Search: Posts Made By: oneacer
Showing results 1 to 25 of 36
Search took 0.01 seconds.
03-01-09, 05:43 AM
Replies: 10
Views: 1,288
Posted By oneacer

Any combo of bends would be fine in my opinion....

Any combo of bends would be fine in my opinion. After all, it is only water from a bathroom sink, not a sewer line. Just grab some pvc piping and be done with it. Goes together for the home owner...
02-23-09, 06:16 AM
Replies: 3
Views: 1,439
Posted By oneacer

Where are these washers located? (i.e. basement,...

Where are these washers located? (i.e. basement, kitchen, upstairs hall, etc etc,..)

Is all the plumbing exposed/ sealed behind finished walls?

Is the second going to sit next to the first?
...
02-23-09, 06:04 AM
Replies: 3
Views: 937
Posted By oneacer

Supply tubes (usually 3/8) to a toilet shut off...

Supply tubes (usually 3/8) to a toilet shut off valve are either compression or gasket type. No pipe joint compound required.
02-23-09, 05:52 AM
Replies: 10
Views: 1,288
Posted By oneacer

I would come off the existing drain with a...

I would come off the existing drain with a 90*elbow, short length pipe, another 90* and your set. Remember that joining two dissimilar materials can be done easily with a fernco coupling.

Also...
02-23-09, 05:38 AM
Replies: 3
Views: 1,429
Posted By oneacer

I have always used the compound in a can for gas...

I have always used the compound in a can for gas applications. It usually comes with its own applicator in the cap for easy use.

Shacko is correct also; make sure you have the correct orifice...
02-21-09, 02:42 PM
Replies: 13
Views: 26,330
Posted By oneacer

Lol ................ :)

Lol ................ :)
02-21-09, 06:54 AM
Replies: 13
Views: 26,330
Posted By oneacer

Fernco coupling would be my choice.

Fernco coupling would be my choice.
02-21-09, 06:49 AM
Replies: 2
Views: 752
Posted By oneacer

What is on the reverse side of the wall that...

What is on the reverse side of the wall that holds your faucet?

Built in 1940, I would assume a complete replacement is in order. Replacing a section of sheetrock on opposite side would be easy,...
02-17-09, 03:25 PM
Replies: 6
Views: 1,870
Posted By oneacer

Just a quick update. I heard back from Aprilaire...

Just a quick update. I heard back from Aprilaire regarding this remote set-up, and this is what they wrote:
******************************************

Dear Mr. XXXXXXXX,

Thank you for...
02-16-09, 08:46 AM
Replies: 6
Views: 1,870
Posted By oneacer

Jay11J, Thanks Again. I will proceed to install...

Jay11J,
Thanks Again. I will proceed to install unit and make the connections. I will write back when it comes time for the wiring.

BTW, I am attaching the photos for everyone else to veiw, if I...
02-16-09, 06:42 AM
Replies: 6
Views: 1,870
Posted By oneacer

Hi Jay11J, Thank you for your response. ...

Hi Jay11J,

Thank you for your response.

The Humidifier being in the closet (but, on the second floor close to the main trunk lines and unit) seems out of the ordinary, but if you think about...
Replies: 1
Views: 894
Posted By oneacer

bar/chain repl. on Husky 44

Hi, I have the Husky model 44 with a 16" bar and an Oregon 34 chain.
I was thinking of replacing it with this:

http://www.jackssmallengines.com/cha...uidebar_id=386

For 35.00 for a bar and...
Replies: 3
Views: 1,069
Posted By oneacer

Best 21 cu.ft. Fridge to buy?

I am having my second Fridgidare top freezer fridge taken back as major problems with cooling, especially in freezer section. What would people here in the industry recommend as being the best that I...
12-29-06, 04:07 AM
Replies: 1
Views: 938
Posted By oneacer

New Gas Range prospects?

Hi, I am one of those unfortunates that own a Magic Chef Gas Range that goes through an electronic clock every few years. (third one in it now) I will be looking to replace it in the future, what...
Replies: 8
Views: 39,757
Posted By oneacer

Hi mswoodr, I get it locally at American...

Hi mswoodr,

I get it locally at American Olean / Carpet Products. You will have to go to a flooring specialty/wholesaler store or tile store. Just ask to see their selection of aluminum floor...
Replies: 8
Views: 39,757
Posted By oneacer

I am choosing the commercial way. Screw the...

I am choosing the commercial way. Screw the channel down between the laminate and tile and then snap the rubber strip of your color choice into the channel, covering the expansion joint. Looks and...
Replies: 4
Views: 1,856
Posted By oneacer

I will be using reg. oak flooring, ripping it on...

I will be using reg. oak flooring, ripping it on one side to butt against the oak stair top and along rail bottom and router out the underside of the other end so the laminate slides under. Should...
Replies: 9
Views: 9,084
Posted By oneacer

I"m only a novice on pumps, but any time you...

I"m only a novice on pumps, but any time you pull metal out of an oil chamber you have some serious issues. If you are assuming that the dipstick is to measure the level of oil, and you are not sure...
Replies: 1
Views: 1,551
Posted By oneacer

I would use the aluminum channel with a few slits...

I would use the aluminum channel with a few slits in it, bend it around the tile. They make any color rubber inserts that snap in. Your other floor would go against the channel(leaving room for...
05-14-06, 10:27 AM
Replies: 5
Views: 3,984
Posted By oneacer

hoffacard, I was wondering how you made out. I...

hoffacard, I was wondering how you made out. I had the same problem with my Kenmore(Whirpool) dryer and I replaced the two selonoids on the gas valve and that fixed it.
05-13-06, 03:42 AM
Replies: 4
Views: 1,565
Posted By oneacer

I also had the same problem on my Kenmore(made by...

I also had the same problem on my Kenmore(made by Whirpool) dryer, and after reading in this forum I also changed these two selonoids, and presto!, all back to normal.
04-16-06, 05:49 AM
Replies: 5
Views: 18,202
Posted By oneacer

twelvepole said what I thought. Here in CT this...

twelvepole said what I thought. Here in CT this time of year it is usually Skunk in search of grubs or the squirrels digging up thier acorns.
03-11-06, 04:15 AM
Replies: 2
Views: 7,445
Posted By oneacer

Anderson Patio Door Installation Screw up, your opinion.

It is not until now that I realized my Anderson Frenchwood Hinged Patio Doors were installed incorrectly. They were installed in a 2x6 exterior wall without putting on the exterior jamb extension...
Replies: 2
Views: 1,349
Posted By oneacer

Thanks Annette.

Thanks Annette.
02-22-06, 03:58 AM
Replies: 5
Views: 862
Posted By oneacer

Home Depot sells box extenders in different...

Home Depot sells box extenders in different colors for the different widths they come in.(1/4,3/8,etc.) I have used them before, they work great. Just be careful, as you have to un-screw the...
Showing results 1 to 25 of 36
 


 
Forum Jump