Search: Posts Made By: Houston204
Showing results 1 to 25 of 200
Search took 0.02 seconds.
07-03-20, 11:58 PM
Replies: 3
Views: 161
Posted By Houston204

Posting a picture of the new relay (as wired) may...

Posting a picture of the new relay (as wired) may be of assistance.
It might be as easy as moving a wire.
...
07-03-20, 11:52 PM
Replies: 9
Views: 417
Posted By Houston204

If you post another picture from a little further...

If you post another picture from a little further back we can see if you have a pressure switch.
( If the brown and blue wires running to the right in your pic connect directly to the wire nuts...
07-03-20, 07:01 PM
Replies: 2
Views: 266
Posted By Houston204

?

That zone control board might not be the best option for your setup.
I see that you are giving the zone control input tp the HZ432 but you have nothing connected to the output options.
The output...
04-02-20, 07:31 PM
Replies: 10
Views: 305
Posted By Houston204

https://www.doityourself.com/forum/thermostatic-co...

https://www.doityourself.com/forum/thermostatic-controls/538501-lennox-36g7001-replacement-honeywell-rth6450.html

Looks like V and Vr is the same as Rc and R.
The strangest part is that M is the...
04-02-20, 07:24 PM
Replies: 3
Views: 375
Posted By Houston204

Unless you can post the actual wire connections...

Unless you can post the actual wire connections before and after the last service call it would be difficult to guess.

We would need to know the thermostat in use, the heat pump, and the air...
03-12-20, 10:51 PM
Replies: 13
Views: 585
Posted By Houston204

A compressor blanket would probably reduce the...

A compressor blanket would probably reduce the noise.
Your neighbor might be more inclined to install it if you offered to purchase it.

Looks like they run around $60 but you would need to know...
03-12-20, 10:43 PM
Replies: 4
Views: 409
Posted By Houston204

You can't remove the white wire from that...

You can't remove the white wire from that thermostat. It isn't Electric heat control as with most other models. It is 24VAC common.

The 10 second push of "Advanced" would get you to the equipment...
03-06-20, 07:29 AM
Replies: 7
Views: 330
Posted By Houston204

Where do you see this water? AC primary...

Where do you see this water?

AC primary drains usually pipe into the plumbing under a bathroom sink. It would be difficult to notice the temperature?

Air conditioner secondary drains usually...
02-16-20, 10:04 AM
Replies: 20
Views: 5,386
Posted By Houston204

Wait usually tells me that you have a low voltage...

Wait usually tells me that you have a low voltage short.
Do you have a heat pump?
Does this problem occur in heat mode or cool mode?
01-26-20, 07:25 PM
Replies: 24
Views: 557
Posted By Houston204

C is the big light gray wire under your thumb in...

C is the big light gray wire under your thumb in the picture that you posted.

The AC condenser connects to stat Y and air handler C so you will end up with 2 wires connected to the air handler C.
01-21-20, 11:10 PM
Replies: 15
Views: 529
Posted By Houston204

If the damper is running on a separate...

If the damper is running on a separate transformer you want zone 2 stat common to connect to the damper transformer and zone 1 common to connect to the furnace transformer.
01-21-20, 07:46 PM
Replies: 2
Views: 315
Posted By Houston204

The Carrier Infinity heat pump may be able to...

The Carrier Infinity heat pump may be able to work with a non communicating thermostat but you will need to move around some wires at the air handler and outdoor unit. You may also need to pull more...
01-21-20, 07:36 PM
Replies: 15
Views: 529
Posted By Houston204

https://customer.honeywell.com/resources/Techlit/T...

https://customer.honeywell.com/resources/Techlit/TechLitDocuments/71-0000s/71-3201.pdf

It looks like the damper will only open if zone 2 has a demand. I would measure the heat rise across the...
01-21-20, 07:21 PM
Replies: 15
Views: 529
Posted By Houston204

Can you drive that damper open and close to...

Can you drive that damper open and close to verify that it works?
01-19-20, 07:29 PM
Replies: 15
Views: 529
Posted By Houston204

Do you get any error codes at the furnace when...

Do you get any error codes at the furnace when this problems occurs?
This sounds more like a furnace issue. I would expect pressure switch or flame sensor issues.
01-19-20, 10:52 AM
Replies: 8
Views: 521
Posted By Houston204

It looks like you had a thermistor (soft start...

It looks like you had a thermistor (soft start kit). Those things often melt in half when they fail. They are junk. Unwire it to allow operation until you can buy a hard start kit.
01-16-20, 10:45 PM
Replies: 3
Views: 320
Posted By Houston204

https://www.amazon.com/Honeywell-YTHX9421R5127WW-P...

https://www.amazon.com/Honeywell-YTHX9421R5127WW-Prestige-Internet-Thermostat/dp/B00OZXEEG4/ref=sr_1_2?crid=1WY9IOVIAJMWR&keywords=prestige+iaq+thermostat+kit&qid=1579243317&sprefix=prestige+iaq%2Cele...
01-07-20, 07:23 PM
Replies: 8
Views: 484
Posted By Houston204

If you post the make and model number of your air...

If you post the make and model number of your air handler I may be able to show you the page in the manual that states that a P-trap is required.
01-07-20, 07:19 PM
Replies: 24
Views: 2,218
Posted By Houston204

I install Honeywell duct sensors to duct board...

I install Honeywell duct sensors to duct board ducts with silver foil duct tape.

I get them with the Prestige IAQ. How are you planning on wiring 2 sensors to your thermostat? Your stat only...
01-05-20, 10:30 AM
Replies: 8
Views: 484
Posted By Houston204

I see the drain under the deck but I don’t see a...

I see the drain under the deck but I don’t see a trap.
Can you see if the drain drops into an open plumbers hub or does it have a ridgid drain connection between the 3/4” and the 1-1/2” hub?
01-05-20, 10:22 AM
Replies: 2
Views: 250
Posted By Houston204

Did you configure the new thermostats for heat...

Did you configure the new thermostats for heat pump operation?

Are you looking at the “Conventional” or “Heat Pump” terminals on the TH6220?

It sounds like you are looking at the conventional...
01-05-20, 07:30 AM
Replies: 2
Views: 240
Posted By Houston204

The most common failure is the dual capacitor in...

The most common failure is the dual capacitor in the outdoor unit.

Does the outdoor compressor sound like it is running?
01-04-20, 06:15 PM
Replies: 8
Views: 484
Posted By Houston204

When the cooling coil is located in the negative...

When the cooling coil is located in the negative air side of the blower a P-Trap is required to prevent the blower from pulling in air through the drain.

Is that air handler sitting on a wooden...
01-04-20, 11:21 AM
Replies: 4
Views: 275
Posted By Houston204

I only buy the THX9421 unless I am trying to...

I only buy the THX9421 unless I am trying to match other stats on the same wall.

I like the data logging and the ability to see how much the equipment is heating or cooling my air from the...
01-03-20, 06:20 PM
Replies: 1
Views: 224
Posted By Houston204

12 is the code you get when you reset power. ...

12 is the code you get when you reset power.



41 is a bad sign. It sounds like it may be time for a new motor.

If you are not tripping a door switch or flipping off and on the power switch...
Showing results 1 to 25 of 200
 


 
Forum Jump