Search: Posts Made By: GEEVEE
Showing results 1 to 23 of 23
Search took 0.01 seconds.
11-14-11, 11:51 AM
Replies: 4
Views: 1,724
Posted By GEEVEE

Tempstar Furnace at Church

Grady - Thanks for your reply. I checked the setup at the church. There is only one transformer for both the cooling and heating side. The Rc and Rh are joined by a jumper at the thermostat. Some...
11-03-11, 12:48 PM
Replies: 4
Views: 1,724
Posted By GEEVEE

Tempstar Furnace at Church

Hello All: I can use some help diagnosing an issue with a Tempstar Furnance/Air Conditioner combo unit (NTC6) at my church. The unit was functioning fine for the last heating season. We have not...
01-12-11, 08:04 AM
Replies: 11
Views: 1,626
Posted By GEEVEE

Discussions with the Electric Company

All of you have provided very valuable information. I did not know that each account had an account Rep. We were just calling the toll free customer service number and each person/rep we were...
01-10-11, 06:39 AM
Replies: 11
Views: 1,626
Posted By GEEVEE

Understanding an Electricity Bill

Our Church just purchased a restaurant building and is in the process of converting it for use as a church. We got out first electricity bill and have several questions on the bill. I am posting a...
11-25-09, 07:34 AM
Replies: 4
Views: 2,912
Posted By GEEVEE

Additional Info

Jay: The Partnumber stamped on the Relay is correct. I found the attached wiring scematic behind the relay cover. I am hopeful that this can help you. It is a very old relay. I am pretty sure...
11-24-09, 07:35 PM
Replies: 4
Views: 2,912
Posted By GEEVEE

Additional Info

This is a heat only setup using radiators. No A/C.

GEEVEE
11-24-09, 07:09 PM
Replies: 4
Views: 2,912
Posted By GEEVEE

Help Replacing a two wire thermostat

I have 25 year old HydrothermH-25 boiler with single zone. It currently uses an analog two wire thermostat. I am trying to replace it with a Z Wave capable digital thermostat from Wayne Dalton. The...
Replies: 4
Views: 2,412
Posted By GEEVEE

I spoke to Rinnai Application Department. They...

I spoke to Rinnai Application Department. They have no issues with high temp hotwater feeding the Rinnai Input. The input temp is measured and Rinnai will fire only if the temp is less than the...
Replies: 4
Views: 2,412
Posted By GEEVEE

Solar Evacuated Tube Drainback Hotwater Heater Install

Thanks Xiphias for your response.

The whole system is a packaged unit from SunMax. It comes with the Collector, Storage tank with heat exchanger, drainback tank with site glass, Taco 007 pump...
Replies: 4
Views: 2,412
Posted By GEEVEE

Solar Evacuated Tube Drainback Hotwater Heater Install

Hello All: Many people helped me design a high efficiency boiler in October 2008. The system worked OK during the last heating season. I am on to my next project and would like your help and...
Replies: 3
Views: 2,201
Posted By GEEVEE

Stained Glass Windows at 150 Year Old Church

My Parish is in the process of renovating a 150 year old Church that we are buying. The Church has not been used for the last 15 years and some exrtensive repairs are needed before we can starting...
Replies: 3
Views: 970
Posted By GEEVEE

Varios Options

Rick: Thanks for the reply. I did not mean that I was using the two lines at the sametime for conferencing. I use a bridging service. With the two line phone I can be on a conference bridge for...
Replies: 19
Views: 8,528
Posted By GEEVEE

Problem Solved

NJ TROOPER was right on the money. I had the sensors crossed. The setup has been running fine for a week. Thanks for your help.

GEEVEE
Replies: 3
Views: 970
Posted By GEEVEE

Two line to single line switching

I have two lines coming into my house currently. I am using a two line cordless phone. Since I spent a lot of time on conference calls, I invested in a Plantronics Calisto phone with bluetooth...
Replies: 19
Views: 8,528
Posted By GEEVEE

Rbeck: Here is the thread on my installation. ...

Rbeck: Here is the thread on my installation.

http://forum.doityourself.com/boilers-steam-hot-water-systems/361568-boiler-piping-replacing-30-year-old-boiler.html

NJ Trooper: The purge tee...
Replies: 19
Views: 8,528
Posted By GEEVEE

Weil-Mclain Mod Con Boiler Locks Up

Just installed WM Ultra 3 105 boiler about three weeks ago. Things have been working fine for two weeks. However, in the last week the boiler locked up three times. The error message is "Supply too...
Replies: 27
Views: 18,062
Posted By GEEVEE

Why Tankless

I thought of adding the indeirect heater into the design. Then if my boiler fails, I have no heat or hot water. If the tankless heater fails, I can add an indirect any time since the piping is...
Replies: 27
Views: 18,062
Posted By GEEVEE

Final Installation Pictures

I am very happy to post some pictures of my completed installation. In summary, I replaced a 30 year old Slantfin conventional cast iron boiler (oh boy that weighed a ton !!!) with a Weil Mclain...
Replies: 41
Views: 11,303
Posted By GEEVEE

Where is the zone valve?

I like the pictures you posted. I am in the middle of an installation myself. Looking at your picture, I can't quiet make it out. Where is the zone valves connected to? On the supply header or the...
Replies: 27
Views: 18,062
Posted By GEEVEE

We are almost there !!!

We are allmost there!! I have made revisions based on all the feedback. I have incorporated the changes from NJ Trooper's simplified diagram into my original diagram. As mentioned in the previous...
Replies: 27
Views: 18,062
Posted By GEEVEE

Revisions to Piping

Hello All.

Thanks for all the feedback here. I have made several modifications. Main changes are using of zone valves instead of the circulators, removing the check valve from the boiler loop...
Replies: 27
Views: 18,062
Posted By GEEVEE

Thanks fo the reply. I appreciate your help. ...

Thanks fo the reply. I appreciate your help.
I will get the Ultra 105. I think in the long run that will same some dough.

Other comments and responses:

Nj Trooper

"I don't think you...
Replies: 27
Views: 18,062
Posted By GEEVEE

Smile Boiler Piping - Replacing 30 year Old Boiler

This is my first posting. I have been watching this site for the last several weeks and I need your valuable advice in validating the piping design that I am attaching here. I have done the...
Showing results 1 to 23 of 23


 
Forum Jump