Search: Posts Made By: powerz99
Showing results 1 to 9 of 9
Search took 0.01 seconds.
Replies: 17
Views: 1,611
Posted By powerz99

I got a spanner wrench and removed and inspected...

I got a spanner wrench and removed and inspected the drive block and the tabs on the spin tube. They both look fine.
Replies: 17
Views: 1,611
Posted By powerz99

Ok, I think I got it. I was not allowing the...

Ok, I think I got it. I was not allowing the machine to wait 2 minutes before it shifted to spin cycle. After running several more loads (and allowing the full 2 minutes to see if it shifts on its...
Replies: 17
Views: 1,611
Posted By powerz99

I posted on another forum stating that I replaced...

I posted on another forum stating that I replaced the timer as I was thanking someone who had referred me to another professional. I wanted to watch cycles run through completely to try to gather...
Replies: 17
Views: 1,611
Posted By powerz99

Thank you both. Any ideas on where I can find a...

Thank you both. Any ideas on where I can find a timer for this locally? My wife has been down a washer for a week and a half and if I have to wait on these parts to ship...I may not make it through...
Replies: 17
Views: 1,611
Posted By powerz99

No, it just starts and runs without spinning the...

No, it just starts and runs without spinning the tub until I open and close the lid.
Replies: 17
Views: 1,611
Posted By powerz99

It does go through the 2 minute drain before...

It does go through the 2 minute drain before attempting to begin the spin cycle. I'm not sure what you mean by "If there is no motor pause after the 2 minute drain". After the 2 minute drain...
Replies: 17
Views: 1,611
Posted By powerz99

Yes. It will run a full cycle as normal until it...

Yes. It will run a full cycle as normal until it gets to spin. When it reaches the spin mode it will make a sound as if its spinning, but the tub is not spinning. I open the lid and the tub is not...
Replies: 17
Views: 1,611
Posted By powerz99

I'm not sure what you mean by sounds like its...

I'm not sure what you mean by sounds like its running like it should. It will only start the spin cycle after I open and close the lid. If I do not open the lid then it goes through the spin cycle...
Replies: 17
Views: 1,611
Posted By powerz99

Whirlpool lsb6000pq2 spins only after open/close lid

I just replaced the gear and pinion in the transmission because the gear was stripped. Now, when I run a load the spin cycle does not engage. It makes a humming noise as if it is attempting to spin....
Showing results 1 to 9 of 9


 
Forum Jump