Search: Posts Made By: tmanmikey
Showing results 1 to 13 of 13
Search took 0.01 seconds.
Replies: 15
Views: 12,237
Posted By tmanmikey

It is so strange! While working on the mower this...

It is so strange! While working on the mower this past weekend. The seat was up, the mower would start (seat up no one setting in it) no fuse in the 7.5 when you pulled up on the mower switch the...
Replies: 15
Views: 12,237
Posted By tmanmikey

I have followed wires and cannot find any shorts....

I have followed wires and cannot find any shorts. Would the solenoid blow the PTO fuse. Would the creative fuse jumping cause the PTO engagement switch short out? How can I test or check out the...
Replies: 15
Views: 12,237
Posted By tmanmikey

The electro magnetic switch. It is attached near...

The electro magnetic switch. It is attached near the fly wheel has three wires two white with a purple in the center. That is what I got from the schematic. It was listed in the trouble shooting...
Replies: 15
Views: 12,237
Posted By tmanmikey

I do have a electric tester and a multimeterr.

I do have a electric tester and a multimeterr.
Replies: 15
Views: 12,237
Posted By tmanmikey

O.K. New news. The battery had been installed...

O.K. New news. The battery had been installed wrong. blew the 20 amp fuse. A jumper wire was put in in place of the fuse. Then the battery cables were noticed and changed. (Thats where I came in.) I...
Replies: 15
Views: 12,237
Posted By tmanmikey

The cables are connected correct at the battery(...

The cables are connected correct at the battery( the old battery is still good). I will check the solenoid. how do I determan if it is a dead short at the solenoid? Thanks.
Replies: 15
Views: 12,237
Posted By tmanmikey

Husqvarna Rz5424 keeps blowing fuse

Put a new battery on this Husqvarna RZ5424/965881301 after it has set through the winter. It blew the 20 amp fuse. Put in a new fuse and blew that one tried again and blew again when I try to start...
Replies: 15
Views: 55,008
Posted By tmanmikey

It was the pins on the brake! Thanks guys. I took...

It was the pins on the brake! Thanks guys. I took the brake off and cleaned everything up and did a light brass brushing and put it back and goes forward and reverse. Now I have to spend my Saturday...
Replies: 15
Views: 55,008
Posted By tmanmikey

No I did not remove a wheel. I replaced the...

No I did not remove a wheel. I replaced the ignition switch. I started up the mower I moved it up ten feet I aired up the tires. ( One of the front tire was low, I have slime in it and was going to...
Replies: 15
Views: 55,008
Posted By tmanmikey

Yes it is turning. asking for 25 or more...

Yes it is turning. asking for 25 or more characters so adding this.
Replies: 15
Views: 55,008
Posted By tmanmikey

When I put the park brake on I can move the...

When I put the park brake on I can move the tranny pulley, I cannot move it when it is not on. the belt is on all the pulley not under it. I have had problem with the belt slipping before, replaced...
Replies: 15
Views: 55,008
Posted By tmanmikey

Thanks Cheese. I checked the belt it is fine. I...

Thanks Cheese. I checked the belt it is fine. I live right on the edge of the service area for my online provider and have not been able to down load the repair manual. What should I do to check the...
Replies: 15
Views: 55,008
Posted By tmanmikey

Craftsman lawn tractor will not go forward or reverse.

I have a Craftsman lawn tractor model 917.276903 automatic transmission. I bought it new in 2006. I just replaced the ignition switch on it. I started it up and moved it about 10 feet to air up the...
Showing results 1 to 13 of 13


 
Forum Jump