Search: Posts Made By: adam09
Showing results 1 to 25 of 148
Search took 0.02 seconds.
Replies: 0
Views: 298
Posted By adam09

Question KitchenAid Water Dispenser Filter Issue

The water dispenser in my KitchenAid fridge recently started flowing to a trickle. When I take out the filter and use the bypass device the water flow is strong. However, I have tried two new filters...
07-26-12, 02:52 PM
Replies: 11
Views: 26,198
Posted By adam09

installing mounting block

When installing a mounting block, do I need to put j channel around it? I bought a super jumbo that will probably work.
07-23-12, 09:59 AM
Replies: 11
Views: 26,198
Posted By adam09

Thanks, not exactly what I'm looking for. I'm...

Thanks, not exactly what I'm looking for. I'm installing a range hood vent, which is larger and different than the bathroom vents.
07-23-12, 07:29 AM
Replies: 11
Views: 26,198
Posted By adam09

Question exhaust mounting question

I know this is an old thread, but am trying to do the same thing as original poster. I'm going the route of using a meter vinyl mounting block (since that's all I can find that will fit), but am...
07-23-12, 07:09 AM
Replies: 11
Views: 26,198
Posted By adam09

Question Advice for mounting exhaust vent

I am trying to install an exhaust vent for a microwave. The old vent does not match up, so I need to adjust the vent that is already on the outside of the house. I've decided to just rip that one...
Replies: 1
Views: 2,010
Posted By adam09

Unhappy Well, how about this - does anyone know the best...

Well, how about this - does anyone know the best way to raise the existing exhaust duct work that is going through the wall to the outside? There aren't any studs nearby, so I'm wondering what to do...
Replies: 4
Views: 6,726
Posted By adam09

They sell diy vent cleaning systems that involve...

They sell diy vent cleaning systems that involve hooking up a rod w/brush to a drill. I've used mine several times and they work fairly well. I bought it at a Big Box a few years back.

If your...
Replies: 1
Views: 2,010
Posted By adam09

Question Above Range Microwave Venting Size Issue

I am installing an above the range microwave to replace the existing one. The microwave vents to the back wall outside. The current hole for the old microwave vent fan is 3"x10" and is a little bit...
Replies: 2
Views: 6,338
Posted By adam09

Painting over Exterior Oil-based Stain

I recently stained some outdoor furniture with Cabot exterior semi-solid stain (oil-based), but don't like the way it turned out and would like to just paint over the stain to make it solid. What...
Replies: 3
Views: 7,015
Posted By adam09

Are the boots typically replaced when a roof is...

Are the boots typically replaced when a roof is replaced regardless of the type of boot (i.e. if a metal boot is on there, will it have to be replaced along with the roof even if in good condition)? ...
Replies: 3
Views: 7,015
Posted By adam09

Question Best material/method for repairing boots around vents

Multiple of the vents going through my roof have cracked rubber boots around them, which is causing leaks. I am getting contractor estimates, but wanted to get some opinions on the best solution. ...
Replies: 2
Views: 2,475
Posted By adam09

Question Possibility of resurfacing paver stones

I have a patio that is laid with concrete paver stones. It appears that the nice solid gray surface of the pavers is wearing down, which is giving way to a 'speckled' look on the surface (where you...
Replies: 1
Views: 980
Posted By adam09

Question Form for putting down paver stones?

I have a unique situation for an area where I want to put paver stones. The patio is at the bottom of some stairs, and in order to get the patio at the correct height, the soil will have to be...
Replies: 2
Views: 4,706
Posted By adam09

Question weight of crusher run

I need 12 cubic feet of crusher run for a stair landing at the bottom of my deck. How much would 12 cubic feet of crusher run weigh? There's a place that sells it at a flat rate based on whatever...
05-02-11, 07:13 AM
Replies: 1
Views: 3,209
Posted By adam09

Question Connecting PVC to Brass

I'm installing a brass backflow preventer on my irrigation system, and the other pipes are PVC.

How do I connect male PVC to female brass? Do I need any special fittings, or just screw the PVC...
03-22-11, 07:05 AM
Replies: 1
Views: 1,506
Posted By adam09

Hunter Irrigation Products

Any idea where I can purchase Hunter sprinkler heads? I can't find them in any big box stores, which is the only place I know to buy irrigation supplies around here (central Virginia).

Do the...
03-22-11, 06:04 AM
Replies: 2
Views: 1,573
Posted By adam09

If I put my sprinkler a foot from my mailbox,...

If I put my sprinkler a foot from my mailbox, then when the spinkler turns in line with the mailbox it would be as if I'm standing there holding my hand in front of the sprinkler.

This seems...
03-21-11, 06:49 AM
Replies: 2
Views: 1,573
Posted By adam09

Question Positioning sprinkler around mailbox

I am trying to re-do part of my irrigation system since there are about 7 sprinkler heads where I really only need 3. I'd like to put one in each corner of the yard next to the street, and a third...
Replies: 3
Views: 1,669
Posted By adam09

Cat6 worth effort to find?

I am looking to run some ethernet cable in my house to connect my Netflix enabled blu-ray player to the Internet. I can't find Cat6 cable anywhere (except online). Is there a big enough difference...
12-28-10, 09:52 AM
Replies: 5
Views: 6,023
Posted By adam09

Currently I have an outlet next to the electrical...

Currently I have an outlet next to the electrical that is for speaker wires - they're 6" apart (center to center).

Ideally I'd like to have one outlet for the speaker wire, coax, and cat6.
...
Replies: 5
Views: 21,163
Posted By adam09

rg6 vs. rg6 quad

Is it worth the trouble replacing rg6 cable with rg6 quad? Would I see any picture improvements in HD?
12-27-10, 02:29 PM
Replies: 5
Views: 6,023
Posted By adam09

Coax outlet proximity to electrical outlet

I am planning to move a coax outlet in one of my rooms, and the new location would put it fairly close to an electrical outlet. Are there any rules on how close a coax outlet can be to an electrical...
Replies: 6
Views: 3,266
Posted By adam09

Thanks for the advice... sorry to sound like a...

Thanks for the advice... sorry to sound like a jerk. :(
Replies: 6
Views: 3,266
Posted By adam09

YOu have to figure out of 47 views someone would...

YOu have to figure out of 47 views someone would have replied....
Replies: 6
Views: 3,266
Posted By adam09

Unhappy No one has ever put down a transition strip? Wow.

No one has ever put down a transition strip? Wow.
Showing results 1 to 25 of 148
 


 
Forum Jump