Search: Posts Made By: midast
Showing results 1 to 7 of 7
Search took 0.01 seconds.
12-19-10, 06:09 AM
Replies: 11
Views: 1,699
Posted By midast

It is the time delay. When I take it out,...

It is the time delay. When I take it out, everything runs smoothly. I guess I mistakenly thought if I received current with it in line that it must be fine. Thanks for all your help with this.
12-18-10, 08:33 PM
Replies: 11
Views: 1,699
Posted By midast

I am obviously not very knowledgeable about...

I am obviously not very knowledgeable about electricity. I was under the impression that the contactor needed 24v to engage. It is engaging under the 9V from the battery test you suggested. Is the...
12-18-10, 08:07 PM
Replies: 11
Views: 1,699
Posted By midast

Had done that already from scanning through the...

Had done that already from scanning through the forum before posting. Did it again anyway just to make sure. Inside unit came on. Outside unit sparked at the contactor when the electricity was...
12-18-10, 05:57 PM
Replies: 11
Views: 1,699
Posted By midast

9V battery does pull the contactor.

9V battery does pull the contactor.
12-18-10, 05:47 PM
Replies: 11
Views: 1,699
Posted By midast

Coil voltage is 24v. Honeywell, Single Pole...

Coil voltage is 24v.

Honeywell, Single Pole 24 Volt Air Conditioner Contactor
Part #DP1030A 5013
12-18-10, 04:19 PM
Replies: 11
Views: 1,699
Posted By midast

Yes, I do have a time delay relay. At one point...

Yes, I do have a time delay relay. At one point I thought that was the problem. However, since I am getting enough current coming through with it in the loop I am assuming it is not. Is this a bad...
12-18-10, 02:38 PM
Replies: 11
Views: 1,699
Posted By midast

Contactor Issue

I recently replaced the fan motor that fried on my unit. When looking at the inside of the unit everything was very old and rusty so I replaced contactor, capacitor, and thermostat too. Worked...
Showing results 1 to 7 of 7


 
Forum Jump