Search: Posts Made By: syakoban
Showing results 1 to 25 of 200
Search took 0.03 seconds.
02-02-20, 11:20 AM
Replies: 5
Views: 325
Posted By syakoban

Thanks everyone. Yeah I meant NM-b

Thanks everyone. Yeah I meant NM-b
02-01-20, 08:15 PM
Replies: 5
Views: 325
Posted By syakoban

Exclamation Flex cord or NMW?

I'm installing a radon fan in the attic. The fan is in a 3" pipe inside the attic just below the rafters. It will connect to a disconnect switch mounted about 2-1/2 feet away. The wire will hang in...
12-25-19, 07:41 AM
Replies: 4
Views: 372
Posted By syakoban

Thanks guys. The fan is in the attic...

Thanks guys.

The fan is in the attic (basement is against code). No GFI in the attic?
12-24-19, 06:02 PM
Replies: 4
Views: 372
Posted By syakoban

Exclamation 3 conductor wire when I don't need it

Hello,

I need to put a dedicated outlet in my attic for a radon fan and have to run a cable from the box in the basement. Turns out I overbought on 3-conductor wire so I'd like to use it up for...
Replies: 2
Views: 578
Posted By syakoban

Exclamation Bonding second pour to recent concrete pour

There was an emergency while pouring a 5" slab yesterday so we couldn't finish the job. We have one area finished but had to cut a clean edge and then taper down to a section that is only 2" thick.
...
Replies: 1
Views: 962
Posted By syakoban

Exclamation Proper water for concrete mix

Iím installing a 170 foot long French drain in my basement. We have to cover the trench with concrete to restore the basement slab. The basement is getting finished so itís important that the...
Replies: 2
Views: 299
Posted By syakoban

Yeah, working better now. It was a combination of...

Yeah, working better now. It was a combination of working from an edge and a sharp bit which doesn't bounce around like when it was dull.
Replies: 2
Views: 299
Posted By syakoban

Exclamation Bosch Brute jackhammer

I just purchased a really clean used Bosch Brute jackhammer. I gave it a try breaking up my basement floor (what I bought it for) and the results are disappointing. It's slow to break through.

My...
Replies: 3
Views: 356
Posted By syakoban

@XSleeper - Aside from the fact that everyone...

@XSleeper - Aside from the fact that everyone that quoted the job said the roof is good, only do the repair, I NEVER intended to be the overseeing workers, but unlike what I was told, the foreman...
Replies: 3
Views: 356
Posted By syakoban

Exclamation Roof repair concerns

Hi,

I was going to repair my roof where there's a leak in a valley myself but decided I'll get a roofer since I can't do everything myself. Despite all the research I did, it turns out that I...
Replies: 5
Views: 399
Posted By syakoban

No - not referring to tin plated copper. I'm...

No - not referring to tin plated copper. I'm referring to copper clad aluminum. Have a look at cheap Cat6 cables and you'll see it exists.

Why shielded for a self-powered subwoofer?
Replies: 5
Views: 399
Posted By syakoban

Thanks Pilot Dane. Most likely a self-powered sub...

Thanks Pilot Dane. Most likely a self-powered sub woofer.
Replies: 5
Views: 399
Posted By syakoban

Exclamation Stereo/TV sound wiring to speakers

Hi,

Wiring my den for surround sound before we hang the sheetrock. The TV will be on one long wall with a stereo below, two speakers either side of the stereo, a bass in the opposite corner, and...
Replies: 3
Views: 363
Posted By syakoban

The lever was loose but not having any effect. I...

The lever was loose but not having any effect. I believe the valve motor is jammed open. I pulled the head off and then pulled a wire and the heat immediately shut off.

I'm now able to control...
Replies: 3
Views: 363
Posted By syakoban

Exclamation Gas boiler won't turn off

We have 2 zones with two thermostats. Although it's winter, the A/C came on today so I figured the one thermostat went bad. I switched it from automatic (A/C or heat) to heat only and the heat kicked...
10-12-18, 08:01 AM
Replies: 11
Views: 1,429
Posted By syakoban

@ Allanj - some excellent points. I've been...

@ Allanj - some excellent points. I've been concerned about having room for the pipe and gravel while maintaining a full floor thickness. I've seen "pros" that put an inch or so of concrete over the...
10-12-18, 07:58 AM
Replies: 11
Views: 1,429
Posted By syakoban

@ Pilot Dane - external is just not possible. One...

@ Pilot Dane - external is just not possible. One basement wall adjoins the garage so there is no way to get to the outside of it, then aside from wiping out thousands of dollars of mature plantings,...
10-11-18, 01:03 PM
Replies: 11
Views: 1,429
Posted By syakoban

From a perspective of installation effort,...

From a perspective of installation effort, probably 3-4x times the work for an external french drain.

Typically here in NJ, it seems that retrofit french drains are interior drains.

Somewhere...
10-09-18, 08:17 AM
Replies: 11
Views: 1,429
Posted By syakoban

It's a block wall. Every block void needs to be...

It's a block wall. Every block void needs to be drilled. That's the point of the membrane I asked about - it provides a path from wall to drain field.



The waste pipe will cross the drain at...
10-08-18, 06:26 PM
Replies: 11
Views: 1,429
Posted By syakoban

Thanks Pilot Dane. "...bottom of the pipe...

Thanks Pilot Dane.

"...bottom of the pipe lower than the top of your slab in the basement." I have to have the top of the pipe lower than the slab to pour a slab back over it.

"I would not...
10-08-18, 11:58 AM
Replies: 11
Views: 1,429
Posted By syakoban

Exclamation French Drain Guidance Needed (under basement floor)

Hi,

We have minimal basement moisture issues, but before finishing off about 600 sq. feet, want to put in an under slab french drain ourselves.

I've been doing some research and have settled on...
Replies: 11
Views: 3,901
Posted By syakoban

@poorplmbr @PJmax @doughess - thank you for the...

@poorplmbr @PJmax @doughess - thank you for the great advice!

Fixed and working. I replaced the entire electrical head assembly and we're back in business.
Replies: 11
Views: 3,901
Posted By syakoban

Thanks poorplmbr. I pulled the motor off and...

Thanks poorplmbr.

I pulled the motor off and powered it with 24V and it does rotate.

Curious why not the motor alone? Is it because of a possible faulty end switch or gear issue?
Replies: 11
Views: 3,901
Posted By syakoban

@poorplmbr If you're correct about failing in the...

@poorplmbr If you're correct about failing in the open position, you don't mean the water portion of the valve, correct?

I know the motor is replaceable alone, so would that do it w/o draining...
Replies: 11
Views: 3,901
Posted By syakoban

http://ehydrant.com/v2.jpg ...

http://ehydrant.com/v2.jpg
http://ehydrant.com/v1.jpg

I see no control board. What exactly should I be testing for?
FYI - I pulled the R V&W wires on the motor to troubleshoot.
Showing results 1 to 25 of 200
 


 
Forum Jump