Search: Posts Made By: kish2554
Showing results 1 to 25 of 45
Search took 0.01 seconds.
12-28-17, 01:46 PM
Replies: 2
Views: 455
Posted By kish2554

The other question I had was....or do I dare...

The other question I had was....or do I dare trying to run 3 8ga wires and 1 10ga wire through that existing conduit? I know probably a horrible idea.
12-28-17, 10:36 AM
Replies: 10
Views: 796
Posted By kish2554

Yes, one should be your line in (line) and the...

Yes, one should be your line in (line) and the other should be other outlets downstream (load).
12-28-17, 08:45 AM
Replies: 2
Views: 455
Posted By kish2554

Advice on electrical service to shed

This is probably a topic that's been brought up over and over again...

I've dug trenches and buried conduit for outbuildings in the past -- installed subpanels to both my previous houses'...
10-05-15, 02:51 PM
Replies: 3
Views: 1,368
Posted By kish2554

I planned to keep the washer on the bottom either...

I planned to keep the washer on the bottom either way. It's just a matter of do I put it on the right and re-plumb, or do I put it on the left and re-duct and reroute electrical? I think my biggest...
10-05-15, 02:20 PM
Replies: 3
Views: 1,368
Posted By kish2554

Laundry Room Remodel Ideas? Where to stack?

My wife and I are about to remodel our bathroom, but looking for ideas. Currently, laundry room sits between our family room and garage with the two appliances facing each other. From the family...
Replies: 6
Views: 2,763
Posted By kish2554

Hello there, Spike, I looked at the routers...

Hello there,
Spike, I looked at the routers you suggested and I may try my hand at the RT-N56U. Honestly, high speed in wireless isn't all that much of a priority to me because all I use my...
Replies: 5
Views: 3,089
Posted By kish2554

Hello, I'm a line technician for the cable...

Hello,
I'm a line technician for the cable company in our area. What he's referring to "pairing" is called dynamic leveling. Basically the modem "listens" to different frequencies until if...
Replies: 6
Views: 2,763
Posted By kish2554

Router for DOCSIS 3.0 Ultra100 Internet service

Hello all :)

This isn't necessarily a problem I'm having, but rather an inquiry for advice on purchasing a new router. I recently had Internet service upgraded at my home to our company's...
11-12-11, 08:04 AM
Replies: 9
Views: 7,917
Posted By kish2554

Well, I'm going to do what I really don't want to...

Well, I'm going to do what I really don't want to have to do. The more and more I think about it, I might as well just take the wall back down, do it right -- once. Yesterday I went and bought some...
11-10-11, 06:25 PM
Replies: 9
Views: 7,917
Posted By kish2554

Well, when I had the copper piping, I never had...

Well, when I had the copper piping, I never had this issue. The only thing I could think of was that the ID was a little bit less. Yeah, it didn't make any sense to me either. If there's a way to...
11-10-11, 06:05 PM
Replies: 9
Views: 7,917
Posted By kish2554

I just want to make sure that I'm not going to...

I just want to make sure that I'm not going to have too much pressure on the diverter spout if I should happen to cut the shower off. Is that even a possibility? The CPVC should handle that much...
11-10-11, 05:19 PM
Replies: 9
Views: 7,917
Posted By kish2554

Back pressure on shower valve issue

Hello all,
I have a bit of a quirky issue that maybe someone can offer some assistance with. My bathroom has a typical tub/shower setup with a single knob shower valve, made by Price Pfister, I...
Replies: 5
Views: 11,466
Posted By kish2554

Well, will I be able to reuse the existing drain...

Well, will I be able to reuse the existing drain then? Just attach the new overflow assembly to the pipe? Any recommendations?
Replies: 5
Views: 11,466
Posted By kish2554

Well, I can access the drain if I need to cut a...

Well, I can access the drain if I need to cut a hole in the adjoining wall, but what I'm concerned with is can I use the existing drain, or do I need to rip out the one and replace it?
Replies: 5
Views: 11,466
Posted By kish2554

Replacing a tub on a slab, in an alcove

Hello everyone!
I'm about to take on a task that has been having me concerned about what I'm getting involved in for quite some time. I've been hesitant to do this because my concern is that...
05-02-11, 08:31 PM
Replies: 3
Views: 1,567
Posted By kish2554

Dishwasher tail piece? Should I use one...

Dishwasher tail piece? Should I use one continuous piece from the dishwasher to just before the p-trap? My plan was to put a wye just below the sink drain, before the P-trap and attach the...
05-02-11, 02:07 PM
Replies: 3
Views: 1,567
Posted By kish2554

Drain for dishwasher

Hello all!
I know that I've questioned this a while ago, but have a slightly different scenario. This also seems to be a pretty common question, but nobody's really been able to answer what I...
01-22-11, 11:03 AM
Replies: 3
Views: 4,797
Posted By kish2554

Building a multi-purpose storage shed

Hello all!

Well, it's time for a new project. Have been wanting to do this for a while now, but really haven't had the means or drive to do so. Anyways, I am wanting to build a storage shed...
12-18-10, 01:48 PM
Replies: 7
Views: 1,248
Posted By kish2554

Well, if I'm already going to pull cable anyways,...

Well, if I'm already going to pull cable anyways, and install a double pole breaker, would it HURT to install say a 60 amp rainproof sub panel on the building, that could also double as a cutoff? I...
12-18-10, 09:21 AM
Replies: 7
Views: 1,248
Posted By kish2554

Wiring to shed & limit on amount of subpanels

Hello everyone and happy holidays!

I'm back with yet another question about a pending / ongoing project with my house out in the North Fort Worth, TX area....

This spring, when the...
12-13-10, 05:08 PM
Replies: 6
Views: 5,630
Posted By kish2554

There is no garbage disposal to worry about, and...

There is no garbage disposal to worry about, and I do not have any way of running the piping underneath, unless I'm to tear up the slab. That's not going to happen. As far as the airgap, can you...
12-10-10, 08:24 PM
Replies: 6
Views: 5,630
Posted By kish2554

Plumbing for dishwasher in cabinet?

Hi there,
I had planned on installing a built-in dishwasher in the space just to the right of my sink in my kitchen, but unfortunately I'm not able to get the cabinets out. Therefore, my only...
Replies: 6
Views: 3,659
Posted By kish2554

I already have the dishwasher. It was one...

I already have the dishwasher. It was one purchased for a different house but never got installed. So buying a new one isn't an option. The house is on a slab, so running anything underneath isn't...
Replies: 6
Views: 3,659
Posted By kish2554

It WAS spaced out, but apparently it truncates...

It WAS spaced out, but apparently it truncates all unnecessary spaces in postings :(
Replies: 6
Views: 3,659
Posted By kish2554

Options for installing a dishwasher (cringes...)

Hello all!
I've never posted on this forum before, but am on the electrical one quite often. Have a situation that I can't imagine has NEVER been attempted before. Here's the scenario. My...
Showing results 1 to 25 of 45
 


 
Forum Jump