Search: Posts Made By: kmh747781
Showing results 1 to 15 of 15
Search took 0.01 seconds.
Replies: 2
Views: 984
Posted By kmh747781

Staircase questions

How are handrails attached to Newell posts and how are ballasters fastened to the handrail and base of stairs. I am going to refurbish a staircase and have little experience in this area of finish...
06-29-08, 05:56 PM
Replies: 13
Views: 2,519
Posted By kmh747781

Corner Shower

Make sure the type you choose will not crack over time. I am replacing a fiberglass corner shower that has cracked on the bottom after 15 years of use. My new one is a composite material that is...
06-09-08, 07:02 PM
Replies: 5
Views: 1,189
Posted By kmh747781

Plaster Repair

The damage areas in most cases are small from water intrusion (roof leaks, windows leaks etc.) the largest is an area about 1 foot wide wide and 7 feet high.
06-09-08, 04:41 AM
Replies: 5
Views: 1,189
Posted By kmh747781

Plaster Repair needed

I need to repair the plaster on some walls that are water damaged in my church. The building was built in the early 60's in Florida and has a medium sand finish. What do I use to repair this and what...
Replies: 3
Views: 2,009
Posted By kmh747781

Tar and gravel roof patch

Thanks for the info ... I cannot get access to a hot tar kettle .. none availble to rent any longer and cannot rent one from a local roofer so rubberized flashing cement appears to be my best option...
06-09-08, 04:26 AM
Replies: 6
Views: 2,101
Posted By kmh747781

Knockdown ceiling

Thanks for the PSI info and the tips ... I am assuming that that on the texture gun you turn to the largest hole for this ... is that correct?
Thanks again!
06-04-08, 04:19 AM
Replies: 6
Views: 2,101
Posted By kmh747781

Knockdown ceiling texture

How much air pressure is commonly used?
06-02-08, 05:20 PM
Replies: 6
Views: 2,101
Posted By kmh747781

Knockdown texture for ceiling

What is the best way to do this ... I have a texture spray gun and compressor

thanks
Replies: 2
Views: 1,336
Posted By kmh747781

Installation costs

What is the approx labor cost for installing a laminate floor on a concrete floor about ... 250 sq ft

thanks
Replies: 3
Views: 2,009
Posted By kmh747781

Patching Flat Tar and Gravel Roof

What is the best way to patch a tar and gravel flat roof. I have a suspected leak were the flashing on a exterior wall intersects with flat roof.

Thanks ...
05-19-08, 03:10 AM
Replies: 3
Views: 1,337
Posted By kmh747781

I am using adhesive remover currently ... it is...

I am using adhesive remover currently ... it is tough going I have about 350 sq ft to clean ... thanks for the input!
05-18-08, 11:35 AM
Replies: 3
Views: 1,337
Posted By kmh747781

Removing sheet vinyl

What is the best way to remove the bottom layer of sheet vinyl from a concrete floor. I pulled up the top part of the sheet vinyl but it seperated fromt he lower part that is "very stuck to the...
04-16-08, 06:32 PM
Replies: 4
Views: 2,108
Posted By kmh747781

Thanks will give it a try!

Thanks will give it a try!
04-12-08, 06:24 AM
Replies: 4
Views: 2,108
Posted By kmh747781

I am new at this where would be the best place to...

I am new at this where would be the best place to to look? The area is about 70 sf
04-11-08, 03:30 PM
Replies: 4
Views: 2,108
Posted By kmh747781

Question Knock Down Ceiling

I am removing part of a drop ceiling in a kitchen and I would like to put a light knock down texture on it. How do I do this?
Showing results 1 to 15 of 15


 
Forum Jump