Search: Posts Made By: alwayz
Showing results 1 to 25 of 138
Search took 0.02 seconds.
Replies: 5
Views: 2,672
Posted By alwayz

I checked everything out and found no thermal ...

I checked everything out and found no thermal
fuse and I have power to the brushes. I removed the armature and sure enough...one of the wires on the brush end broke just under the connection:(
...
Replies: 5
Views: 2,672
Posted By alwayz

thanks for the heads up to look for the thermal...

thanks for the heads up to look for the thermal fuse. I'll tear it back down this weekend and see what I can see:D
Replies: 5
Views: 2,672
Posted By alwayz

armature spins freely and looked good, brushes...

armature spins freely and looked good, brushes looked good, no funky smell, I cant see any wires fried.

as far as forcing the material, I was cutting a 3/4 groove in some 2x4's 1/2" deep and...
Replies: 5
Views: 2,672
Posted By alwayz

I fried my ryobi router...

I think I ran it too long without letting it cool down and it quit on me:wall: . My only question is, when this happens, what exactly fries out in them? No smoke was let out of the motor, it just...
Replies: 2
Views: 1,329
Posted By alwayz

thanks for the snips idea;) I'll give that a...

thanks for the snips idea;) I'll give that a try!
Replies: 2
Views: 1,329
Posted By alwayz

cutting a hole in the top of the heater trunk...

I have a 4 year old house and I am adding a bedroom in the lower level. I didnt want to tackle doing the HVAC work since I know nothing about it so i had a company come in and give me an estimate on...
03-15-08, 10:03 AM
Replies: 4
Views: 2,995
Posted By alwayz

What I mean is, if I have a 16 foot long wall to...

What I mean is, if I have a 16 foot long wall to build, is it correct to build 2 8' walls, stand them up, and nail them together?


..and by your reply it looks like I can:cool:
03-15-08, 09:03 AM
Replies: 4
Views: 2,995
Posted By alwayz

quick question on non-load bearing wall framing...

Since I don't have any 16 foot 2x4's, does anyone know if its generally accepted to build a 15 foot non-load bearing wall in 2 sections and nail them together? Or does it vary from state to state?
...
Replies: 4
Views: 959
Posted By alwayz

I double checked that the fan was moving, waited...

I double checked that the fan was moving, waited a few seconds for it to die again, went thru to make sure everything was still plugged in and seated, found the cpu fan brackets were loose and not...
Replies: 4
Views: 959
Posted By alwayz

i think 2-3 years old. I will check the power...

i think 2-3 years old. I will check the power supply tonight, thank you!
Replies: 4
Views: 959
Posted By alwayz

HP a335w keeps shutting down....

A friend handed me her PC to take a look at. Dont know much about it except its a p4 running XP. WHen you first turn the computer on (after letting it sit for a day or so)it will get all the way to...
Replies: 6
Views: 7,526
Posted By alwayz

I doubt it will be alive that long. The motor,...

I doubt it will be alive that long. The motor, which has always been on the noisy side, is already puffing at me. Im probably going to have to put a motor in it at the end of this season. Im glad...
Replies: 6
Views: 7,526
Posted By alwayz

thanks for the replies, guys. I guess I'll just...

thanks for the replies, guys. I guess I'll just it leave be.


thanks!
Replies: 6
Views: 7,526
Posted By alwayz

2004 craftsman LT2000 rear axle fluid change?

I have a Craftsman rider that I would like to change the fluid on, but I cannot seem to locate a drain/fill plug. I figure before I rip the axle out and disconnect everything, I would ask if there...
Replies: 3
Views: 1,666
Posted By alwayz

thanks for the reply. I am kinda in a limbo...

thanks for the reply. I am kinda in a limbo state here. We are a new subdivision, so we need permits for everything. I wanted to get an idea of the total cost and if I needed to make mods to the...
Replies: 3
Views: 1,666
Posted By alwayz

screen porch load question?

I added a 12x14 deck to my house last year and now I want to add a screened porch. It is attached to the house and is also supported by 6 4x4's bolted to 8" concrete tubes 4' deep...4 feet off the...
Replies: 4
Views: 2,872
Posted By alwayz

can you hear the FP prime if you turn the key off...

can you hear the FP prime if you turn the key off and back to run, but not start?
Replies: 8
Views: 1,901
Posted By alwayz

I agree 100% possible that its a...

I agree 100%



possible that its a leak, but I am not convinced for some reason.
Replies: 8
Views: 1,901
Posted By alwayz

That was my first thought but the problem popped...

That was my first thought but the problem popped up again the next day with 3/4 full tank. with the fuel pick-up on the bottom, that shoots that theory.



I would tend to think that the cap...
Replies: 8
Views: 1,901
Posted By alwayz

update....as far as I can tell....there must have...

update....as far as I can tell....there must have been some water in my tank because everything is running ok now. I had gotten a tank of gas from work a week or so before hand and found out that...
Replies: 8
Views: 1,901
Posted By alwayz

thanks for the reply.... I think maybe the evap...

thanks for the reply....
I think maybe the evap code was from the RPMs jumping up and down so fast? dont hear any noises...

update for today...

so this morning, I got on the interstate and...
Replies: 8
Views: 1,901
Posted By alwayz

04 taurus trouble codes retrieved....

2004 taurus DOHC 3.0l 69k changed fuel filter 2 weeks ago

I posted last week about my Taurus engine light coming on. 3 days later it went off and all was good.

Today on my way home cruising...
Replies: 2
Views: 652
Posted By alwayz

separate light for the cap but I checked that...

separate light for the cap but I checked that yesterday just incase and didnt go off.... forgot about autozone scanning things. I guess I will have to swing by there. Thanks!
Replies: 2
Views: 652
Posted By alwayz

2004 taurus engine light.....

Replaced fuel filter this past weekend. Tapped the fuel shut off in the trunk, started the car and ran till dead, replaced filter, reset switch in trunk, primed pump, and started car.
...
Showing results 1 to 25 of 138
 


 
Forum Jump