Search: Posts Made By: sharpa
Showing results 1 to 25 of 68
Search took 0.01 seconds.
Replies: 2
Views: 2,343
Posted By sharpa

210 degrees

Yes its calling for heat but this boiler always gets up to the cutout temp quickly and then hot water pumps till the temp goes down and then it fires up again. It won't get over 170
and its not...
Replies: 2
Views: 2,343
Posted By sharpa

Problem with heatmaker boiler

I have an older heatmaker Mark II boiler that has been working great all these years.
Now on firing it up, the water temp won't go over 170 degrees and the boiler won't cut out and stays...
04-12-07, 05:10 AM
Replies: 7
Views: 3,718
Posted By sharpa

Thanks for the info!

Thanks for the info!
04-12-07, 05:06 AM
Replies: 3
Views: 1,695
Posted By sharpa

closet flange

Thanks, I didn't know they made a cap for these.
04-11-07, 11:56 AM
Replies: 3
Views: 1,695
Posted By sharpa

How to cap a closet flange

I am taking an old toilet out and want to cap the old flange till I can tear into the floor and properly do it (this summer) . I won't be using this ever again. Is there a way to do this?
04-11-07, 11:50 AM
Replies: 7
Views: 3,718
Posted By sharpa

another question

Thanks for all the info. What are your thoughts on using a ceramic tile and fixture caulk by FlorCraft on the tub surround?
04-10-07, 05:37 AM
Replies: 7
Views: 3,718
Posted By sharpa

sanded or unsanded grout

I am grouting a tub surround,can I use sanded grout on spacings less than 1/8"? I used it on the floor (spectralock grout) very expensive and sets up way to fast but looks great.
Replies: 3
Views: 1,056
Posted By sharpa

Thanks Larry

I am also wondering if I should use a mortar under the tub to help leveling.Is this necessary and if so do I use the same mortar I use for ceramic tiles?
Replies: 3
Views: 1,056
Posted By sharpa

air tub installation

I am wondering when I build the framing for a drop in air tub do I tile the top before or after setting the tub in. If done before I would think it would be to much weight on the tile especially with...
01-02-07, 06:37 AM
Replies: 1
Views: 743
Posted By sharpa

marble tile question

I recently installed marble tile around a corner fireplace and am wondering if I can install just 1 tile on top of the others for a different look. Can this be done and what is the procedure?I have...
Replies: 2
Views: 1,051
Posted By sharpa

new gas boiler

I am looking to replace my old heatmaker(troublemaker) gas boiler.What are some good ones out there? Is slant-fin one of the better ones?
02-06-06, 01:39 PM
Replies: 6
Views: 2,946
Posted By sharpa

Thanks

Thanks for the help
02-03-06, 12:55 PM
Replies: 6
Views: 2,946
Posted By sharpa

denshield

Should denshield be installed under a shower module and a whirlpool or not?
Also has anyone heard of a shower by Maax, the advanta series called the
Allegro? It is acrylic and was wondering if...
05-15-05, 06:37 AM
Replies: 5
Views: 2,199
Posted By sharpa

Thanks

for the help everyone.
05-13-05, 06:42 PM
Replies: 5
Views: 2,199
Posted By sharpa

waterproof basement wall

I have an old (1918) house that never had a wet basement until we had a stretch of very wet years and now every time it rains an inch or two one wall starts leaking in. The walls are poured concrete...
Replies: 2
Views: 674
Posted By sharpa

Thanks

for the info.I will try that.
Replies: 2
Views: 674
Posted By sharpa

dual sinks

I have dual sinks in newer bathroom where 1 of them smells like the sewer when I run the water. Doesn't smell ever if no water is run. I have all the vents and plumbing done properly so what would be...
Replies: 6
Views: 3,879
Posted By sharpa

switch

Is there any way to check out the switch before I replace it?
Replies: 6
Views: 3,879
Posted By sharpa

I'm sorry, I meant to say the switch that needs...

I'm sorry, I meant to say the switch that needs resetting all the time is the safety limit switch. Can this switch go bad? This is on a trianco heatmaker mark II gas boiler otherwise known to...
Replies: 8
Views: 1,786
Posted By sharpa

side shot

Why aren't you a fan of the side shot power vent? Is there a lot of problems with them? What is the cost?
Replies: 8
Views: 1,786
Posted By sharpa

corn fired boiler question

Has anyone used a corn fired boiler. It would work great for me as I raise a lot of corn. The question I have is if I go this way I no longer have a chimney in the basement to the first floor and...
Replies: 6
Views: 3,879
Posted By sharpa

Heatmaker gas boiler trouble

Every 10 days or so the pressure switch in this boiler needs to be reset manually.Of course it always trips at night so it is freezing in the house in the morning.What is the cause for this? I have...
01-19-05, 11:14 AM
Replies: 7
Views: 3,078
Posted By sharpa

Thanks

everyone for all the help!
01-19-05, 05:46 AM
Replies: 7
Views: 3,078
Posted By sharpa

reply

Yes there is a vent fan in the downstairs bathroom that is vented to the outside wall from the suspended ceiling.It is a large one, don't remember the cfm's.This bathroom also has a shower that is...
01-18-05, 08:37 PM
Replies: 7
Views: 3,078
Posted By sharpa

moisture behind insulation

I have an unfinished room above a downstairs bathroom. There is insulation in all the 2x6 studs and vaulted ceiling (which also has baffles, a ridge vent and soffit vents).My problem is there is...
Showing results 1 to 25 of 68
 


 
Forum Jump