Search: Posts Made By: gepag
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Replies: 7
Views: 780
Posted By gepag

At 16” oc I am not worried about the joints that...

At 16” oc I am not worried about the joints that don’t fall over the rafters. I will glue those joints along with a piece of wood on the back for stiffness.
Replies: 7
Views: 780
Posted By gepag

Leveling cathedral rafters for strip flooring installation

I am going to be installing 3/4" x 3-1/4" prefinished oak flooring on a 3-season porch ceiling. The rafters are 2x10, 16" oc. I have two question on the best way to prepare these rafters for...
Replies: 12
Views: 758
Posted By gepag

“The dimmer allowed enough voltage for the meter...

“The dimmer allowed enough voltage for the meter to read but not light the light.“
I understand what you mean but do not understand the situation. With my final readings,after playing around a lot,...
Replies: 12
Views: 758
Posted By gepag

Turns out that it is the dimmer. I had 120V at...

Turns out that it is the dimmer. I had 120V at the light but when I connected that plug nothing lit. I noticed that when I turned either switch off there was still about 30V at the light. When I...
Replies: 12
Views: 758
Posted By gepag

I metered the non-dimmer switch and there is 120v...

I metered the non-dimmer switch and there is 120v there. I disconnected the dimmer (only way I could acces the wire) and there is 120v there. I then reconnected the dimmer and metered at the...
Replies: 12
Views: 758
Posted By gepag

Chandelier not lighting

Hi, I have a chandelier that is controled by two wall switches, one of which is a dimmer. One of the bulb sockets was intermittent. When trying to find the problem, I shorted the chandelier ( yeah, I...
Replies: 3
Views: 3,006
Posted By gepag

TroyBilt XP 7000 generator battery start

I have a TroyBilt XP 7000 generator that will not start with the battery start. It starts fine with the pull cord but when I push the battery start the starter just whirs and never tries to start the...
Showing results 1 to 7 of 7


 
Forum Jump