Search: Posts Made By: donnyjay
Showing results 1 to 25 of 48
Search took 0.01 seconds.
Replies: 10
Views: 1,134
Posted By donnyjay

Ford Super Duty is possessed

This is a '98 Ford Super Duty Mini Motorhome. V-10 gas and it does have hydra boost.
Drives as if it has a computer that is sending mixed signals thru the power steering system. Drive down the...
Replies: 10
Views: 1,134
Posted By donnyjay

97 E350 is possessed

While driving this mini m.h. the steering wheel will move to the right and left by itself. As if someone was sitting in the right seat and had a hand on the wheel. Low speed or any speed, doesn't...
Replies: 3
Views: 2,202
Posted By donnyjay

kitchenaid dishwasher door latch broke

Where is the model number? Inside the machine? Can't even pull the machine out as it is screwed to the counter top. This is the style with the handle that pulls up. Suggestions? Big pry bar?
Replies: 3
Views: 2,202
Posted By donnyjay

Kitchenaid dishwasher door latch broke

How can I get the door open? I was able to remove the lower front panel. Thinking I could reach up inside with a hook and a flashlight and pull on the latch. Maybe if I could find a picture of the...
Replies: 2
Views: 1,102
Posted By donnyjay

Bad case of the barnacles

If you leave your boat in the water in Florida for three weeks it will be really covered with barnacles. I used my power washer to knock off the big chunks. Who has the magic solution for getting off...
01-22-07, 04:58 AM
Replies: 3
Views: 967
Posted By donnyjay

No water in the pressure tank

The set up I have here in Florida is a pump in the well, another pump at the house next to the aerator and water softner and two pressure water tanks. I shake the tanks and they feel like there is...
Replies: 3
Views: 3,020
Posted By donnyjay

powerwash stucco with what before painting

Going to paint my Florida house. What should I wash the stucco with. Bleach, white vinegar, dish soap??? The power washer has an attachment I can use to syphon the wash solution right from a bucket....
12-26-06, 05:25 AM
Replies: 1
Views: 738
Posted By donnyjay

poly or pvc?

Why do the irrigation guys use pvc in Florida and not poly? I am getting ready to do a small sprinkler installation at my house here in Florida. The ones I have done before in Michigan I have used...
08-29-05, 05:09 PM
Replies: 1
Views: 1,271
Posted By donnyjay

Rainbird valve

When the controller tells the valve, #6 to open it doesn't move. If I open the bleeder the water starts to flow to the sprinkler heads.
When the system is going from one zone to the next and it gets...
04-03-05, 03:37 AM
Replies: 3
Views: 2,809
Posted By donnyjay

XPS is what it will be. Thank you so much for the...

XPS is what it will be. Thank you so much for the well thought out information.
04-02-05, 01:06 PM
Replies: 3
Views: 2,809
Posted By donnyjay

How thick is the insulation under the vinyl?

Going to strip the cedar shakes, wrap the house with tyvek, nail on 4x8 sheets of insulation. What thickness of insulation board do you suggest using under the vinyl siding?
If the walls turn out...
Replies: 10
Views: 1,286
Posted By donnyjay

I/o or OB?

Hurricane Charley blew my boat away. Now I have to decide if I want an I/O or outboard for the new boats I have been looking at. Don't really understand the pros and cons of the two. Any suggestions?...
Replies: 2
Views: 4,195
Posted By donnyjay

9X7 overhead door

What would the rough opening size be for a 9'X7' overhead door?
Replies: 1
Views: 2,517
Posted By donnyjay

will angle iron support brick?

Building a garden shed that is 8'x8'. I was thinking about putting a short brick wall, maybe 3' high, across one side. If I attach a 4"x3" piece or angle iron to the 2X6 that is setting on the ground...
04-05-04, 06:06 PM
Replies: 4
Views: 1,222
Posted By donnyjay

Thank you. I will let you know in a couple days.

Thank you. I will let you know in a couple days.
04-05-04, 05:52 PM
Replies: 4
Views: 1,222
Posted By donnyjay

text the pressure?

What does that mean, text the pressure?
04-05-04, 05:08 PM
Replies: 4
Views: 1,222
Posted By donnyjay

Temp & pressure relief valve

My Bradford White 50 gallon gas water heater is 3 years old. What is causing it to over heat and start dumping water out the relief valve?
Thank you for the advise.
Replies: 2
Views: 912
Posted By donnyjay

need to vent the attic

One part of this house in southwest Florida has a gable roof and the other part has a hip roof. No vents in the roof, but it does have vented soffit all the way around. Looking for suggestions on the...
01-02-04, 05:01 PM
Replies: 6
Views: 7,402
Posted By donnyjay

eggshells in septic system?

Is it acceptable practice to run eggshell through the garbage disposal and into the septic tank system?
12-28-03, 04:26 AM
Replies: 1
Views: 862
Posted By donnyjay

wet saw?

Getting ready to purchase a good wet saw. Being I will be setting tile of maybe 18 to 20 inch square I was wondering about a wet bridge saw. Never tried one, but they look like they would work real...
12-08-03, 01:55 PM
Replies: 1
Views: 1,304
Posted By donnyjay

one piece decorative floor plate?

I am installing a claw tub and the drain and supply lines are on the end and face toward the center of the bathroom. You can look directly at them when you walk in. I should have purchased a carbide...
12-06-03, 05:02 AM
Replies: 4
Views: 9,805
Posted By donnyjay

electrical to dock and boat lift

Hello from Florida.
New boat lift is installed and now I need to run wire underground to the motor.
My first problem is that the 150A Fereral panel I have is full of breakers. Install a sub panel?...
Replies: 4
Views: 2,580
Posted By donnyjay

Hi Greg: This building is an old five story...

Hi Greg:
This building is an old five story apartment building. The roof has clay tile going up from the gutter to the top of the parapet. We are going to tuck the copper up under the tile and...
Replies: 4
Views: 2,580
Posted By donnyjay

cleaning copper gutters for solder

The copper gutters have been on this building since the 1920's. So you can imagine how oxidized they are. The owner wants to cover the gutters with a sheet of copper by tucking the one edge up under...
07-15-03, 04:37 PM
Replies: 1
Views: 760
Posted By donnyjay

strip porcelian inside claw tub?

Have an old claw tub that has a real rough interior. Part of the porcelian is gone on about half the bottom. I sandblasted the exterior and that cleaned up real well. Is there is a slick way to...
Showing results 1 to 25 of 48
 


 
Forum Jump