Search: Posts Made By: Firenspeed
Showing results 1 to 10 of 10
Search took 0.01 seconds.
Replies: 2
Views: 635
Posted By Firenspeed

Venting/back up problem

I have an old home I'm working on. I removed a toilet that was in the basement. I put a test plug in the drain hole to seal it and keep out sewer gas (septic system). There is also a floor drain...
03-09-14, 07:42 PM
Replies: 13
Views: 4,460
Posted By Firenspeed

He tested it right at his truck. I could have...

He tested it right at his truck. I could have sworn we tested it in the well with the controller to make sure it worked even though we knew the pipes were frozen. As for the wires, geez, I think...
03-09-14, 11:13 AM
Replies: 3
Views: 685
Posted By Firenspeed

At this point, I'm hoping against hope. The...

At this point, I'm hoping against hope. The little room and the pipe are pretty warm. Granted, the sand under the garage is really damn cold, but every bit helps. If I can get it just a few...
03-09-14, 11:10 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

Good call on the capacitor. I watched a youtube...

Good call on the capacitor. I watched a youtube video and learned how to test. I have my old controller and the new one. The one loses voltage quickly (as a capacitor should) and the other does...
03-09-14, 10:20 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

It is a capacitor. I have a multimeter, but I'm...

It is a capacitor. I have a multimeter, but I'm not sure how to test a capacitor. Thoughts?
03-09-14, 10:00 AM
Replies: 3
Views: 685
Posted By Firenspeed

Frozen well line

I wasn't sure if I should post here or under "wells and pumps". I've had a lot of challenges with these frozen pipes. In a thawing effort, we caused a lot of other problems, but I'm down to this: I...
03-09-14, 09:52 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

Correction: The brand is VMC. Model 14940947. ...

Correction: The brand is VMC. Model 14940947. It replaced Franklin 2801074915.
03-09-14, 08:55 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

The new controller is a VSM. It is identical to...

The new controller is a VSM. It is identical to the old Franklin I replaced. There are no resets that I saw. I can't hear the pump run normally per se, other than to run out to the well pipe and...
03-09-14, 06:45 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

Pressure switch is closed. I didn't think the...

Pressure switch is closed. I didn't think the ground needed to be connected, but I can't figure out what's going on.

I turn the breaker on. Check voltage at switch and pump control. All good....
03-09-14, 06:15 AM
Replies: 13
Views: 4,460
Posted By Firenspeed

3-wire into 2-wire well pump

Hi Folks,

I've done some researching here and elsewhere concerning my topic, but I thought I'd run it by this group. I'm new to the site, but have been slowly increasing my DIY resume.

...
Showing results 1 to 10 of 10


 
Forum Jump