Search: Posts Made By: R_Willis
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Replies: 4
Views: 1,519
Posted By R_Willis

Thank you very much for the reply. ...

Thank you very much for the reply.



This is where I am a little confused. Dont want it to sound like I dont know what I am doing....cause I mostly do. I guess there are a few ways to skin this...
Replies: 4
Views: 1,519
Posted By R_Willis

Arrow Notching 6x6 Posts for Glulam Beam (rim joist) Questions

I had an old thread in here, but it's too old to post replies to. I never got building, so it isn't accurate anyway as plans changed slightly.....but you can search for it if you want.

16' wide x...
Replies: 0
Views: 364
Posted By R_Willis

Can you use joist hangers side of Glulam Beam

Can you use joist hanger on the side of a 5.25x13.75x15' glulam outdoor rated beam to hold the joists for a deck opposite the ledger board? Any disadvantage in strength vs laying over top the beam?...
Replies: 4
Views: 3,881
Posted By R_Willis

Those original front there posts are not resting...

Those original front there posts are not resting on the concrete patio, it appears the patio was poured right around 3 sides of them, however. Like I state earlier, I'm sure I'm going to need an...
Replies: 4
Views: 3,881
Posted By R_Willis

Arrow Excuse my "crude" drawings. :help: Yellow -...

Excuse my "crude" drawings. :help:

Yellow - beam
Blue - engineered vaulted truss
red - posts
...
Replies: 4
Views: 3,881
Posted By R_Willis

Question Looking for input on covered porch over elevated deck build...

I'm looking to build a covered porch over my elevated deck. Will be redoing the deck at the same time in composite Timbertech decking/railing.

Here are some shots of the situation (clicking on...
01-19-07, 11:49 AM
Replies: 6
Views: 878
Posted By R_Willis

Question Looking for a PVC pipe accessory...

Not even sure it exists. Searched the internet, but didn't find much. However, if you don't know the "name" of what your looking for, finding it can be hard. :)

Looking for a flexible rubber...
Replies: 4
Views: 1,819
Posted By R_Willis

You can't download manuals unless you have a...

You can't download manuals unless you have a username/password with GE Elite. :wall:
01-29-06, 04:01 PM
Replies: 4
Views: 1,229
Posted By R_Willis

Arrow Any other suggestions or tips? Getting ready...

Any other suggestions or tips?

Getting ready to start his project here real soon.

Thanks.
01-06-06, 06:53 PM
Replies: 2
Views: 1,759
Posted By R_Willis

Arrow Crown Molding (where to nail)

Does crown molding normally get attached to the walls (2x4s on side) or the ceiling (joists) via nailing?

...or both if possible?
Replies: 2
Views: 1,335
Posted By R_Willis

Arrow Would you recommend a NX-8e for me?

I'm looking at getting a security alarm for my house.

Please forgive my "newbie" state. Never had an alarm system, but consider myself pretty "tech" friendly.

I need a WIRELESS system as my...
12-16-05, 09:44 AM
Replies: 4
Views: 1,229
Posted By R_Willis

Arrow Any other tips/tricks or hints? Looks like...

Any other tips/tricks or hints?

Looks like it would cost an arm and a leg to do the whole floor in that Noble CIS...

If I did the math right, it would be over $1500 not counting shipping or...
12-14-05, 07:35 AM
Replies: 4
Views: 1,229
Posted By R_Willis

Arrow Suggestions for a ceramic tile newbie large install...

I'm currently finishing my basement and I'm ready to tile the floor in my rec room. The room is going to need roughly ~850 tiles (12x12) and I have already picked out one I really like from one of...
Showing results 1 to 13 of 13


 
Forum Jump