guys I need some help.

93' Mustang LX
2.3l 4 CYL
5 Speed

Occasionally upon starting after sitting it runs really rough for a minute or two and then smooths out and runs like a new car. It...
03-03-11, 09:50 AM
Replies: 8
Views: 16,964
Posted By mattison

Like said the true way to check proper charge...

Like said the true way to check proper charge would be super heat/sub cooling. That being said your system is R-410 and the oil is very hygroscopic, meaning it absorbs moisture very easily. If your...
03-03-11, 09:34 AM
Replies: 2
Views: 2,781
Posted By mattison

Have you checked the blower wheel real good to...

Have you checked the blower wheel real good to make sure there's nothing inside of it? I have found countless things in blower wheels causing noise.
Replies: 1
Views: 4,679
Posted By mattison

You could possibly get what you need from...

You could possibly get what you need from Goodmans site.
Replies: 6
Views: 17,846
Posted By mattison

You've got delayed ignition. More than likely due...

You've got delayed ignition. More than likely due to a spider web in the gas trane. What needs to be done is to remove all the burners and crossovers and blow them out good with compressed air. Pipe...
10-06-10, 05:21 AM
Replies: 6
Views: 1,789
Posted By mattison

If it's in an area where a lot of snow, ice,...

If it's in an area where a lot of snow, ice, leaves, etc... will accumulate on the top it's not a bad idea to put a piece of plywood or the like with a brick to hold it down. Just be sure and...
Replies: 13
Views: 1,301
Posted By mattison

That's what I'm talking about. :)

That's what I'm talking about. :)
Replies: 4
Views: 814
Posted By mattison

Fuel pump was going out. Replaced it and back on...

Fuel pump was going out. Replaced it and back on the road. Thanks for the help.
Replies: 3
Views: 1,548
Posted By mattison

Bingo and thanks for the help. Had to replace the...

Bingo and thanks for the help. Had to replace the right side and all is well.
Replies: 4
Views: 814
Posted By mattison

Cool I'll do that. Where is the check valve...

Cool I'll do that. Where is the check valve located. It has a newer "2-3 years old" fuel pump in it.
Replies: 3
Views: 1,548
Posted By mattison

2001 S-10 Blazer ABS Issue.

2001 S-10 Blazer
4X4
4.3l V-6

ABS light was on. Tested the front ABS sensors and got no readings. Ordered 2 new ones from on-line dealer. Installed them as directed. Now ABS light has went out...
Replies: 4
Views: 814
Posted By mattison

2001 S-10 Blazer Starting Issue.

2001 S-10 Blazer
4.3l V-6

I have an issue that began a while back to where when you 1st go to start it after it's been sitting it would take several tries before it would start. Once started it...
Replies: 2
Views: 779
Posted By mattison

Thanks Bill. Sounds like a ton of...

Thanks Bill. Sounds like a ton of fun............... :program:
Replies: 2
Views: 779
Posted By mattison

01' Blazer HVAC issue.

01' Chevy Blazer
4.3l
4X4

Problem just started that air will not blow out of the vents for your feet. If you put the selector switch for your feet or defrost/feet it only blows out of the...
Replies: 6
Views: 8,561
Posted By mattison

They sell a brush burner that attaches to a...

They sell a brush burner that attaches to a propane tank.
01-29-10, 05:13 AM
Replies: 4
Views: 906
Posted By mattison

Just about anything will work. I usually will use...

Just about anything will work. I usually will use the S locks that connect ductwork. Another simple hanger is hole strap like plumbers use.
01-25-10, 01:02 PM
Replies: 1
Views: 820
Posted By mattison

As for the power and refrigeration lines you...

As for the power and refrigeration lines you could mount the indoor unit on an interior wall. The one problem would be the condensate lines. Normally they run straight outside, if they're on an...
12-11-09, 05:08 AM
Replies: 1
Views: 2,267
Posted By mattison

I'm not the official oil pro here and they will...

I'm not the official oil pro here and they will more than likely chime in with other "detailed" methods but what you probably will need to get is a "wet pack". It will come with instructions on the...
12-09-09, 04:49 AM
Replies: 5
Views: 1,143
Posted By mattison

Maybe ask around the neighborhood or put up some...

Maybe ask around the neighborhood or put up some signs. Very well may be someones cat that either wandered from their home or is just visiting you.
Replies: 10
Views: 42,183
Posted By mattison

I used to work at a place back in the 80's and...

I used to work at a place back in the 80's and did a good amount of flood repairs to cars. Like Bud say's it gets into the padding. What we would do is remove all of the interior, carpet, padding,...
11-20-09, 12:36 PM
Replies: 23
Views: 1,620
Posted By mattison

Being the system is that old the duct work is...

Being the system is that old the duct work is more than likely not sized for a/c. What you need to do is get bids from at least 3 quality HVAC companies. They will all need to do a Manual D...
Showing results 1 to 25 of 200
 


 
Forum Jump