Search: Posts Made By: Drangd
Showing results 1 to 8 of 8
Search took 0.01 seconds.
10-19-20, 01:44 PM
Replies: 3
Views: 132
Posted By Drangd

Smaller gennys are a lot rpm driven for voltage...

Smaller gennys are a lot rpm driven for voltage regulation. What I would do is put a VOM like my Fluke 87 and run it on min then max for about 20 minutes each. See what the gen is producing UNDER A...
10-19-20, 01:17 PM
Replies: 44
Views: 1,100
Posted By Drangd

Unfortunately it is a crap shoot. I once...

Unfortunately it is a crap shoot. I once purchased a male Samoyed for my wife to show. Nikki was close to standard and was a typical male. As he got older say about 3 he started to be come...
09-23-20, 03:39 PM
Replies: 4
Views: 162
Posted By Drangd

A quick search on the internet and I am more...

A quick search on the internet and I am more confused now than when I read your post. I did not find any display panels on the air handlers. Are you reading this on the Trane control/thermostat

I...
09-21-20, 09:34 AM
Replies: 3
Views: 168
Posted By Drangd

Line surges from the generator? How is that...

Line surges from the generator? How is that going to happen? The generator regulates voltage and amperage internally. The only way to get a surge is for the controls on the generator to go bad. ...
Replies: 18
Views: 453
Posted By Drangd

When this happened to me from lightning strike...

When this happened to me from lightning strike near by. I found it was easier and less expensive to change the unit out than to purchase replacement parts from the mfg. The mother board alone was...
08-03-20, 09:03 AM
Replies: 6
Views: 279
Posted By Drangd

I do not have a Nest but when I changed my unit...

I do not have a Nest but when I changed my unit out my Venstar t stat REQUIRED a constant hot. Which most of the older single stages t stats did not require. Check behind the t stat and see if you...
08-28-19, 02:40 PM
Replies: 3
Views: 448
Posted By Drangd

This is not something I would do. Cutting the...

This is not something I would do. Cutting the concrete shell on a pool is just asking for trouble once the water is replaced.
As an alternative I would dig down on the side of the pool and put your...
06-24-19, 08:50 AM
Replies: 7
Views: 542
Posted By Drangd

The home inspector is confusing the issue. When...

The home inspector is confusing the issue. When was the house built? Was it wired correctly THEN? Trying to enforce new codes on old systems is the mark of an uninformed person who is trying to be a...
Showing results 1 to 8 of 8


 
Forum Jump