Search: Posts Made By: beamhillrd
Showing results 1 to 25 of 72
Search took 0.01 seconds.
Replies: 11
Views: 251
Posted By beamhillrd

OK, it all points to the sealed system. Thank you...

OK, it all points to the sealed system. Thank you all for your help.
Replies: 11
Views: 251
Posted By beamhillrd

Not a lot of frost on the coils, the ones at the...

Not a lot of frost on the coils, the ones at the bottom did not seem to have any frost. I will try to post photos. I opened up back of freezer and let run with fan removed a couple hours. Seemed to...
Replies: 11
Views: 251
Posted By beamhillrd

Freezer temp was again at 14 degrees at 10pm last...

Freezer temp was again at 14 degrees at 10pm last night, same at 7am today. Refrigerator section was 37 degrees. It was running at this point, probably ran all night (?). I backed off the...
Replies: 11
Views: 251
Posted By beamhillrd

Thanks PJmax and manden. I forced the defrost...

Thanks PJmax and manden. I forced the defrost several times. Later, I opened up the back of the freezer and the coils had no ice and no frost. I tried attaching a photo. Both the evaporative fan and...
Replies: 11
Views: 251
Posted By beamhillrd

Thanks for the reply. Three days ago, freezer...

Thanks for the reply. Three days ago, freezer door ajar, how long, don't know. Ice cream soft. I put thermometer in freezer then and temp has stayed at 14 since then. I also put a thermometer in...
Replies: 11
Views: 251
Posted By beamhillrd

Refrigerator freezer at 14 degrees

I have a freezer on top Frigidaire FGUI2149LP2 refrigerator. Just recently, the freezer is staying at 14 degrees (soft ice cream!). The refrigerator section temp is good at about 35. The evaporator...
Replies: 5
Views: 609
Posted By beamhillrd

Thanks again marksr. I am slowly getting there....

Thanks again marksr. I am slowly getting there. Below is my attached drawing assuming hole depth of 42", footing width (diameter) of 21" and footing thickness of 8". Is this what is intended by the...
Replies: 5
Views: 609
Posted By beamhillrd

OK - thanks marksr. Want to make sure i...

OK - thanks marksr. Want to make sure i understand correctly: If my footer is in the ground 42" (to get below frost line) and it is 4" above ground then the footing thickness for this is 46", yes?...
Replies: 5
Views: 609
Posted By beamhillrd

Footing diameter v. footing thickness

I do not understand the difference between the terms "Round Footing Diameter" and "Footing Thickness" in the Prescriptive Residential Wood Deck Construction Guide, Figure 4, page 12.

For my...
Replies: 7
Views: 671
Posted By beamhillrd

Hi- just pulled the heating element both circuits...

Hi- just pulled the heating element both circuits test positive for continuity. However it seems that for the two coils interconnected, if just one of these two could have a break, it would still...
Replies: 7
Views: 671
Posted By beamhillrd

Thanks pugsli. Makes sense. Have taken apart...

Thanks pugsli. Makes sense. Have taken apart before with help from Youtube or Repair Clinic. Will give it a try and post back.
Replies: 7
Views: 671
Posted By beamhillrd

Thanks Pjmax. Disconnected vent and ran with...

Thanks Pjmax. Disconnected vent and ran with load. Same result, got up to about only 94F. Ran without load, it cycled around 135-140 on high heat. Maybe the load makes that big a difference in...
Replies: 7
Views: 671
Posted By beamhillrd

GE Electric Dryer Low Heat

The dryer model is DPSE810EG4WT. Wife said it did not seem to be getting as hot as in the past (High heat setting). I tested dryer running empty with a thermometer in the vent. When empty, it got...
Replies: 1
Views: 407
Posted By beamhillrd

Need help using router

I have a project where I have to have a 5/16" slot about 4 inches long in a piece wood that is 6" x 6" x .25". Is this something that could be done with a router? I have never used one and would...
Replies: 4
Views: 509
Posted By beamhillrd

Thanks chandler. Would you mind explaining what...

Thanks chandler. Would you mind explaining what you mean by "crack the case".

Thanks.
Replies: 4
Views: 509
Posted By beamhillrd

Small leak after Subaru Forester 2012 engine replacement

Subaru Forester 2012 engine seized at 110,000 miles. Not sure why, but it was not due to lack of oil or not doing proper oil changes.

Engine was replaced by Subaru dealer last Friday. Have...
Replies: 3
Views: 666
Posted By beamhillrd

I do have a rather long vent, yesterday I...

I do have a rather long vent, yesterday I disassembled and cleaned completely, though was not much lint, and did not resolve problem. Flow at exterior vent end seems normal but will check as you...
Replies: 3
Views: 666
Posted By beamhillrd

GE Dryer Heating but Not Full Heat

GE electric dryer DPSE810EG4WT seems to have lower than normal heat, long time to dry. Heating element is WE11X20397. This element appears to have 3 coils. Could just one or two of them be not...
Replies: 7
Views: 1,024
Posted By beamhillrd

Update #2 from original poster

Tested transformer at AC, working ok at about 27v. So now thinking faulty circulating pump; would zone valves not open if pump doesn't work?
Replies: 7
Views: 1,024
Posted By beamhillrd

update from original poster

I am not getting any reading at the valves from the transformer. Should be 12 or 18 dc volts I believe (?).
Replies: 7
Views: 1,024
Posted By beamhillrd

Oil burner heats water; does not provide baseboard heat

My Weil-McLain boiler comes on to provide hot water (coil in boiler), but does not respond to calls for heat from any of four zones. I probably can't make this repair myself (unless it is something...
Replies: 3
Views: 2,977
Posted By beamhillrd

Repair Exterior Foundation Spalling

On my homes exposed concrete foundation, which is approx 20" from ground to siding is deteriorated on the surface, varies about 1/4" to 1" in depth; I believe it is called spalling (?). It is a 1955...
Replies: 7
Views: 740
Posted By beamhillrd

Thank you marksr. Erring on the side of caution...

Thank you marksr. Erring on the side of caution is the plan.
Replies: 7
Views: 740
Posted By beamhillrd

Thanks for all the repsonses. Very helpful.

Thanks for all the repsonses. Very helpful.
Replies: 7
Views: 740
Posted By beamhillrd

Help with dorm refrigerator transport

This concerns a new 4.4 cubic foot dorm refrigerator, still in box, to be transported to college in my SUV. In the box it is too large to stand upright in the SUV. When I picked it up at the store to...
Showing results 1 to 25 of 72
 


 
Forum Jump