Search: Posts Made By: shelbyscott
Showing results 1 to 19 of 19
Search took 0.01 seconds.
Replies: 13
Views: 2,934
Posted By shelbyscott

dumb

my bad sorry i had the same problem on a JD 214 i didn't
read the elctronic ign part sorry
Replies: 13
Views: 2,934
Posted By shelbyscott

kohler

check your points and condensor
Replies: 40
Views: 47,102
Posted By shelbyscott

switch

it is the ignition switch does it have a anti-backfire solinoid?
the switch is making that solinoid shut down that was my experiance
Replies: 5
Views: 1,553
Posted By shelbyscott

brigg's

i figured it out thanks
Replies: 5
Views: 1,553
Posted By shelbyscott

17.5 intec briggs

Model 31C707 0026G1 080205ZD according tp the briggs website this engine is a "gravity fed" system so it cannot be used for a remote gas tank. Question: the engine that i have has the optional...
Replies: 5
Views: 1,553
Posted By shelbyscott

wiring

tractor: Craftsman 917270940
old motor:20 hp briggs 461707
new motor: 17.5 hp 31C707 0026G1
wires from tractor orange/blue/black/red looped
wires on new motor grey&black together
red (spaded)...
Replies: 5
Views: 1,553
Posted By shelbyscott

brand new brigg's 17.5 hp won't start

the tractor had a 20hp twin briggs 461707 I/C it threw a rod so instead of getting a shortblock i went to runnings and got
a new off the shelf 17.5 brigg's I/C single cylinder. everything
bolted up...
Replies: 14
Views: 21,679
Posted By shelbyscott

dead man's bail

i bet the cable that is hooked onto the dead man's bale is stretching
and shutting it off??
Replies: 21
Views: 7,436
Posted By shelbyscott

craftsman 19.5 briggs twin

Same exact deal with a rider i worked on replaced everything except
coil(s) i thought that i had it licked when we replaced the top end of
the carb (4 screw) what a crappy carb no adjustment not...
Replies: 4
Views: 846
Posted By shelbyscott

3.8

it was the key thank you and GOD Bless
Replies: 4
Views: 846
Posted By shelbyscott

3.8 HP Techumseh

what causes a black poof of smoke from the carb
and a yank back sensation when pulling the starter
rope??
Replies: 3
Views: 855
Posted By shelbyscott

thanks

maybe i will just put a briggs on the darn thing :)
the only thing GOLD about this engine is the trips
to the repair shop..
Replies: 3
Views: 855
Posted By shelbyscott

Craftsman II rider

Here is my problem: it is a tech 12.5 "Gold" engine it is leaking oil somewhere
i replaced the OHV cover gasket it drips oil on the drive belt just enough to
make the belt slip and when it hasn't...
Replies: 3
Views: 1,259
Posted By shelbyscott

snowblower

the carb bowl probley has junk in it varnish etc
un-bolt the nut that holds the carb bowl on then
clean that nut it has holes in it call jets put a small
wire through theses holes and re assemble...
Replies: 4
Views: 902
Posted By shelbyscott

Just put a in line fuel shuy off valve less than...

Just put a in line fuel shuy off valve less than $5.00 YOU'LL
be glad you did

have a nice day
Replies: 1
Views: 1,493
Posted By shelbyscott

john deere RX 75

Does anyone know if you can get a recoil starter for a
vertical shaft 9HP kawasaki engine-mine has electric
start but would sure like a back up pull starter thanks
Replies: 13
Views: 1,586
Posted By shelbyscott

no start

ya must have a jet that is still plugged is the jet on the bowl nut or the carb stem (where the float is?)
Replies: 13
Views: 1,586
Posted By shelbyscott

carb

i have chased my tail afew times clean the carb then realize the gas in the tank is stale that stinks and so does the bad
gas just my 2 cents
Replies: 15
Views: 16,736
Posted By shelbyscott

kawaski

it's the plug trust me
Showing results 1 to 19 of 19


 
Forum Jump