Search: Posts Made By: sethuvs
Showing results 1 to 25 of 57
Search took 0.01 seconds.
06-30-09, 06:49 PM
Replies: 2
Views: 1,063
Posted By sethuvs

what pest leaves such thing in the yard.....

hello, since last week I have noticed yellow colored "vomit-type" patches in my mulch in the backyard. Its a gated community so it cannot be strange large animals. Also, i notice these patches...
Replies: 3
Views: 2,459
Posted By sethuvs

follow up

I found this link - Major Appliances: Timer control, timer control, set screws (http://en.allexperts.com/q/Major-Appliances-3603/Timer-control.htm#b)

This is exactly th problem I'm facing, similar...
Replies: 3
Views: 2,459
Posted By sethuvs

Lady Kenmore 90 series knob

We have a lady kenmore 90 series and the dial (setting time, etc.) lost its friction. That is, I can use a screw driver, key or something to press on the dial to rotate it. However, the knob doesn't...
12-27-08, 11:24 AM
Replies: 7
Views: 1,244
Posted By sethuvs

Thanks, for the reply. I am done with...

Thanks, for the reply.

I am done with re-insulating the attic above the bedroom. I see some difference but as Craig said, since there is a cold garage below I still have to fix that problem.
...
12-04-08, 06:32 PM
Replies: 7
Views: 1,244
Posted By sethuvs

basic rule for attic re-insulation

Our bedroom is very cold and room above the garage as well.
Our windows are slightly drafty - but insulating it didn't help. So I'm guessing its the attic insulation.

Do I have to remove the...
05-03-07, 05:33 PM
Replies: 4
Views: 793
Posted By sethuvs

re: patio weed

Dear All,

We have a interlocking concrete/brick paving stones patio. In between the bricks/stones we have weeds coming constantly. We don't walk around the patio much during the week. The only...
10-11-06, 09:29 AM
Replies: 2
Views: 1,486
Posted By sethuvs

Bees around our shrubs

All - we have quite a few shrubs in our garden (I think they are Arborvitae). I noticed that there are surrounded by Bees all the time. I read few threads relating to granular Sevin - can I spead...
Replies: 4
Views: 2,096
Posted By sethuvs

how do I go about removing the brushroll from the...

how do I go about removing the brushroll from the vacuum? Is it connected to the axle? is there a information website I can refer to since the manual gives no info on this.
how do I order brushroll...
Replies: 4
Views: 2,096
Posted By sethuvs

re: Kenmore vacuum motor

mrbizness1, the axle protruding from the motor was extremely hot. The belt is around the axle and the agitator. Within few minutes after I put a new belt on, I get a burnt smell and I notice that the...
Replies: 4
Views: 2,096
Posted By sethuvs

re: Kenmore vacuum motor

I have a 4 yr old kenmore upright (bag) vacuum. The belt breaks frequently, which I figured is due to the axle that gets heated. Otherwise, the vacuum is fine. My question is how easy is it to relace...
08-27-06, 08:45 AM
Replies: 8
Views: 1,273
Posted By sethuvs

weed problem

hello there!

I let the weed grow quite a bit in our house. Now, we got a landscaper to get the weed out and mulch the garden. I have few questions:
1) is this a good time to weed out and mulch -...
Replies: 9
Views: 1,326
Posted By sethuvs

Upstairs cooling/heating

Thank you all for your replies. I was the original post. I gather that the problem with air circulation in our house requires further evaluation.
I would like to clarify the problem with...
Replies: 9
Views: 1,326
Posted By sethuvs

Need more airducts

Our home is relatively new but we were surprised to see that each room has only one airduct (vent). This takes really long for room to cool/heat (esp. second floor). We were thinking of bringing a...
Replies: 2
Views: 2,518
Posted By sethuvs

re: Kenmore Progressive vacuum

All,

We have a 2000 model Kenmore progressive vacuum which has problems recently. I should say that it works fine but within 3-4 mins., I would get a burning smell. I changed the spare belt...
Replies: 4
Views: 1,387
Posted By sethuvs

similar problem

All,

I have a similar problem. Our house is abt 7 yrs old. I don't know if there is any warranty left. The room above the garage is the coldest room in our house. I just recently laid new carpets...
Replies: 1
Views: 1,702
Posted By sethuvs

mildew or mold in bathroom

hello all - happy holidays.

I recently noticed that our bathroom walls have some kind of mld or mildew formation. Its yellowish in color (fungi) and it appears as though several streaks of water...
Forum: Sports
11-27-05, 05:36 PM
Replies: 4
Views: 43,987
Posted By sethuvs

similar question - building a pool table

I have a dining table sitting around (60x40"). Its a good quality one made of oak but haven't been used for a while. I was wondering if I can purchase any pool top to go over this dinning table? I...
Replies: 8
Views: 1,277
Posted By sethuvs

I made a hole in the wall. I found the insulation...

I made a hole in the wall. I found the insulation sheets. I dropped all the wires, i.e., monster cables, power cord from the TV, audio wires, etc, through a hole in top. Fished them from bottom. My...
Replies: 1
Views: 879
Posted By sethuvs

does anyone have a solution to this problem?

does anyone have a solution to this problem?
Replies: 1
Views: 879
Posted By sethuvs

leak in the garage

After tropical storm Tammy, I noticed quite a bit of leak in the garage wall.
The downsprout exit is pitched at the top of first level and water flows over the shingles into the gutter. (pardon me,...
09-01-05, 07:06 AM
Replies: 1
Views: 791
Posted By sethuvs

re: separating light connections

I'm hoping this is a simple problem and can be resolved but need your advise.

I installed a motion detector light in front of garage. The switch is connected to three other lights outside our...
Replies: 8
Views: 1,277
Posted By sethuvs

Bob - thanks. Do I run a flexible pvc type tube...

Bob - thanks. Do I run a flexible pvc type tube inside the dry wall where I bundle all the wires together? or just make a hole in the wall (top) drop the wires and catch them from bottom? isn't there...
Replies: 8
Views: 1,277
Posted By sethuvs

Your question comes just in time... I just...

Your question comes just in time... I just purchased a SONY LCD and want to mount this in the wall but unfortunately, I'm afraid of two things (1) the LCD might fall if I don't mount right, (2) wires...
Replies: 2
Views: 773
Posted By sethuvs

re: plasma tv & home theatre

All -

I plan to purchase a SONY 42"plasma tv. I'd also like to purchase a 6.1 home theatre system.

Question is - how easy is it to install the TV on the wall? I'm afraid if it might fall if I...
08-05-05, 02:21 PM
Replies: 3
Views: 1,378
Posted By sethuvs

Thank you both for the advise. I'll keep you...

Thank you both for the advise. I'll keep you posted on the painting project.
Showing results 1 to 25 of 57
 


 
Forum Jump