Search: Posts Made By: Saurd
Showing results 1 to 25 of 55
Search took 0.01 seconds.
Replies: 7
Views: 566
Posted By Saurd

Thank you to all. Am off to Home Depot to get...

Thank you to all. Am off to Home Depot to get what is needed to install the vent.

Will get it dried out and then attack the mold.

Thanks again.
Saurd
Replies: 7
Views: 566
Posted By Saurd

Yes there is a bathroom venting directly into the...

Yes there is a bathroom venting directly into the attic which has increased in usage recently, that is the path I was on as well, just wanted to assure I was thinking on the right track. We do have...
Replies: 7
Views: 566
Posted By Saurd

Mold in attic

I live in Iowa. Have an attic space above the second story of my home which we use for storage. Noticed mold forming and moisture on the underside of the roof decking. Looking for a couple of...
Replies: 1
Views: 1,328
Posted By Saurd

04 Suburban Heater not working at idle

Our 04 suburban has shown this chronic issue. It will not kick out any heat to the cabin until we get moving or the engine is run at a higher RPM. The level of coolant is normal. Once we get going...
Replies: 13
Views: 1,957
Posted By Saurd

bleading it down did help and it is now kicking...

bleading it down did help and it is now kicking out colder air. the pressure is no at 30-35 range while it is running. At 100 degrees outside I am getting about 68 degree air out of the system at...
Replies: 13
Views: 1,957
Posted By Saurd

One additional question about the compressor...

One additional question about the compressor itself. I was told it is a cycling compressor that is not intended to come on and stay on. Is this the case?
Replies: 13
Views: 1,957
Posted By Saurd

Thanks Jim. I will give this a try this...

Thanks Jim.

I will give this a try this evening. It sounds logical to me.

have a great day.
Replies: 13
Views: 1,957
Posted By Saurd

I changed the compressor because it was leaking...

I changed the compressor because it was leaking around the front seal and the clutch went bad and was rubbing metal on metal.

the low side pressure while not running is in excess of 90psi. When...
Replies: 13
Views: 1,957
Posted By Saurd

the compressor was pre oiled. the first can of...

the compressor was pre oiled. the first can of 134 added had addional lube in it for the compressor. Then about 2 1/2 12 0z cans of 134A.
Replies: 13
Views: 1,957
Posted By Saurd

AC Compressor replacement 2000 Bravada

I replaces the compressor and receiver on the my 2000 bravada. I vacuumed the system with a electric vacuum pump and held it at 25 in hg to assure all connections were tight and get all the air out....
Replies: 8
Views: 4,697
Posted By Saurd

Thanks for the input. The battery is less then 1...

Thanks for the input. The battery is less then 1 year old and has been tested 3 times. the only reason I replaced the BCM was it was identified during my first round of testing as having the...
Replies: 8
Views: 4,697
Posted By Saurd

Thanks for the input I will try this. I was...

Thanks for the input I will try this. I was looking at the hot line and not the neg line. I was also using an induction meter at the time along with the other meter.

What is an acceptable draw?...
Replies: 8
Views: 4,697
Posted By Saurd

Battery Drain 2000 Bravada

I have a 2000 Bravada that is draining the battery while setting. Very difficult time locating the source of the drain. With an amp meter I have measured and pulled fuses one at a time to look for...
Replies: 1
Views: 1,270
Posted By Saurd

Exhaust fan in bathroom

I need to install an exhaust fan in a bathroom in a older home. The issues are I do not want to penetrate the roof and there house has no soffits. Getting out the wall will be difficult if not...
Replies: 4
Views: 8,522
Posted By Saurd

Thanks for all the responses they are all...

Thanks for all the responses they are all helpful, both in new ideas and assuring myself I have not overlooked the obvious, which happens, just ask my wife. Any way thank you. I have the tank out,...
Replies: 4
Views: 8,522
Posted By Saurd

Fuel pump replacement in 2001 Malibu

I need to replace the fuel pump in my 01 malibu and the tank is full of fuel. Of course I learned after some frustration there is a screen at the bottom of the fill tube preventing my siphon hose...
Replies: 6
Views: 945
Posted By Saurd

Thank you for your input. this is the one I have...

Thank you for your input. this is the one I have been looking at.

Thanks again.
Replies: 6
Views: 945
Posted By Saurd

Is there a brand you would recommend. And what...

Is there a brand you would recommend. And what should I expect to pay for them, I have seen them for anywhere from the $200 range to $600-$700 range.

Thanks,
Replies: 6
Views: 945
Posted By Saurd

2000 Bravada Suspension

I have a 2000 Bravada I would like to raise the rear suspension a bit. I tow a 12 ft trailer from time to time and it sags the suspension. I know there are several options out there just wondering...
08-20-10, 09:20 PM
Replies: 4
Views: 4,825
Posted By Saurd

I did find an approx match and have it installed...

I did find an approx match and have it installed and working. I did take some mods in the wiring and shortening the shaft.

Thanks for the response. I realize I am living on borrowed time with...
08-19-10, 04:50 PM
Replies: 4
Views: 4,825
Posted By Saurd

Old GE central air unit

I have an old GE central air unit, approx 30 years old, and the fan motor has went out. I am unable to spin the motor shaft. I am looking for suggestions on finding a replacement motor.

I have...
Replies: 2
Views: 747
Posted By Saurd

toyota Camry Transmission

My daughter recently backed into a 1998 toyota camry. She backed into the front end of the camry at a very low speed, neither car had even enough damage to smug the dirt off of the bumper of either...
Replies: 2
Views: 828
Posted By Saurd

I realize that. The second post was done in...

I realize that. The second post was done in error.

Sorry.
Replies: 4
Views: 1,722
Posted By Saurd

Thanks, the cruise control works fine. I was not...

Thanks, the cruise control works fine. I was not sure if they both used the same signal or not.

Any ideas on the best place to get the new instrument cluster.

Pretty sure I can handle the...
Replies: 2
Views: 828
Posted By Saurd

Laminate on Stairs

What is the best way to do a stair case with laminate flooring? What bull nose is recommended?

Thanks,
Showing results 1 to 25 of 55
 


 
Forum Jump