Search: Posts Made By: Akpsdvan
Showing results 1 to 6 of 6
Search took 0.03 seconds.
01-10-19, 11:39 AM
Replies: 6
Views: 750
Posted By Akpsdvan

With the culligan not pulling brine it is...

With the culligan not pulling brine it is possible that the injector is plugged or some thing is built up on it, the screen on the brine piston is dirty or the o rings on the brine piston are not...
02-22-15, 10:21 AM
Replies: 9
Views: 3,071
Posted By Akpsdvan

I am going to have too keep an eye open for that...

I am going to have too keep an eye open for that one, drain flow control. Culligan uses a larger one than fleck.
02-21-15, 10:34 PM
Replies: 9
Views: 3,071
Posted By Akpsdvan

When you put the injector back in , was it pushed...

When you put the injector back in , was it pushed all the way down into the tan holder? Was that holder pushed all the way into the valve body?

You said that you put a new main piston and seal...
02-21-11, 07:52 PM
Replies: 16
Views: 22,891
Posted By Akpsdvan

The brine piston is on the top half of the valve,...

The brine piston is on the top half of the valve, one can get to it by removing the so called back plate, there is a screw over at the top or just over the brine piston and then there are two screws...
01-12-11, 08:40 PM
Replies: 16
Views: 22,891
Posted By Akpsdvan

It is very noticeable when the water is getting...

It is very noticeable when the water is getting pulled out of the brine tank at .45gpm.... but if you had the line off and your finger or thumb was not getting pulled in big time or suction would not...
01-07-11, 11:05 AM
Replies: 16
Views: 22,891
Posted By Akpsdvan

The screen is mainly to help keep the injector...

The screen is mainly to help keep the injector clear.
Under that silver plate is the injector, there are 2 parts to it, the little blue or tan part that sets with in the larger.. if the little one...
Showing results 1 to 6 of 6


 
Forum Jump