Search: Posts Made By: stairguy
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Replies: 4
Views: 4,525
Posted By stairguy

What part of Texas? Most of the companys that do...

What part of Texas? Most of the companys that do ornimental wrought iron wont do wood railing. Mostly because they are just two diferent craftsmen. The wood guys usually cant do any more than just...
Replies: 21
Views: 14,529
Posted By stairguy

You CAN do it with a poket knife if you really...

You CAN do it with a poket knife if you really want to, but you will be wasting the worlds time if you do it with anything but a miter box
Replies: 4
Views: 5,548
Posted By stairguy

so far you have been given good info. Don't for...

so far you have been given good info. Don't for get to allow for carpet or what ever type of flooring you will be using. Also, to keep from cutting up alot of lumber, you can use a story line. Cut a...
Replies: 3
Views: 1,209
Posted By stairguy

I think a ring roll bender will do the trick....

I think a ring roll bender will do the trick. E-bay has a VERY cheap manual one for sale all over (tool america). Has any one used this, is it worth a damn. It is A LOT cheaper than any thing else...
Replies: 7
Views: 14,484
Posted By stairguy

If it is only the molding part it is easy to...

If it is only the molding part it is easy to replace. You will have to cut the caulk line (both at the wall and were the molding meets the jamb)with a razor knife. Simply pry it off. Try to not...
Replies: 2
Views: 1,359
Posted By stairguy

What are you trying to do? Do you allready have...

What are you trying to do? Do you allready have rail and you want to remodel?

You might want to hire a stair specalist. It can be a big job even for an experienced carpenter
Replies: 2
Views: 2,328
Posted By stairguy

Depending on the shape of your stair, you will...

Depending on the shape of your stair, you will have to support your hand rial with newel post. They can be attached to the front of the step with long screws or lags and then plug the holes with wood...
Replies: 3
Views: 1,209
Posted By stairguy

curved railing

I'm trying to figure out the best way to make large radius curves in flat stock (the hard way), channel, and railing. Not tube. I think that most benders are for putting tight bends in tube. Even if...
Showing results 1 to 8 of 8


 
Forum Jump