Search: Posts Made By: Nevar
Showing results 1 to 25 of 31
Search took 0.01 seconds.
07-17-20, 12:16 PM
Replies: 6
Views: 259
Posted By Nevar

Depends on the current wall thickness. Most...

Depends on the current wall thickness. Most Vinyl Replacement window are 3 1/4 3 3/8 The entire master frame needs to be supported.
Replies: 23
Views: 770
Posted By Nevar

Looks like A pic of an Old Merc ONE. or older. ...

Looks like A pic of an Old Merc ONE. or older. It is not an air bleed. That is the air vent when you re fill the gear case.
Replies: 8
Views: 632
Posted By Nevar

The past owner said it running low 60 mph at 8000...

The past owner said it running low 60 mph at 8000 rpm ? correct ?
Something very wrong here. Anyone else see it. ???
A big block factory 5200 to 5600 RPM . 6K maybe . 8k is way to much And...
03-11-17, 10:53 AM
Replies: 10
Views: 1,462
Posted By Nevar

Problem fixed. Want to thank all of you for the...

Problem fixed. Want to thank all of you for the help.
Brought in a Real Oil burner tech. Should have from the start. Rather than throw parts at it. [ my fault] A little knowledge is a bad...
03-09-17, 03:23 PM
Replies: 10
Views: 1,462
Posted By Nevar

Pic enclosed. Oil flow new filter --- new Rheem...

Pic enclosed. Oil flow new filter --- new Rheem pump --- to the honeywell electric oil switch ---
To the Gun housing to the nossle .
The Electric switch has 2 [two] black wires that go thru...
03-09-17, 12:52 PM
Replies: 10
Views: 1,462
Posted By Nevar

Is it possible That the electric Honey Well...

Is it possible That the electric Honey Well electric oil valve [ see top pic ] on my post # 3 is causing the intermittent flame out ? [ runs for a few minutes then seems to be starved for fuel] It...
03-08-17, 04:54 AM
Replies: 10
Views: 1,462
Posted By Nevar

That is beyond my knowledge. will have to call in...

That is beyond my knowledge. will have to call in a good tech.
Note Did it again [ flame loss] this morning. Wife turned down the T stat. I checked did not go into lock out.
Thank you
03-07-17, 04:18 PM
Replies: 10
Views: 1,462
Posted By Nevar

UP -date on intermittent lock out Old Oil /hot air /furnace

Furnace is 50 + years old, Burner head not as old.
Same oil line feeds Furnace and Water heater [ which works 100%] now have 1/4 tank of oil. Had not been cleaned or serviced for like 2/3 years,...
02-27-17, 09:24 AM
Replies: 10
Views: 1,462
Posted By Nevar

Question Intermittent Lock out. Oil hot air Honeywell

Have a very old Oil/hot air furnace. The Burner head is a Carbo Concord [sp?]
Not as old .
Had a problem with the R8184 G 4009 Honeywell going into lock out. Once/twice a day, then run for a few...
02-16-17, 11:59 AM
Replies: 11
Views: 929
Posted By Nevar

They are Aluminum [ or steel] Awning windows that...

They are Aluminum [ or steel] Awning windows that are very old. No chance of finding the hardware.
And if your gonna try to screw into the sash frames 90% sure you will crack or break the glass.
...
05-08-16, 11:50 AM
Replies: 4
Views: 932
Posted By Nevar

PJ Thanks I fished out the switch wires. As you...

PJ Thanks I fished out the switch wires. As you recommended. The door switch is odd [ I'm real handy at some electronics] It works in reverse of what I thought. Wires disconnected the light is...
05-06-16, 01:52 PM
Replies: 4
Views: 932
Posted By Nevar

Question Kitchen Aid gas oven door light switch

Model KGST307HBS8 ser#Imm2956346
I broke the door light switch by slamming the door [ moron] it is inside the stove. And the light stays on.
Top burners working, but oven bake/broil will not. ...
Replies: 9
Views: 3,279
Posted By Nevar

Have a Karcher 2500 psi. Did the same. Get a...

Have a Karcher 2500 psi. Did the same.
Get a new Unloader valve.
Replies: 2
Views: 598
Posted By Nevar

Check to see if the motor is getting power from...

Check to see if the motor is getting power from the switch[s]
If it is getting 12v. Your most likely look to replace the window lift motor.
Note sometimes it is easier to change the motor and...
Replies: 4
Views: 757
Posted By Nevar

I got Both valve stem-kits. Came with everything...

I got Both valve stem-kits. Came with everything , except the body, esc. plates and handles. $19.00 each. Works like a charm. THANK YOU
Replies: 4
Views: 757
Posted By Nevar

Thanks a Bunch. I will try it.

Thanks a Bunch. I will try it.
Replies: 4
Views: 757
Posted By Nevar

Shower Water temp. Changes

OK dumb question. I have a 2nd floor bath that the shower/tub is very rarely used.
The unit is a old [about 25 years] Kohler 3 piece Hot / divert er / cold.
The other day while I was in the...
Replies: 2
Views: 804
Posted By Nevar

Use carb/choke cleaner on the linkage. Remove...

Use carb/choke cleaner on the linkage.
Remove the plastic choke housing, clean in there
Something is binding
05-27-13, 11:08 AM
Replies: 10
Views: 8,375
Posted By Nevar

First Thanks to all. Dane So closed cell...

First Thanks to all.
Dane So closed cell foam, does not have to be sealed in Plastic [Blue board]
Found 2" at HD a yellow color foam with plastic on one side $40. each
Lowes 2" 4x8 white foam,...
Replies: 2
Views: 1,260
Posted By Nevar

Or use the spark plug socket with a wrench on the...

Or use the spark plug socket with a wrench on the end instead of a wrachet
05-24-13, 12:04 PM
Replies: 10
Views: 8,375
Posted By Nevar

Question Make an indoor hot tub cover

Have a older Cal spa [ don't buy one] 8x8 Hot tub in an enclosed Patio. The old cover is shot and very heavy for one person to move, even though it is cut in 2 4' sections. I want to make a cover...
07-15-12, 12:53 PM
Replies: 5
Views: 8,574
Posted By Nevar

I have a Cal Spa [ junk] Hot tub bought new...

I have a Cal Spa [ junk] Hot tub bought new about the same age as yours. I did all the work myself. It is semi enclosed in a screen/glass room.
Yours is wired wrong. It has to be on its own...
Replies: 2
Views: 783
Posted By Nevar

Can you get a "Line" wrench on the pipe fitting...

Can you get a "Line" wrench on the pipe fitting and another wrench on the black dryer fitting?
Replies: 2
Views: 1,211
Posted By Nevar

RJ beat to my first point. But also look to...

RJ beat to my first point.
But also look to see if the shift interrupter is working. [ kills the RPMs for a split second going into gear]
Long warm up I'd look at a thermostat
07-08-11, 02:20 PM
Replies: 3
Views: 1,052
Posted By Nevar

PV do yourself a big favor Stop right here ....

PV
do yourself a big favor Stop right here . Cheap HD and lowes windows are just that CHEAP junk.
First find a good window. Spend the time.
I can teach how to rip out an old wood DH in 15...
Showing results 1 to 25 of 31
 


 
Forum Jump