Search: Posts Made By: juntjoo
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 6
Views: 184
Posted By Pilot Dane

I think in your situation where from your other...

I think in your situation where from your other thread you are cranking the volume loud and blowing speakers. You might want to start focusing on the speakers efficiency and not so much on ohms. ...
Replies: 3
Views: 209
Posted By Pilot Dane

It's not a cable issue. It's a setup in either...

It's not a cable issue. It's a setup in either the screen or the displaying device. If it's old enough the monitor won't really have an aspect ratio adjustment so it's likely in your computer or...
Replies: 3
Views: 209
Posted By AllanJ

Check the monitor's picture shape or picture size...

Check the monitor's picture shape or picture size or aspect ratio setting.

Note: Some monitors stretch the sides horiZontally more and stretch the middle less for one or more aspect ratio...
Replies: 15
Views: 590
Posted By AllanJ

Rule for speaker impedance versus...

Rule for speaker impedance versus amplifier/receiver impedance:

Try to have the net speaker impedance equal to the amp impediance but if you cannot get it exact, then have the net speaker...
Replies: 15
Views: 590
Posted By 2john02458

You said in an earlier post that you have 8 ohm...

You said in an earlier post that you have 8 ohm speakers. They will work fine with your receiver but as Pilot Dane noted they may overload if you push the volume too high since your receiver can...
Replies: 6
Views: 340
Posted By Pilot Dane

Blu-Ray took DVD to the next level. Technology...

Blu-Ray took DVD to the next level. Technology had reached the limits of what could be done because of the wavelength of the laser light so they switched to the blue end of the spectrum who's...
Replies: 11
Views: 524
Posted By Crashandburn

Probably easier to just buy a new one. The DVD...

Probably easier to just buy a new one. The DVD laser died on my Sony bluray surround system. I wanted to get it repaired but they don't make or stock the part any more. You could try looking for the...
06-04-19, 05:52 PM
Replies: 8
Views: 994
Posted By Geochurchi

Hi, will the fan run if the Tstat is set to fan?...

Hi, will the fan run if the Tstat is set to fan? also you can jump R to G at the Tstat to see if it runs.
Geo
06-04-19, 04:47 PM
Replies: 8
Views: 994
Posted By roughneck77

Check for a call for the fan on the low voltage...

Check for a call for the fan on the low voltage terminal block. Check for voltage to the fan motor.
Showing results 1 to 9 of 9


 
Forum Jump