Search: Posts Made By: tspence
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Replies: 10
Views: 198
Posted By Zorfdt

For what it's worth, I just installed 4, 4"...

For what it's worth, I just installed 4, 4" recessed fixtures in a 15x15 open kitchen/dining room. I was a bit concerned if it would be sufficient, but it's certainly bright enough. They do kick...
Replies: 10
Views: 198
Posted By Pilot Dane

For brightness you need to consider where you are...

For brightness you need to consider where you are using the light. In a room with high ceilings it will provide less light at floor level than it does in a room with lower ceilings. 1'100 lumens...
Replies: 17
Views: 493
Posted By Bob14525

The cable that you're missing is the data cable. ...

The cable that you're missing is the data cable. I looked at a picture of your motherboard, and unfortunately you only have 2 SATA ports. The only option you have is to temporarily remove the SATA...
Replies: 17
Views: 493
Posted By Dixie2012

That's what I see. There are guys here that are...

That's what I see. There are guys here that are more educated on this than I, but what I'm seeing is a 4 TB HDD drive, connected to that internal port is your max. In other words, even without an...
Replies: 6
Views: 423
Posted By Hal_S

During WWII, the "Brewster Air Craft Co." of...

During WWII, the "Brewster Air Craft Co." of Willow Grove Pa. hastily manufactured the "Buffalo" fighter and "Buccaneer" dive bomber. The pilots hated them because of poor design, poor workmanship,...
Replies: 6
Views: 423
Posted By pugsl

Saw your comment about tool left under hood. When...

Saw your comment about tool left under hood. When I was a mechanic I had dropped a socket behind a battery. # years later they returned to replace battery again (40years ago) and found socket still...
Replies: 6
Views: 423
Posted By cwbuff

The tool appears to be steel with a sharp point....

The tool appears to be steel with a sharp point. Not a good choice for an O ring tool. They are usually made of a softer material such as brass to prevent scratching the O ring seating surfaces.
Showing results 1 to 7 of 7


 
Forum Jump