Search: Posts Made By: LenIvy
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 9
Views: 23,543
Posted By LenIvy

31Ytech, When I had the cam off I didn't ...

31Ytech,
When I had the cam off I didn't
notice any other moving parts.
How can I check to see if the compression release is working. Where is it located or how can I get to it?
Replies: 6
Views: 1,148
Posted By LenIvy

flirty1, Thanks for the response, but no...

flirty1,
Thanks for the response, but no rubber burning. The machine will stop. It has to be reprogramed to start and then under a load it will stop again. Len
Replies: 6
Views: 1,148
Posted By LenIvy

Cheese and bonti, Thanks for the responses....

Cheese and bonti, Thanks for the responses. Weight is not and issue. It is my wife's tred and she used it before and she is around onefifty. I had the motor checked and is was a little questionable...
Replies: 9
Views: 23,543
Posted By LenIvy

Greetings, I tried the adjustments that you...

Greetings,
I tried the adjustments that you suggested and it made no difference. Thanks anyway. I was told by and engiine repair person that it is probably just tight and that I would have to try...
Replies: 9
Views: 23,543
Posted By LenIvy

31Yteck, Thanks for the info. I'll make the...

31Yteck,
Thanks for the info. I'll make the adjustment you sugested and let you know the results. Your help is appreciated.
Len
Replies: 9
Views: 23,543
Posted By LenIvy

Thanks for your replly. I believe that the Lady...

Thanks for your replly. I believe that the Lady ran the macnine low on oil and the shaft broke. I replaced it . I cleaned all of the matter of the inside. I coned the cylinder wall and replaced the...
Replies: 6
Views: 1,148
Posted By LenIvy

dc motor for treadmill

after programming my treadmill when I step on it the motor dies right down. I replaced the controller for the unit and I still have the same problem. Please help! Thanks, Len
02-07-08, 11:02 AM
Replies: 7
Views: 3,170
Posted By LenIvy

Follow your yellow wire to see if it goes to...

Follow your yellow wire to see if it goes to ground. If it does connect to the box. I am not familiar with yellow color. Usually ground is green. I hope this helps.
Replies: 9
Views: 23,543
Posted By LenIvy

briggs and stratton 28n707 15HP

Greetings, I am new to this site. I need some help. I replaced a connecting rod on this engine for my meighbor Lady. How do I make sure it is on time and That I put the two gears together correctly...
Showing results 1 to 9 of 9


 
Forum Jump