Search: Posts Made By: rupus2020
Showing results 1 to 21 of 21
Search took 0.01 seconds.
Replies: 7
Views: 1,297
Posted By rupus2020

A real hss bit will do fine if you use it right.A...

A real hss bit will do fine if you use it right.A cast bit cuts well,but prone to breaking in awkward position.You need two people with a squirt can with oil and drill large enough with alot of...
Replies: 3
Views: 971
Posted By rupus2020

Hve you tried no themostat?That would be one of...

Hve you tried no themostat?That would be one of my first steps.
Replies: 15
Views: 11,283
Posted By rupus2020

I would try a master cylinder first.Before you...

I would try a master cylinder first.Before you install it,bench bleed it first.Put some fluid in it and try to get a good firm "pedal".These things can be a booger to bleed.Hopefully,your slave...
Replies: 7
Views: 896
Posted By rupus2020

Flaky memory could also be a problem.Will it boot...

Flaky memory could also be a problem.Will it boot up in safe mode?
Also,make sure the processor fan is ok.Is it full of gunk,is it turning?
Replies: 16
Views: 1,114
Posted By rupus2020

I,being a family guy and bread winner went the...

I,being a family guy and bread winner went the easy way out.I bought a cheap fixer-upper 4-banger car and swallowed it.I was young once and had to have the latest and greatest,but wasn't getting any...
Replies: 4
Views: 1,486
Posted By rupus2020

Your truck should have the A-518 (46re).The 2nd...

Your truck should have the A-518 (46re).The 2nd gear band adjustment will be on the driver's side of the transmission.
Replies: 4
Views: 2,112
Posted By rupus2020

MAF will definitely cause those symtoms.Make sure...

MAF will definitely cause those symtoms.Make sure you have no leaks in the air filter assembly.I have found on GM MAFS,that it was not getting a good ground.Try finding a wire schematic and run a new...
Replies: 6
Views: 19,632
Posted By rupus2020

Most oem's use cheap hydraulic shocks that are...

Most oem's use cheap hydraulic shocks that are mushier.Gas shocks will be firmer,but perform better and safer.
Replies: 4
Views: 1,486
Posted By rupus2020

You may be able to adjust the second gear band to...

You may be able to adjust the second gear band to fix the slip,if the band is not completely shot.There is an external adjustment for it.You may want to purchase a manual before attempting it.They...
Replies: 6
Views: 1,331
Posted By rupus2020

Unless you have a lift and a good transmission...

Unless you have a lift and a good transmission jack,I wouldn't attempt it.This tranny is massive as well as the transfer case.I'm a 15 year transmission tech and I wouldn't attempt it.I have the...
Replies: 2
Views: 696
Posted By rupus2020

Check the throttle valve rod linkage.It connects...

Check the throttle valve rod linkage.It connects to the carb and down to the transmission.It may have came loose.It is held on by plastic grommets on each end that breaks.
Replies: 2
Views: 1,224
Posted By rupus2020

My parents have dark gray metal roof.I think it...

My parents have dark gray metal roof.I think it will match with about anything.
Replies: 46
Views: 35,480
Posted By rupus2020

Just make sure you have alot of spare...

Just make sure you have alot of spare differentials around.The high speed will smoke them out pretty fast.
Replies: 1
Views: 981
Posted By rupus2020

It should be counter-clockwise to loosen.I would...

It should be counter-clockwise to loosen.I would use a breaker bar and wedge it against the frame.Then bump the starter.This method has never failed me.
04-12-06, 08:56 PM
Replies: 44
Views: 11,915
Posted By rupus2020

A double barrel 12 guage is the best and easiest...

A double barrel 12 guage is the best and easiest protection.The shorter the better with buckshot.Always use gun safety,especially with kids around.
Replies: 3
Views: 1,532
Posted By rupus2020

The pledge squirt and mop stuff works here.No...

The pledge squirt and mop stuff works here.No oily residue.
Replies: 6
Views: 24,646
Posted By rupus2020

Old cunfusius carpenters say front wall first.

Old cunfusius carpenters say front wall first.
Replies: 7
Views: 1,294
Posted By rupus2020

It's a pretty redundant idea IMO.

It's a pretty redundant idea IMO.
Replies: 15
Views: 16,687
Posted By rupus2020

A compression check would help.The former owner...

A compression check would help.The former owner may have gotten starting fluid happy and bent a valve.
Replies: 6
Views: 1,172
Posted By rupus2020

I would load the hi-powered water gun with...

I would load the hi-powered water gun with bleach,soak,then rinse.Seriously,300 sounds reasonable,unless you just gotta have a real pressure washer.

the rubes
Replies: 6
Views: 5,525
Posted By rupus2020

Not trying to hijack a thread,but where is a good...

Not trying to hijack a thread,but where is a good online site to find parts for trimmer.My father-in-law gave me his dad's (now deceased) old t-20.I'm needing the fuel tank and air filter assembly.
...
Showing results 1 to 21 of 21


 
Forum Jump