Search: Posts Made By: Big Orn
Showing results 1 to 25 of 37
Search took 0.01 seconds.
Replies: 2
Views: 814
Posted By Big Orn

You could have a sticky door latch so we'll...

You could have a sticky door latch so we'll tackle that first. Get a can of WD40 with the tube inserted, spray it up into the door latch with one hand while you work the latch with the other. Might...
Replies: 5
Views: 865
Posted By Big Orn

Kathy, He's right - it's probably the COP (Coil...

Kathy,
He's right - it's probably the COP (Coil Over Plug), or maybe more than one. Thing is the boots are not made of very good rubber and will crack, causing a short - which will eventually damage...
Replies: 1
Views: 2,360
Posted By Big Orn

Found it. The motor connectors worked loose....

Found it. The motor connectors worked loose. Sounded just like something was flying apart inside the gearbox, though.

I guess that's what you get when you attach a heavy motor to a plastic...
Replies: 17
Views: 1,143
Posted By Big Orn

How did you choke it? Did you actually see the...

How did you choke it? Did you actually see the choke closing off the intake?

If you are getting fire to the plugs and gas to the cylinders, then you either have no compression or the timing is so...
Replies: 17
Views: 1,143
Posted By Big Orn

Maybe the choke isn't working... You can...

Maybe the choke isn't working...

You can have tons of fire and gallons of gasoline and too much air. Try choking the carb.
Replies: 1
Views: 2,360
Posted By Big Orn

Maytag MDB-5 Jetclean II - grinding noise

I have a Maytage Dishwasher that just started making a grinding noise. I have checked all rotating parts and all are free.

Any ideas?
Replies: 2
Views: 751
Posted By Big Orn

Sounds like your light switch, kc. What happens...

Sounds like your light switch, kc. What happens when you tap the dimmer switch? Sometimes the dimmer switches get a little rusty inside and short out.

But, I'll bet it's the light switch.
Replies: 1
Views: 2,101
Posted By Big Orn

It sounds like you may have one of two problems: ...

It sounds like you may have one of two problems:
(1) The mixing valve may be weak and not sealing after the solenoid de-energizes or you may have trash trapped in the valve itself. This allows the...
Replies: 6
Views: 1,445
Posted By Big Orn

Thanks for the help, Lugnut. :thumbup:

Thanks for the help, Lugnut. :thumbup:
Replies: 6
Views: 1,445
Posted By Big Orn

I can buy a universal kit for $27.50, which makes...

I can buy a universal kit for $27.50, which makes that $55 total for both assys. What do you think about the aftermarket kits, Lugnut?
Replies: 3
Views: 1,142
Posted By Big Orn

Russ, It's hard to tell, since we all have...

Russ,
It's hard to tell, since we all have different tolerances to odors, but I had to use vinegar in my old truck before I finally got rid of the undesirable odors. It took about a week of removing...
Replies: 6
Views: 1,445
Posted By Big Orn

Thanks, Lugnut. I have disconnected the...

Thanks, Lugnut.

I have disconnected the water lines and watched them dump into a glass. Water streams good, except it's just every other time. Cold water solenoid seems weak - I think I'll replace...
Replies: 6
Views: 1,445
Posted By Big Orn

Icemaker Acting Up

I apologize if this topic has been covered before, but I canít find a Search button...

I have a Frigidaire side-by-side Model #FRS26ZRFW3 with an icemaker. The trouble Iím having is that it only...
Replies: 2
Views: 1,107
Posted By Big Orn

Hello, omer :) Make sure your vehicle is...

Hello, omer :)

Make sure your vehicle is in gear (or park if auto transmission) and engage the parking brake. Chock all tires so that the vehicle can't roll forward or backwards.
At the rear of...
Replies: 3
Views: 1,641
Posted By Big Orn

Do they also replace the boots? If the boots are...

Do they also replace the boots? If the boots are not replaced when the COP (coil over plug) is replaced it can cause the new coil to fail. The rubber that these boots are made of are real cheap and...
Replies: 6
Views: 1,395
Posted By Big Orn

It does sound like the IAC valve.

It does sound like the IAC valve.
Replies: 5
Views: 870
Posted By Big Orn

What have you checked so far? Fuel pressure -...

What have you checked so far?
Fuel pressure - see if it's getting fuel - maybe hit the fuel reset button?
Check all wires and hoses, etc., that might have gotten against the block or heads and...
Replies: 3
Views: 1,067
Posted By Big Orn

Do you have a lift kit installed? Things to...

Do you have a lift kit installed?
Things to check:
(1) Ujoints (as you thought)
(2) Loose Ubolts on rear differential
(3) Loose transmission mount

If you hear it farther up front it could be...
Replies: 10
Views: 6,058
Posted By Big Orn

So, Capthook, did you ever find that post from...

So, Capthook, did you ever find that post from the dealer?

I would like to read it...
Replies: 6
Views: 1,386
Posted By Big Orn

I agree with easywind. If you want to take in...

I agree with easywind. If you want to take in more air (intake) you need to let more air out (exhaust)...like open headers on a race engine. K&N filters do not increase anything but the potential for...
Replies: 10
Views: 6,058
Posted By Big Orn

Where is your post from the dealership...? ...

Where is your post from the dealership...? :confused:
04-27-05, 09:07 AM
Replies: 7
Views: 20,176
Posted By Big Orn

The bracket that holds the guard over the blade -...

The bracket that holds the guard over the blade - the "L" shaped bracket - on some models is drilled off center. You can't do anything with the bracket itself, but you can elongate the holes in the...
04-27-05, 02:32 AM
Replies: 6
Views: 7,951
Posted By Big Orn

Thanks, dogman1953. So, it can be removed...

Thanks, dogman1953.
So, it can be removed without adverse affects?

Will the tile still have that "new" look?
04-21-05, 03:23 AM
Replies: 6
Views: 7,951
Posted By Big Orn

Let's say that he is... :eek:

Let's say that he is... :eek:
Replies: 4
Views: 8,570
Posted By Big Orn

Along the lines of what Dick posted: Is the...

Along the lines of what Dick posted:
Is the block cracked? Or was it caused by a baseball, for instance? If it was not due to stress then just get a ľĒ thick or so piece of lumber or plywood or...
Showing results 1 to 25 of 37
 


 
Forum Jump