Search: Posts Made By: networker
Showing results 1 to 25 of 56
Search took 0.01 seconds.
Replies: 1
Views: 689
Posted By networker

1991 Bonneville Dies After Running 15 Minutes

1991 Bonneville with 3800 engine, 60,000 miles. This car starts and runs 15 minutes or so at an idle and then dies. The engine turns through well but will not start again for hours. At that point it...
Replies: 16
Views: 1,960
Posted By networker

If you are going with a China made engine Home...

If you are going with a China made engine Home depot has this 4000 watt for 329.00. I wish I could say the B&S units would be better but that is almost not the case anymore.

4000-Watt Portable...
Replies: 36
Views: 6,843
Posted By networker

Can you drip fuel into the carb and keep it...

Can you drip fuel into the carb and keep it running?

networker



Is it paranoia if they really are out to get you?
Replies: 36
Views: 6,843
Posted By networker

Just a Thought......

This is really more of a question than an answer. Does anyone remember when some Briggs point engines had reverse polarity magnets on the flywheel? I know for years after the magnatron came out you...
Replies: 8
Views: 8,525
Posted By networker

We need a model # to get specific. Check for a...

We need a model # to get specific. Check for a single wire coming from under the blower housing with a plug on the end that runs into the main harness. That plug will be very near the engine. If you...
Replies: 3
Views: 4,072
Posted By networker

Ratchet Cluch

If this engine has a ratchet clutch you need to oil it with something thin. There's a hole in the end of the clutch to oil through.

networker


Is it paranoia if they really are out to get...
Replies: 3
Views: 2,735
Posted By networker

You need to do what sidny said. Pull the plug and...

You need to do what sidny said. Pull the plug and flush the cylinder with starting fluid to dry it up. It is likely hard to roll the engine through because the cylinder has oil in it and cannot roll...
Replies: 8
Views: 9,474
Posted By networker

I talked to a couple of appliance guys and an 800...

I talked to a couple of appliance guys and an 800 tech # and 20 gallons or so of water run off a day is normal for this machine. Thanks for the help on this issue.

Networker

Is it paranoia if...
Replies: 3
Views: 4,072
Posted By networker

If this started after the hydro oil change I...

If this started after the hydro oil change I would think you need to look there. You didn't say what engine you have but I would remove the recoil unit and make sure it is OK. There could be some air...
Replies: 1
Views: 1,517
Posted By networker

This one is a pain. Almost a 2 man job. Working...

This one is a pain. Almost a 2 man job. Working through the hole where the battery sits have someone use a long pry bar to relieve all the tension on the idler arm/pulley. At this point just work...
Replies: 11
Views: 19,676
Posted By networker

Plugs

Hey cheese,

How you doing? I don't know if you remember but I used to help moderate this forum category and 3 others sometime around 2002. My user name was mike merritt.

On this plug thing...
Replies: 8
Views: 9,474
Posted By networker

Ice Maker

Thanks for the input everyone. I owned two of these units going back as far as 1985 or so but in that era running fresh water on the ground was not a concern. What this boils down to is 20+ gallons...
Replies: 8
Views: 9,474
Posted By networker

Icemaker

I let the machine run for 2 days and this is what I see....Plenty of ice, almost too much. Water output is still the alternating trickle and full flow from the drain. 3/4
of a gallon of water an...
Replies: 8
Views: 9,474
Posted By networker

Kenmore Under Counter Ice Maker

Hey Folks,

I have a Kenmore under counter ice maker model 6.89483998 that seems to have excessive water from the drain in the rear. There is plenty of ice being made. It drips water steadily...
Replies: 16
Views: 1,310
Posted By networker

I got the Belarc Advisor......pretty nice...

I got the Belarc Advisor......pretty nice program. I took the tower to work to play with it some so its not here but what I remember about the video section the adviser test shows no video card,...
Replies: 16
Views: 1,310
Posted By networker

Sarawent....you nailed the ethernet thing! Got...

Sarawent....you nailed the ethernet thing! Got the driver you suggested and jumped right online.

Now for the video issue. I have no display adapter in device manager. I looked in the case and I...
Replies: 16
Views: 1,310
Posted By networker

I had my daughter look for more CD's and she...

I had my daughter look for more CD's and she found several. One is drivers etc. so I ran it. Still no ethernet anything to be found. I suppose I will take it to some shop and get it straightened out....
Replies: 16
Views: 1,310
Posted By networker

OK, maybe there is some assumed knowledge one...

OK, maybe there is some assumed knowledge one must have to follow this stuff at the Dell site. It states to enter the tag to get a concise list of components and drivers for my computer but for the...
Replies: 16
Views: 1,310
Posted By networker

OK, the PC is a Dell 4600C and the Service Tag...

OK, the PC is a Dell 4600C and the Service Tag says 7952W31

Is this what you need?

Thanks for your time on this.

Mike
Replies: 16
Views: 1,310
Posted By networker

The monitor is the Dell that came with the...

The monitor is the Dell that came with the system. The model is E151FPb.

As I sit here now I have no idea what I need to download or where to get it. When I have that info I suppose I will need to...
Replies: 16
Views: 1,310
Posted By networker

I have an ethernet cable plugged into the router....

I have an ethernet cable plugged into the router. In device manager I have no ethernet controller. Does that mean no driver? It obviously is not on the drive or it can't be accessed. Using the...
Replies: 16
Views: 1,310
Posted By networker

New Install....No Cable Internet

I had to put a new hard drive in my 2004 Dell desktop with XP Pro. Reinstall using recovery discs went well with the exception of two things.

I am unable to adjust the screen resolution from 480...
Replies: 1
Views: 753
Posted By networker

Explorer Hood Issue

I have a 2000 Ford Explorer. The hood has been getting hard to open for some time. It was to point that one had to lean on the hood while another pulled the inside release. Now the hood will not...
Replies: 2
Views: 717
Posted By networker

I think its a spyware problem. Search Google (or...

I think its a spyware problem. Search Google (or in this case your favorite search engine) for view.atdmt.com There is some reading there on how to remove this problem. I doubt Google plays any...
Replies: 11
Views: 1,141
Posted By networker

dalel20, Under 500.00 will only get you a...

dalel20,

Under 500.00 will only get you a very basic system. My needs in a computer sound much like yours but I run an Ebay business and do light booking on mine. I went with a Toshiba A135 laptop...
Showing results 1 to 25 of 56
 


 
Forum Jump